Your 2012 Jeep Patriotproblems, repair costs and recalls
What we've documented about the 2012 Jeep Patriot: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2012 Jeep Patriot
17 documented issues apply to 2012, most serious first.
CVT overheats, loses power or fails
- What you'll notice
- A transmission temperature warning, sudden loss of speed or power on the highway or hills, jerking, shuddering, or a whining or humming sound that grows over time.
- Why it happens
- The continuously variable transmission (CVT) used in most automatic Patriots can run too hot under sustained load and then limits power to protect itself. Old or low fluid makes it worse, and worn units eventually fail. Transmission overheating and failure are the top complaints for several model years.
- What to do
- If the warning light comes on, pull over and let it cool before driving on. Have the CVT fluid level and condition checked and changed with the correct fluid, and ask about software updates. A failing CVT is usually replaced rather than repaired.
Engine stalls from crankshaft sensor or throttle body faults
- What you'll notice
- The engine shuts off while driving or will not restart, sometimes with an electronic throttle warning light and reduced power, and sometimes with no warning at all.
- Why it happens
- Failing crankshaft position sensors and electronic throttle bodies are the most common causes owners report. On 2015 models, stalling while driving is the top complaint.
- What to do
- Have the codes read right after it happens. Test the crank sensor, its wiring and the throttle body before replacing parts, and check your VIN for open recalls.
Front and rear crossmembers can rust through (warranty extension X69)
- What you'll notice
- Heavy rust or holes found on the crossmembers under the vehicle at an inspection, clunks over bumps, or steering vibration.
- Why it happens
- Road salt can corrode the subframes (crossmembers) that hold the suspension until they are perforated. Chrysler extended the warranty to 10 years under X69 and published bulletin 23-007-17 for replacing them.
- What to do
- Have the crossmembers inspected, especially in salt-belt states. Ask a Jeep dealer about X69 coverage. A perforated crossmember must be fixed before more driving.
Seatbelt tensioner and side airbag timing error (recall)
- What you'll notice
- Usually no warning.
- Why it happens
- A software error could delay or stop the seatbelt tensioners and side curtain airbags from firing in a rollover.
- What to do
- Check your VIN for recall 13V-233. The software fix is free.
Airbag control module may short out (recall)
- What you'll notice
- The airbag warning light comes on and stays on.
- Why it happens
- The occupant restraint control module could short internally, so the front airbags, side airbags and seatbelt tensioners may not work in a crash.
- What to do
- Check your VIN for recall 16V-668. The dealer replaces the module free.
Fuel transfer tube may cause stalling (recall)
- What you'll notice
- The engine sputters or stalls even though the gauge shows fuel left.
- Why it happens
- A badly made transfer tube inside the saddle-shaped tank could stop fuel moving to the pump side.
- What to do
- Check your VIN for recall 13V-120. The dealer replaces the tube free.
Fuel tank rollover valve damage (recall)
- What you'll notice
- A fuel smell or wet spots under the rear of the vehicle.
- Why it happens
- The tank's rollover valve could be damaged, allowing fuel to leak in a crash or rollover.
- What to do
- Check your VIN for recall 12V-142. The dealer replaces the fuel tank free.
Sunroof and roof water leaks
- What you'll notice
- Water dripping from the dome light or headliner, damp front carpets, or a musty smell after rain or a car wash.
- Why it happens
- Sunroof drain tubes and grommets can come loose, kink or clog, and roof seams can let water in. Leaks are the most-reported Patriot problem, especially on 2008 and 2009 models, and Chrysler issued bulletin 23-005-13 for related repairs.
- What to do
- Have the sunroof drains cleared and checked and the roof seams resealed if needed. Dry wet carpet quickly to avoid mold and electrical faults.
Underhood fuse and relay box (TIPM) failure
- What you'll notice
- A no-start, a fuel pump that will not run, or random problems with the horn, wipers, lights or other accessories.
