Your 2009 Kia Borregoproblems, repair costs and recalls
What we've documented about the 2009 Kia Borrego: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2009 Kia Borrego
18 documented issues apply to 2009, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- The transmission slips, flares in revs between gears, jerks hard when you shift from Reverse to Drive, or suddenly locks up and stops pulling. Owners report failures from very low mileage up to well past 100,000 miles.
- Why it happens
- Transmission failure is the most-reported problem on the Borrego. Some trucks had their transmission replaced or rebuilt and still slipped afterwards, which points to internal wear and control problems rather than one simple part.
- What to do
- Check the fluid level and condition first. If it slips or will not move, stop driving it hard and get a transmission diagnosis. Ask a Kia dealer whether any software update or bulletin repair has not yet been done on your VIN.
Stuck in third gear with a warning light on
- What you'll notice
- A warning light comes on and the transmission holds third gear, will not upshift or downshift normally, or the shifter sticks in Park. Some owners say it shifts abruptly from third to fourth.
- Why it happens
- Kia issued technical service bulletin 035 (revised in 2011) for 2009 Borregos with this exact pattern and stored internal transmission trouble codes. In this state the transmission computer is protecting itself in a fixed gear.
- What to do
- Have the transmission codes read and ask a Kia dealer to check TSB 035 REV 1 against your VIN. Avoid highway merging and towing while it is stuck in one gear.
Brake pedal mount can break in a crash (recall)
- What you'll notice
- No warning beforehand. After a collision, the brake pedal may not work, leaving only the parking brake to stop the vehicle.
- Why it happens
- On Borregos built from May 2008 to January 2009 with non-adjustable pedals, the brake pedal mount was made of a fiberglass composite that can break off in some crashes. Kia recalled about 21,900 trucks (NHTSA 12V245, Kia SC096).
- What to do
- Check your VIN for open recalls. Kia dealers replace the brake pedal mount free of charge.
Brake light switch can fail (recall)
- What you'll notice
- Brake lights that stay off when you brake (or flicker), cruise control that will not switch off, warning lights, and a shifter that will not leave Park, or that can be moved out of Park without pressing the brake.
- Why it happens
- The brake (stop lamp) switch could work only on and off. Kia recalled this switch on the Borrego and other models in 2013 (NHTSA 13V114). The same switch tells the cruise control and the shift lock when you are braking.
- What to do
- Check your VIN for this recall and have the switch replaced free at a Kia dealer. Until then, ask someone to watch your brake lights when you press the pedal.
Seat belt won't latch or comes unlatched
- What you'll notice
- A seat belt does not click in, or it releases from the buckle on its own while driving, sometimes several times.
- Why it happens
- Owners report seat belt buckles that do not latch properly. A worn or dirty buckle mechanism is the usual cause.
- What to do
- Do not ignore it: an unlatched belt gives no protection. Have the buckle inspected and replaced, and check that the belt holds when you pull on it firmly.
Delayed or rough shifts on early V6 models
- What you'll notice
- A slow, delayed shift when pulling out of Park, hesitation going into gear, slow downshifts on hills, or clunky shifts.
- Why it happens
- Borregos with the 3.8L V6 built through January 15, 2009 had transmission computer programming that caused shift delay and poor shift quality. Kia released a transmission computer software update for them under a service campaign (SA 016, bulletin TSB-027).
- What to do
- Ask a Kia dealer to confirm the TCM software update has been done. It is a quick reflash, and it should be checked before any bigger transmission work.
Headliner plates can come loose when airbags deploy (recall)
- What you'll notice
- Nothing you would notice day to day. In a crash that fires the side curtain airbags, plastic plates in the headliner can come loose and fly into the cabin.
- Why it happens
- Too little adhesive was used at the factory to hold the left and right headliner plates in place. Kia recalled about 22,700 2009 Borregos in 2023 (NHTSA 23V692).
- What to do
- Check your VIN for this recall. A Kia dealer will add industrial-grade adhesive tape over the plates for free, and owners who already paid for the fix can ask for a refund.
Shifter won't move into or out of Park
- What you'll notice
- The shift lever will not leave Park, will not go back into Park, or will not go into Reverse. The key may not come out because the truck is not in Park.
- Why it happens
- The shift lock depends on the brake light switch and the transmission controls. Owners report these lockouts alongside warning lights, and Kia's brake light switch recall and TSB 035 both describe a shifter stuck in Park.
- What to do
- Use the shift lock release slot near the shifter to move it in an emergency. Then have the brake light switch recall and transmission codes checked by a dealer.
Check engine light with throttle code P2135
- What you'll notice
- The check engine light comes on, often with trouble code P2135, and the engine may go into a reduced-power mode.
- Why it happens
- Code P2135 means the two throttle position signals do not agree. Kia found that engine computer programming could set this code on Borregos and released an engine computer software update (TSB-043).
