Mazda CX-5problems, repair costs and recalls
Problems reported across 2013–2026. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
28 documented issues across all years, most serious first.
Front strut bolts can loosen (recall)
- What you'll notice
- Clunking from the front suspension over bumps or a change in handling.
- Why it happens
- The bolts holding the front struts to the steering knuckles may not have been tightened properly.
- What to do
- Check your VIN for open recalls and get the inspection done soon. Have any new clunk from the front checked before driving further.
Side curtain airbags may not deploy properly (recall)
- What you'll notice
- Usually no warning signs.
- Why it happens
- The side curtain airbags may not unfold correctly in a crash, reducing protection.
- What to do
- Check your VIN for open recalls and have the airbags replaced promptly.
Misfire or stalling from cylinder deactivation fault (recall)
- What you'll notice
- Check engine light, misfire, loss of power, or the engine stalling and not restarting.
- Why it happens
- Engine computer software could mishandle the valve adjusters when switching back from cylinder deactivation, letting an intake rocker arm move out of place and hit other engine parts.
- What to do
- Check your VIN for open recalls and have the engine computer updated. If the engine misfires or loses power, stop driving and have it towed.
Fuel pump may fail (recall)
- What you'll notice
- Rough running, hesitation, the engine stalling while driving, or not starting.
- Why it happens
- The impeller inside the low-pressure fuel pump can crack and stop the pump.
- What to do
- Check your VIN for open recalls and get the fuel pump replaced. A stall at speed is a crash risk.
Cylinder head can crack and leak coolant on the turbo engine
- What you'll notice
- Coolant level drops, you smell something sweet after a drive, there may be crusty residue near the exhaust side of the engine and the low coolant warning may come on.
- Why it happens
- The cylinder head can crack around the exhaust manifold area, usually at a stud hole, and coolant seeps out there.
- What to do
- Stop driving it if the coolant keeps dropping or the temperature climbs, and have the head inspected; Mazda's fix is a new cylinder head.
Cylinder head can crack on the 2.5L engine
- What you'll notice
- Oil or coolant seeping down the side of the engine, a low level between services, and sometimes a burning smell after driving.
- Why it happens
- Cracks can form in the cylinder head casting, so oil or coolant escapes past it; Mazda released an updated head assembly.
- What to do
- Have the leak traced before the level gets low, because running the engine short of oil or coolant will damage it.
Rear brakes grinding from stuck outer pads
- What you'll notice
- Squeaking or grinding from the rear, with the outer rear pads worn down while the inner pads look nearly new.
- Why it happens
- Road salt rusts the outer rear pads so they bind and keep the brakes lightly applied. Mazda released modified pads and clips through a service bulletin.
- What to do
- Have the rear brakes inspected and ask a Mazda dealer about the bulletin repair. Do not ignore grinding, which can damage the rotors.
Liftgate may fall closed (recall)
- What you'll notice
- The liftgate won't stay up or drifts down on its own.
- Why it happens
- The liftgate support struts can corrode internally and lose their strength.
- What to do
- Check your VIN for open recalls and have both struts replaced. Don't stand under a liftgate that won't stay open.
Overheating or no heat with code P011A
- What you'll notice
- Check engine light, the engine running hot, or the heater blowing cold air.
- Why it happens
- Mazda issued a service alert for a temperature-reading fault on these years that can show up as overheating or poor heat.
- What to do
- Have the code read and the cooling system checked. Stop driving if the temperature gauge climbs high.
Fuel filler pipe can rupture in a crash (recall)
- What you'll notice
- No warning signs in normal driving.
- Why it happens
- In a rear collision the fuel filler pipe could be damaged and leak fuel, raising the risk of fire.
- What to do
- Check your VIN for open recalls and have the free repair done.
Check engine light with the thermostat stuck open
- What you'll notice
- Check engine light, heat that takes a long time to come up in cold weather, and a temperature gauge that sits low.
- Why it happens
- The thermostat can stick open so the engine never reaches its normal running temperature, and the computer stores a code for it.
- What to do
- Have the thermostat replaced; a cold-running engine uses more fuel and wears faster, but it is not an emergency.
Creak or clunk from the steering column
- What you'll notice
- A creak, click or clunk from behind the steering wheel when you turn it, worst at low speed or when parking.
- Why it happens
- A nut inside the steering column can loosen, so parts rub and knock as the column takes load.
- What to do
- Have the column checked; it is usually a tightening or replacement job and should not be left to get worse.
Power liftgate can open on its own
- What you'll notice
- The tailgate opens when nobody pressed anything, sometimes while the car is parked.
- Why it happens
- A fault in the power liftgate control can trigger the open cycle without a command.
- What to do
- Have it looked at and switch the power liftgate off in the menu until then, so your luggage is not left exposed.
Rear differential case can crack on all-wheel drive cars
- What you'll notice
- An oily patch under the back of the car, a whine or hum from the rear at speed, or a warning about the all-wheel drive system.
- Why it happens
- The rear differential case can crack and let its oil out, which then starves the gears.
- What to do
- Have it inspected soon; running a differential dry ruins it and can lock up the rear wheels.
Trailer wiring can melt against the muffler (recall)
- What you'll notice
- Trailer lights stop working, or you see melted wiring near the rear of the car.
- Why it happens
- The trailer hitch wiring harness can rest against the muffler, and the heat damages the wiring.
- What to do
- Have the harness rerouted under the campaign before you tow again, since damaged wiring near heat is a fire risk.
