Your 2000 Lexus RXproblems, repair costs and recalls
What we've documented about the 2000 Lexus RX: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Lexus RX
7 documented issues apply to 2000, most serious first.
Automatic transmission failure on the RX300
- What you'll notice
- Slipping, flaring revs between gears, late or harsh engagement into drive or reverse, or a flashing O/D light.
- Why it happens
- The first-generation automatic is known for wearing out internally, with owners reporting full failures. Old, broken-down fluid and towing add heat and speed up the wear.
- What to do
- Have the fluid level and condition checked and the transmission scanned at the first sign of slipping. Avoid towing and heavy loads until it is looked at, since a slipping unit tends to get worse fast.
Engine oil sludge (oil gelling)
- What you'll notice
- Oil pressure light flickering, rising oil use, blue smoke, or ticking from the top of the engine.
- Why it happens
- Oil in this engine could thicken into sludge and block oil passages, especially with long gaps between oil changes. Toyota and Lexus set up a special policy for sludge damage, and the RX300 was part of a later class settlement.
- What to do
- Change the oil on a short schedule with quality oil. If the oil pressure light comes on, stop driving and have the engine inspected before running it again.
Air conditioning compressor shaft seal can leak
- What you'll notice
- The air gets warm over a season or two, and there may be oily residue around the compressor.
- Why it happens
- The seal on the compressor shaft can weep refrigerant and oil.
- What to do
- Have the system leak-tested before just recharging it, since running a low system can wreck the compressor.
Key is hard to turn in the ignition
- What you'll notice
- The key sticks or needs wiggling and extra force to turn, sometimes worse when it is cold.
- Why it happens
- The ignition lock cylinder wears and binds, and Lexus published a bulletin on improving how it works.
- What to do
- Have the cylinder serviced or replaced before the key stops turning at all and leaves you stranded.
Ticking from the fuel injectors on the RX 300
- What you'll notice
- A light, steady tick from the top of the engine that you hear best at idle with the hood up.
- Why it happens
- The injectors themselves make the noise, and Lexus published a bulletin on how to tell it from a real fault.
- What to do
- Have a shop confirm it is only injector noise; if nothing else is wrong you can simply keep driving it.
Front brakes groan or squeal
- What you'll notice
- A groan at low speed as you come to a stop, or a squeal from the front when braking gently.
- Why it happens
- The front pad and rotor combination on these years is prone to noise, and Lexus issued bulletins with updated parts and procedures.
- What to do
- Have the front brakes measured at the next service; if the pads are fine, the fix is the updated hardware and lubricant, not new brakes.
Rattle from the glove box area
- What you'll notice
- A plastic rattle or buzz from the passenger side of the dash over bumps.
- Why it happens
- The glove box door and its stops can work loose, which Lexus addressed in a bulletin.
- What to do
- Mention it at your next service; it is annoying but harmless, and a shop can shim or adjust the door.
Repair prices for your 2000 Lexus RX
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace transmission with a remanufactured unit
- Remove valve covers and oil pan to clean out sludge
- Replace front pads and rotors with updated hardware
- Replace A/C compressor and recharge system
- Replace ignition lock cylinder
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…