Your 2017 Mazda CX-3problems, repair costs and recalls
What we've documented about the 2017 Mazda CX-3: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2017 Mazda CX-3
10 documented issues apply to 2017, most serious first.
Mazda Connect screen freezes, reboots or ghost touches
- What you'll notice
- The center screen picks items on its own, freezes, goes blank, keeps restarting, drops Bluetooth or navigation, or the backup camera picture does not show.
- Why it happens
- The Mazda Connect head unit can suffer from software faults and a touchscreen that develops phantom touches as it ages. Owners filed a class action over CX-3 and other 2014-2023 Mazdas, and Mazda issued updated software and screen repair kits to dealers.
- What to do
- Ask a Mazda dealer to install the latest Mazda Connect software, which fixes many freeze and reboot problems. If the screen still ghost touches, the screen unit usually needs replacing; ask about extended coverage first.
Backup camera picture flickers or distorts (recall)
- What you'll notice
- When you shift into reverse, the rearview camera image flickers, looks distorted, or doesn't show properly.
- Why it happens
- Moisture and a loose wiring harness at the rear camera can disturb the video signal. Mazda recalled 2016-2021 CX-3s, along with some 2014-2018 Mazda3s, to inspect the camera, replace it if needed, and add a sealed harness fastener.
- What to do
- Check your VIN for an open recall and have the free camera repair done. Until then, use your mirrors and look over your shoulder when backing up.
Free under recall. Check your VIN or ask a Mazda dealer.
Steering feels light or makes noise when turning
- What you'll notice
- The steering feels unusually light or a bit notchy, or you hear a clicking or grinding noise from the steering column when turning the wheel left or right.
- Why it happens
- Mazda found that the worm gear inside the electric power steering assist unit could be made slightly out of tolerance or absorb moisture at the factory and swell. That changes how the gears mesh.
- What to do
- Have a Mazda dealer check the steering under Mazda's bulletin for this problem. The repair is to the steering shaft or assist unit and is often covered if the car is still under warranty.
Oil leak and rattle from the drive belt tensioner
- What you'll notice
- Oily residue around the front of the engine near the belt, sometimes with a rattling or chattering noise from under the hood.
- Why it happens
- The damper inside the automatic belt tensioner may not seal well when it works hard in hot weather and under heavy load, so it leaks oil and stops controlling the belt properly. Mazda redesigned the damper.
- What to do
- Have the tensioner inspected. If it is leaking or rattling, replace it along with the belt before the belt slips or comes off.
Broken front coil spring causes creaking over bumps
- What you'll notice
- A creaking or groaning from a front corner when going over bumps or into driveways. Sometimes a mechanic spots a broken spring during routine service.
- Why it happens
- Mud and sand can get trapped between the bottom of the front coil spring and its seat, wearing off the paint. The spring then rusts through and breaks near its lower end. Mazda changed the shape of the lower spring seat.
- What to do
- Have the front springs inspected. A broken spring should be replaced promptly, ideally in pairs, because it can affect handling and damage the tire.
Whining noise from the automatic transmission
- What you'll notice
- A whine from the transmission that starts around 10 mph and gets louder as you go faster. It stays the same whether you accelerate, coast or cruise.
- Why it happens
- A bearing inside the transmission can be damaged because of how the transmission case was shaped on earlier units. Mazda changed the design on later transmissions.
- What to do
- Have a dealer confirm where the noise comes from; a worn wheel bearing can sound similar. If it is the transmission, get it repaired while it is still under powertrain warranty if possible.
No-start, battery drain or odd electrical faults linked to accessories
- What you'll notice
- The car sometimes won't start, the key isn't detected, the security light flashes, or the battery is dead after sitting.
- Why it happens
- Mazda found that aftermarket devices such as dash cams, remote starters and plug-in insurance trackers can drain the battery or confuse the keyless and security systems.
- What to do
- Unplug any add-on devices and see if the problem stops. Have the battery tested, and ask a shop to do a parasitic-drain test if the battery keeps going flat.
Wheel bearing growl or hum
- What you'll notice
- A growl, hum or whine that rises with speed and may change when you steer gently left or right. It can be mistaken for a transmission noise.
- Why it happens
- A worn front or rear wheel bearing makes noise as it rotates. Mazda reminded technicians to check wheel bearings before blaming the transmission.
- What to do
- Have a mechanic road-test and lift the car to find which wheel is noisy. Replace the bearing before it gets loose, since a badly worn one can affect braking and handling.
Rough idle and check engine light after a freezing night
- What you'll notice
- On a cold morning after the car sat outside overnight below freezing, the engine idles roughly or shakes and the check engine light may come on with misfire codes.
- Why it happens
- Water that collects in the main muffler can freeze overnight and partly block the exhaust, so the engine struggles until the ice melts.
- What to do
- If it clears up once the car warms, it is likely this. If the light stays on or the engine keeps misfiring, have the codes read so a real ignition problem isn't missed.
Leather steering wheel wears or peels
- What you'll notice
- The leather on the steering wheel looks shiny, wears through or starts peeling where your hands rest.
- Why it happens
- Mazda found the leather used on some steering wheels did not resist wear well enough.
- What to do
- Ask a Mazda dealer whether the wheel can be replaced under warranty or goodwill. A steering wheel cover is a cheap stopgap.
Repair prices for your 2017 Mazda CX-3
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Update Mazda Connect software or replace touchscreen
- Repair or replace steering column assist unit
- Replace drive belt tensioner and belt
- Replace front coil spring (pair)
- Repair or replace automatic transmission
- Diagnose misfire; no repair usually needed
- Parasitic drain test and remove accessory
- Replace wheel bearing/hub
- Replace steering wheel
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect or replace rear camera and add harness sealNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…