Driver mirror glass shakes at highway speed
- What you'll notice
- The driver-side mirror glass vibrates at higher speeds, blurring the view behind.
- Why it happens
- The power mirror glass mount allows vibration. Mazda issued several service bulletins with a repair.
- What to do
- Ask a Mazda dealer about the mirror vibration bulletin.
Windshield cracking without impact
- What you'll notice
- A crack appears in the windshield with no clear rock strike.
- Why it happens
- Early CX-5 windshields were the subject of a lawsuit, and Mazda set up a customer service program for certain vehicles built in early 2013.
- What to do
- Replace the glass if the crack is in your view or spreading, and ask a Mazda dealer whether your VIN was in the program.
Rust and paint blisters on the liftgate
- What you'll notice
- Bubbling paint or rust spots on the lower liftgate panel or around the liftgate stopper.
- Why it happens
- Paint was applied too thin in these areas. Mazda issued service bulletins for the repair.
- What to do
- Have a Mazda dealer inspect it and ask about the bulletin before the rust spreads.
LED daytime running lights failing (recall)
- What you'll notice
- One or both LED running lights go out or flicker.
- Why it happens
- Moisture can get into the headlight assembly and damage the LED running light circuit.
- What to do
- Check your VIN for open recalls; Mazda will inspect and replace the gasket or headlight as needed.
Mazda Connect screen ghost touches, freezing and reboots
- What you'll notice
- The infotainment screen registers touches by itself, freezes, keeps rebooting, drops Bluetooth calls, or the backup camera image fails to appear.
- Why it happens
- Hardware and software faults in the Mazda Connect system led to a class action settlement that added extended coverage.
- What to do
- Ask a Mazda dealer for the latest software and whether your screen qualifies for repair under the settlement coverage.
Click from the front brakes at low speed
- What you'll notice
- A single click or light clunk from a front wheel as you pull away or stop, often only on the first stops of the day.
- Why it happens
- The front pads can move slightly in their brackets, which makes a click when the brakes first take hold.
- What to do
- Mention it at the next service; Mazda has a fix for the noise and it does not affect braking.
Chirp from the transmission on the third to fourth shift
- What you'll notice
- A short chirp or squeak as the transmission shifts from third to fourth under light throttle.
- Why it happens
- The way one clutch pack engages on that shift can make the noise; it does not mean the transmission is slipping.
- What to do
- Have it confirmed at a service visit and keep an eye on the fluid; no repair is needed if it only chirps.
Tapping or rattle from the valve train
- What you'll notice
- A light tapping or rattle from the top of the engine, often loudest on a cold start and on newer cars.
- Why it happens
- Clearances in the valve train can make the noise before parts fully bed in.
- What to do
- Have it recorded at a service visit so it can be compared later; a tap that grows or comes with a warning light needs a closer look.
Damp seepage at the water pump bleed hole
- What you'll notice
- A small coolant stain or crust under the front of the engine, with the level staying where it should be.
- Why it happens
- The water pump has a bleed hole that weeps a little coolant by design, which looks like a leak.
- What to do
- Have it checked once to confirm the level is steady; pumps often get replaced for this when they do not need to be.
Oil seepage on the engine front cover
- What you'll notice
- A film of oil on the front of the engine or a few drops on the driveway, with no big drop in oil level.
- Why it happens
- Oil can seep from the joint at the engine front cover.
- What to do
- Have the source confirmed and the level checked at each fill; a slow seep can be monitored.
Infotainment screen blank or slow to start up
- What you'll notice
- The centre screen stays black or takes a long time to come up after you start the car, and the radio and camera may be missing.
- Why it happens
- Software in the infotainment unit can hang on start-up.
- What to do
- Ask for the latest software update at your next visit; nothing else on the car is affected.
Mist inside the headlight lens
- What you'll notice
- A haze or fog on the inside of a headlight, usually after rain or a car wash, that clears slowly.
- Why it happens
- Moist air gets into the headlight housing and condenses on the cool lens.
- What to do
- Have it compared with Mazda's guidance at a service visit; light haze that clears is normal, water pooling is not.
Musty smell or water from the cabin air filter
- What you'll notice
- A damp, musty smell from the vents, and sometimes water where the cabin filter sits.
- Why it happens
- The cabin air filter can get wet, and a wet filter grows the mould that causes the smell.
- What to do
- Have the filter and its housing checked and the drain cleared; a fresh filter usually fixes the smell.
Repair prices for your Mazda CX-5
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace rear pads and rotors and service caliper slides
- Replace driver mirror glass or mirror assembly
- Replace windshield
- Treat rust and repaint lower liftgate
- Replace liftgate support struts
- Replace thermostat and refill coolant
- Retighten or replace front strut mounting bolts
- Replace or add protector to fuel filler pipe
- Replace headlamp assembly with LED running light
- Replace Mazda Connect touchscreen display
- Replace side curtain airbag module
- Update engine software and inspect valve train
- Replace in-tank fuel pump
- Replace cylinder head assembly
- Replace engine thermostat and coolant
- Repair or replace steering column assembly
- Service front brake pads and hardware
- Diagnose and replace power liftgate control unit
- Diagnose shift noise and service transmission fluid
- Diagnose valve train noise
- Inspect water pump and pressure test cooling system
- Reseal engine front cover
- Replace rear differential assembly
- Update infotainment software
- Inspect headlight housing and seals
- Replace cabin air filter and clear housing drain
- Reroute or replace trailer hitch wiring harness
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.