- Why it happens
- The Totally Integrated Power Module, the main fuse and relay box under the hood, can fail internally or corrode. TIPM failure is one of the top 2015 Patriot complaints.
- What to do
- Have the TIPM and its connectors tested before replacing other parts. A replacement module may need programming.
Worn control arms, sway bar links and tie rod ends
- What you'll notice
- Clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear.
- Why it happens
- The front lower control arm bushings, sway bar links and tie rod ends wear out on these vehicles, letting the front end move more than it should.
- What to do
- Have the front suspension and steering joints inspected and replace worn parts in pairs, then get an alignment.
ABS light from wheel bearing, sensor or wiring faults
- What you'll notice
- The ABS and traction control lights come on, sometimes with a humming or growling noise that changes with speed.
- Why it happens
- A worn or rusted wheel bearing, a failed wheel speed sensor, or corroded wiring under the driver's footrest can all set ABS faults. Noisy wheel bearings are common on their own too.
- What to do
- Have the ABS codes read to find which wheel is affected before replacing parts. A growling bearing should be replaced soon.
No-start or electrical faults from corroded grounds and relay box
- What you'll notice
- The engine will not start, or lights and accessories act strangely, often after wet or salty weather.
- Why it happens
- The relay box in the front left wheel well and the ground connection on the frame rail near the alternator can corrode.
- What to do
- Have a shop inspect and clean the ground connections and relay box before replacing modules.
Hard to fill the tank or stalls after fueling
- What you'll notice
- The gas pump keeps clicking off when you refuel, or the engine stalls or runs badly right after filling up.
- Why it happens
- A faulty valve inside the fuel tank or vapor system can block venting. Owners have reported fuel tank replacement as the fix.
- What to do
- Have the evaporative (EVAP) system and tank vent valves checked. Avoid topping off after the pump clicks off.
Front head restraint pops forward on its own
- What you'll notice
- The front headrest suddenly snaps forward with a loud bang while driving or parked, with no crash, and stays forward.
- Why it happens
- The active head restraints are spring-loaded to move forward in a rear crash. Owners report the release failing and firing them without an impact, which led to a class action.
- What to do
- Have the dealer reset or replace the head restraint. Do not drive with it pushed forward if it blocks your view or posture.
Alternator pulley or bearing noise
- What you'll notice
- A whine, buzz or rattle from the front of the engine, sometimes with a battery light or weak charging.
- Why it happens
- The alternator's one-way (decoupler) pulley wears out, or the bearing inside the alternator fails.
- What to do
- Have the noise traced. Often only the pulley needs replacing, which needs a special tool; a bad bearing means a new alternator.
Rust on body panels and wheel wells
- What you'll notice
- Bubbling paint or rust holes on the lower doors, wheel arches and rocker panels.
- Why it happens
- In salt-belt states the lower body panels and wheel wells rust readily.
- What to do
- Wash the underbody often in winter and have rust treated early before it spreads.
Check engine light for EVAP leak (P0456)
- What you'll notice
- The check engine light comes on with a small evaporative leak code, with no change in how the vehicle drives.
- Why it happens
- A worn gas cap or a failed EVAP leak detection unit is the usual cause.
- What to do
- Try a new quality gas cap first. If the code returns, have the EVAP system smoke-tested.
Repair prices for your 2012 Jeep Patriot
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace CVT with a remanufactured or used unit
- Clear and reseat sunroof drain tubes; reseal roof seams
- Replace crankshaft position sensor or electronic throttle body
- Replace and program the TIPM
- Replace front or rear crossmember
- Replace front lower control arms and tie rod ends, then align
- Replace alternator (worn bearing or decoupler pulley)
- Replace one wheel speed sensor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Update occupant restraint softwareNo charge if your vehicle is included
- Replace occupant restraint control moduleNo charge if your vehicle is included
- Replace fuel tank transfer tubeNo charge if your vehicle is included
- Replace fuel tankNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…