Your 2020 Jeep Renegadeproblems, repair costs and recalls
What we've documented about the 2020 Jeep Renegade: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2020 Jeep Renegade
12 documented issues apply to 2020, most serious first.
2.4L engine burns oil (warranty extension)
- What you'll notice
- The oil level drops noticeably between oil changes, the low oil pressure light comes on, or you see bluish smoke and smell burning oil. Left alone it can lead to a ticking or knocking engine.
- Why it happens
- The 2.4L Tigershark engine can let oil slip past the piston rings and burn it. FCA settled a class action over it and extended coverage to 7 years or 100,000 miles on 2015-2018 Renegades built through December 7, 2018 (bulletin 09-003-23). Under that program, a vehicle that fails an oil consumption test gets a new engine long block.
- What to do
- Check the dipstick every fill-up or two and top off with the correct oil. Ask a Jeep dealer for an oil consumption test and whether your VIN is still inside the 7-year/100,000-mile extension. Never drive with the oil pressure light on.
4x4 power transfer unit or rear drive unit failure
- What you'll notice
- A whine, growl or rumble that rises with speed, a Service 4WD warning, grinding when coasting or on light throttle, or the 4x4 system shutting itself off.
- Why it happens
- On 4x4 Renegades the power transfer unit (PTU) that sends power to the rear, its actuator, or the rear drive unit can wear out or fail internally. Some early problems were fixed with software updates, others needed new parts.
- What to do
- Have a shop pinpoint whether the noise is from the PTU, rear unit or a wheel bearing. Changing the PTU fluid about every 30,000 miles helps prevent damage.
Rear brake caliper may be cracked (recall)
- What you'll notice
- A clunk or grinding from the rear, a brake fluid leak, or a softer brake pedal.
- Why it happens
- A right rear brake caliper could have been fractured when it was cast.
- What to do
- Check your VIN for recall 19V-909. The dealer inspects and replaces the caliper free.
Seat belt buckle sensor may stop the front airbag (recall)
- What you'll notice
- An airbag or seatbelt warning light may come on, or there may be no warning.
- Why it happens
- The connector for the seat belt buckle switch could be loose, which can keep the front seat airbag from deploying correctly.
- What to do
- Check your VIN for recall 24V-510. The dealer repairs the connection free.
Rough, jerky or delayed shifting from the 9-speed automatic
- What you'll notice
- Harsh 1-2 and 2-3 shifts, a lurch or bang when slowing down, a hesitation pulling away from a stop, slow engagement out of Park, or the transmission seeming to stick in one gear.
- Why it happens
- The ZF-designed 9-speed automatic relies heavily on software, and early calibrations shifted poorly. Jeep released many transmission computer updates, and a few vehicles needed a valve body or other internal repair.
- What to do
- Ask a dealer to check for and install all transmission software updates and do a shift relearn. If shifting stays harsh or it gets stuck in a gear, have the fluid and codes checked before it causes more wear.
Uconnect screen, Bluetooth and electrical glitches
- What you'll notice
- The radio screen freezes, goes black or reboots, Bluetooth drops, random warning lights appear, door locks act up, or dash lights flicker.
- Why it happens
- Software bugs in the Uconnect radio and body control module cause many of these. Some vehicles needed a new radio unit or body control module.
- What to do
- Try a radio reset by holding the power button. Ask the dealer for radio and module software updates, which are often free under bulletins.
Key not detected or push-button no-start
- What you'll notice
- A Key Not Detected message, the push-button start needing several tries, or the engine not starting at all even with the key fob inside.
- Why it happens
- The keyless entry and start system can lose track of the fob because of a weak fob battery, a software fault in the hub module, or a failing start button. Jeep issued service guidance on intermittent no-starts with multiple start attempts.
- What to do
- Replace the key fob battery first. If it continues, have the dealer check for module software updates and test the start button.
My Sky roof panel leaks, rattles or sticks
- What you'll notice
- Water in the footwells or on the headliner after rain, a musty smell, rattling or creaking from the roof panels, or a power panel that sticks open.
- Why it happens
- The removable My Sky roof panels rely on drain tubes and rubber seals that clog or wear. Loose brackets and clips cause rattles, and Jeep issued bulletins for panels that stick or run roughly.
- What to do
- Clear the roof drain tubes and inspect the seals. Dry wet carpet quickly to prevent mold and wiring problems, and ask the dealer about the My Sky bulletins.
Backup camera image stays on after reverse (recall)
- What you'll notice
- The rear camera picture stays on the screen after you shift out of reverse.
- Why it happens
- A radio software error kept the image displayed longer than federal rules allow.
- What to do
- Check your VIN for recall 20V-191. The radio update is free at a dealer or over the air.
Cranks but won't start in freezing weather (muffler TSB)
- What you'll notice
- On a very cold morning the engine turns over but will not start, then starts normally once it warms up.
- Why it happens
- Some mufflers were built without a small drain hole. Water from normal exhaust condensation collects inside and freezes, blocking the exhaust. Bulletin 09-004-20 has a technician drill a 1/8-inch weep hole.
- What to do
- Ask a dealer or shop to check the muffler for a weep hole. It is a very quick fix.
Stop/Start not ready message and battery sensor faults
- What you'll notice
- A Stop/Start Not Ready or battery charging message, the auto stop/start feature quitting (often in winter), slow cranking, or a battery that keeps going flat.
- Why it happens
- The stop/start system watches the battery through an intelligent battery sensor on the negative cable. A weak battery or failed sensor makes the system shut stop/start off, and Jeep issued service guidance for these faults.
- What to do
- Have the main battery load-tested first. If it is good, the battery sensor is the usual culprit. Use the correct AGM battery when replacing it.
A/C blows warm from a refrigerant leak
- What you'll notice
- The air conditioning slowly stops cooling or blows warm air.
- Why it happens
- Owners report leaks at the condenser and refrigerant lines. Jeep also issued a bulletin for leaking A/C suction lines with a faulty crimp.
- What to do
- Have the system leak-tested with dye before recharging, so you are not paying for refrigerant that leaks back out.
Repair prices for your 2020 Jeep Renegade
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Oil consumption test; replace engine long block if it fails
- Reprogram the transmission control module with the latest software
- Drill a drain hole in the muffler (bulletin 09-004-20)
- Replace leaking A/C suction hose or condenser, then evacuate and recharge
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Update radio softwareNo charge if your vehicle is included
- Inspect and replace right rear brake caliperNo charge if your vehicle is included
- Repair seat belt buckle switch connectionNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…