Your 2014 Mazda Mazda5problems, repair costs and recalls
What we've documented about the 2014 Mazda Mazda5: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2014 Mazda Mazda5
12 documented issues apply to 2014, most serious first.
Liftgate struts can corrode and let the hatch fall (recall)
- What you'll notice
- The rear liftgate doesn't stay up, drifts down, or drops suddenly.
- Why it happens
- The gas struts that hold the liftgate open can corrode and break. Mazda recalled 2012-2015 Mazda5s and other models to replace both struts.
- What to do
- Check your VIN for an open recall. Until it's fixed, hold or prop the hatch and keep people clear of it.
Free under recall. Check your VIN or ask a Mazda dealer.
Worn front struts and control arms
- What you'll notice
- Clunks or knocks over bumps, a bouncy or floaty ride, uneven tire wear, or vague steering.
- Why it happens
- Front struts and control arm bushings wear out on the Mazda5, and suspension is the most-complained-about area for the model. Owners of 2006-2008 vans report worn shocks and loud squeaks from underneath.
- What to do
- Have the front suspension inspected. Replace struts in pairs and get an alignment afterwards so the new tires don't wear out early.
Rear shock leaks or broken top mount rattles
- What you'll notice
- A loud rattle or knocking from the rear over bumps, and oily rear shocks.
- Why it happens
- The rear shock absorbers can leak, or the rubber top mount can break and let the shock knock.
- What to do
- Have the rear shocks inspected. If only the mount is broken, a separate mount can be fitted; otherwise replace the shocks in pairs.
Worn top engine mount
- What you'll notice
- More vibration felt in the cabin at idle, especially in Drive, or a thump when pulling away.
- Why it happens
- The upper engine mount wears out and stops absorbing engine movement.
- What to do
- Have the mounts checked. Replacing the top mount is a fairly quick job.
Jerky shifting from a failed transmission control module
- What you'll notice
- Harsh, jerky shifts and the automatic transmission (AT) warning light flashes or stays on.
- Why it happens
- The transmission control module, which sits on the transmission under the battery, can fail.
- What to do
- Have the codes read. If the module is bad, use the correct part number for your van; rebuilt units vary in quality.
Manual clutch slips or wears out early
- What you'll notice
- On manual-transmission vans the engine revs climb without the van speeding up, especially in higher gears, or the clutch pedal feels different.
- Why it happens
- Owners report clutches slipping or failing around 55,000 miles on both generations.
- What to do
- Have the clutch checked. Once it slips, replacement is the only fix; a slave cylinder problem should be ruled out first.
Starts in Neutral but not in Park
- What you'll notice
- The engine won't crank with the shifter in Park but starts in Neutral.
- Why it happens
- Rust at the pivot of the shift cable stops the transmission from fully reaching the Park position the starter switch looks for.
- What to do
- Have the shift cable pivot cleaned and lubricated. Always set the parking brake if you have to start in Neutral.
Burns oil at higher mileage
- What you'll notice
- The oil level drops between changes even though there is no visible leak. Heavy oil burners may puff bluish smoke.
- Why it happens
- Both the 2.3L and 2.5L engines can start using oil as they age. Separately, some owners of 2006 vans report complete engine failure at high mileage, and running an engine low on oil is a common way to cause that.
- What to do
- Check the oil at every fill-up or at least monthly and top it up. Running it low can ruin the engine.
Front sway bar bushings rattle
- What you'll notice
- A rattle or clunk from the front suspension over small bumps or rough pavement.
- Why it happens
- The rubber bushings that hold the front anti-roll bar wear out and let the bar move.
- What to do
- Have the bushings and end links checked. They are cheap parts and quick to replace.
Check engine light from a stuck-open thermostat
- What you'll notice
- The check engine light comes on, the engine takes a long time to warm up and the heater is weak.
- Why it happens
- The thermostat can stick open, so the engine runs too cool.
- What to do
- Have the codes read. Replacing the thermostat is a modest job and restores heat and fuel economy.
Third brake light stops working
- What you'll notice
- The center high-mounted brake light doesn't light up.
- Why it happens
- The wiring connector for the high-mounted brake light can corrode at higher mileage.
- What to do
- Have the connector checked. Sometimes it has to be replaced along with the LED light assembly.
Check engine light from a leaking EVAP vent valve
- What you'll notice
- The check engine light comes on with an evaporative emissions leak code. You may notice no other symptoms.
- Why it happens
- The vent valve in the fuel vapor system can leak.
- What to do
- Check that the gas cap is tight first. If the light returns, the vent valve is an inexpensive part to replace.
Repair prices for your 2014 Mazda Mazda5
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front struts (pair) and alignment
- Replace rear shock absorber
- Replace front sway bar bushings
- Replace top engine mount
- Replace transmission control module
- Replace clutch kit
- Clean and lubricate shift cable pivot
- Replace thermostat
- Diagnose oil consumption
- Replace third brake light connector or light
- Replace EVAP vent valve
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace both liftgate strutsNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…