Your 2020 Kia Optimaproblems, repair costs and recalls
What we've documented about the 2020 Kia Optima: problems owners and shops report, typical repair and upkeep costs, and safety recalls. Sold as K5 from 2021.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2020 Kia Optima
3 documented issues apply to 2020, most serious first.
Both low beam headlights can stop working
- What you'll notice
- One low beam goes out, then the other follows, often not long after a new bulb was fitted, leaving almost no light on the road ahead at night.
- Why it happens
- Owners report the bulbs and headlight units failing again and again rather than simply reaching the end of their life, which points at the lamp assemblies and their wiring. The pattern across Kia models has drawn a lawsuit investigation.
- What to do
- Fit new bulbs, and if they fail again have the headlight assemblies, sockets and wiring checked instead of just buying more bulbs. Do not drive after dark with no low beams.
Engine can use up its oil between changes
- What you'll notice
- The dipstick reads low or empty well before the next service, the oil light may blink in corners or at idle, and the engine can start to tick or knock.
- Why it happens
- The direct-injection Theta II four burns oil past its piston rings. Federal investigators have tied the same engine family to connecting rod bearings worn by oil starvation, which is how a quiet oil-burner turns into a seized engine.
- What to do
- Check the oil at every fuel stop and top it up, keep the receipts, and ask a Kia dealer whether your VIN qualifies for extended engine coverage or the knock sensor software update. Stop driving and have it towed if it knocks.
Flashing check engine light, code P1326 and limp mode (2020)
- What you'll notice
- The check engine light starts flashing at highway speed, the car drops into a reduced-power mode and will not rev much past 2,000 rpm, and a code reader shows P1326. Many owners also notice a ticking or knocking sound and oil disappearing between changes.
- Why it happens
- P1326 is set by Kia’s knock sensor detection software, which watches for the vibration of a connecting rod bearing starting to wear and then cuts power to protect the engine. Owners of 2020 cars report the same pattern seen on the recalled 2011-2019 engines, sometimes ending in an engine replacement.
- What to do
- Slow down, get off the highway and avoid hard acceleration. Check the oil level right away, and have a Kia dealer inspect the engine rather than just clearing the code or swapping the knock sensor. If it knocks loudly or the oil light comes on, stop and have it towed. Keep your oil-change receipts and ask Kia in writing about warranty or goodwill coverage.
Repair prices for your 2020 Kia Optima
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace low beam bulbs and inspect headlight wiring
- Oil consumption test, then piston ring or short block repair
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…