- What to do
- Have the code read. If it is P2135, ask a Kia dealer about the TSB-043 software update before replacing the throttle body.
Rough idle or misfire from a sticking oil control valve
- What you'll notice
- Rough idle, sluggish acceleration, a check engine light with camshaft timing or misfire codes.
- Why it happens
- The engine uses oil-pressure-controlled valves (oil control valves) to shift the camshaft timing. Kia's TSB-046 tells technicians to suspect a sticking oil control valve for these symptoms. Old or low oil makes them stick more.
- What to do
- Check the oil level and have the oil changed if it is due. Have the codes read; replacing an oil control valve is a modest repair compared with chasing other parts.
Steering heavy or hard to turn at speed
- What you'll notice
- The steering feels unusually heavy or almost locks for a moment, often at higher speeds or after a bump, then returns to normal.
- Why it happens
- Owners have reported this to NHTSA, but dealers often found no fault. Suspected causes include the power steering pump and worn steering parts such as tie rod ends.
- What to do
- Check the power steering fluid level and look for leaks. If the steering ever binds, have the pump, hoses and steering linkage inspected before driving at speed.
ESC and downhill brake lights come on
- What you'll notice
- The stability control (ESC/ESP) and downhill brake control lights come on and off, sometimes with brake warning lights while driving.
- Why it happens
- Owners have filed several stability control complaints with NHTSA. These systems rely on the brake light switch and wheel speed and ABS signals, so a faulty brake light switch (see the recall) is one known trigger. A shop will also check the sensors and the ABS unit.
- What to do
- Have the ABS and stability control codes read, and check whether the brake light switch recall has been done on your VIN.
Driver seat suddenly drops or comes loose
- What you'll notice
- The power driver seat drops to its lowest position, jerks, or comes loose, and the seat buttons stop working.
- Why it happens
- Owners report the seat height adjuster arm unhooking or a seat mounting stud breaking.
- What to do
- Do not drive with a loose seat. Have the seat track and adjuster inspected and repaired right away.
Check engine light from engine computer software (V6)
- What you'll notice
- The check engine light comes on with codes such as P0110, P0111, P0116 or P1618B, often with no change in how the engine runs.
- Why it happens
- Kia found that the engine computer software on some 2009 Borregos with the 3.8L V6 could set these codes and issued a software upgrade in bulletin TSB-074.
- What to do
- Have the codes read and ask a Kia dealer whether the TSB-074 software update has been done before replacing sensors.
Booming noise around 2,000 rpm
- What you'll notice
- A low booming or droning sound inside the cabin when the engine is around 2,000 rpm.
- Why it happens
- Kia traced this noise on 2009 Borregos to the thermostat housing and released a revised housing to stop it.
- What to do
- It is not harmful, but if it bothers you, ask a Kia dealer about the revised thermostat housing.
Power tailgate works on and off or not at all
- What you'll notice
- The power rear tailgate (liftgate) opens or closes only sometimes, or stops working.
- Why it happens
- The tailgate actuator has a gear that wears or slips. Kia redesigned the actuator gear and its outer cover and issued bulletin TSB-041 for it.
- What to do
- Have the actuator checked. Ask for the redesigned part so it does not fail again.
Steering column won't tilt or telescope
- What you'll notice
- The steering wheel will not move up, down, in or out, or it stays stuck in one position. One owner noticed it starting in hot weather.
- Why it happens
- Owners report the adjustable steering column jamming. The exact cause was not identified in the reports.
- What to do
- Have a shop inspect the column lock mechanism. Make sure the wheel is locked firmly in place before driving.
Emissions monitors won't finish after a battery change
- What you'll notice
- The truck fails a plug-in emissions test because the EGR readiness monitor shows "not ready", often after a new battery or a computer reset.
- Why it happens
- Kia issued a service notice that some Borregos cannot complete the EGR readiness check after a battery replacement or engine computer memory reset.
- What to do
- Ask a Kia dealer about service notice PS418 before the inspection. A shop can run the right drive cycle to set the monitors.
Repair prices for your 2009 Kia Borrego
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with remanufactured or used unit
- Transmission diagnosis and TSB 035 bulletin repair
- Transmission computer (TCM) software update
- Diagnose shift lock; replace brake light switch if needed
- Engine computer software update (TSB-043)
- Engine computer software update (TSB-074)
- Replace camshaft oil control valve
- Replace thermostat housing with revised part and refill coolant
- Replace power tailgate actuator
- Replace seat belt buckle
- Stability control diagnosis; replace brake light switch or sensor as needed
- OBD-II drive cycle to set readiness monitors
- Repair seat height adjuster or seat mounting bolt
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace brake pedal mount under recallNo charge if your vehicle is included
- Replace brake light switch under recallNo charge if your vehicle is included
- Tape headliner plates under recallNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…