Mazda Mazda6problems, repair costs and recalls
Problems reported across 2003–2021. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
22 documented issues across all years, most serious first.
Takata airbag inflator recall
- What you'll notice
- Usually nothing at all until a crash. Some owners also notice an airbag warning light.
- Why it happens
- Older Takata airbag inflators can break down after years of heat and humidity and may burst during deployment, throwing metal pieces into the cabin. Mazda has urged owners of unrepaired older cars not to drive them.
- What to do
- Ask a Mazda dealer to check your VIN for open recalls today. If an airbag recall is open, ask the dealer about towing the car in for the free repair rather than driving it.
Rusted front crossmember (recall)
- What you'll notice
- Clunking or banging from the front end over bumps, or heavy rust visible under the front of the car.
- Why it happens
- In states that use road salt, the front subframe can rust badly enough to weaken it. Mazda ran recalls to inspect, treat or replace it.
- What to do
- Check for open recalls by VIN and have the front subframe inspected, especially if the car has spent winters in the salt belt. Do not ignore new clunks from the front.
Engine may stall while driving (recall)
- What you'll notice
- The engine cuts out while you are driving or idling, often with warning lights on the dash.
- Why it happens
- A software error in the engine computer could make it stall. Mazda reprogrammed affected cars under a recall shared with some Mazda3 and CX-5 models.
- What to do
- Check your VIN for open recalls and get the free reprogramming. Stalling at speed is a safety risk.
Fuel pump in the tank can fail (recall)
- What you'll notice
- Rough running, hesitation, the engine stalling while driving, or cranking without starting.
- Why it happens
- A part inside the low-pressure fuel pump can crack and stop the pump from sending fuel to the engine. Mazda recalled affected cars to replace the pump.
- What to do
- Check your VIN for this recall and have the pump replaced. If the engine stumbles or stalls, stop driving and have the car towed in.
Fuel sender unit can leak at the top of the tank (recall)
- What you'll notice
- A strong gasoline smell, especially with a full tank, and sometimes damp fuel staining under the car near the tank.
- Why it happens
- The sender unit on top of the fuel tank may not have been installed correctly at the factory, so fuel can seep past it.
- What to do
- Stop driving it until a dealer checks the VIN and repairs it, because leaking fuel near a hot exhaust is a fire risk.
Rear seat belt retractor may not lock (recall)
- What you'll notice
- Nothing you can feel day to day; a rear belt may simply fail to lock up in a sudden stop or a crash.
- Why it happens
- Some rear belt retractors left the factory without their retaining pins, so the locking mechanism may not hold.
- What to do
- Have a dealer check the VIN and replace the affected retractors; treat any rear belt that pulls out freely under a hard tug as unsafe.
Fuel tank coating damage can lead to rust and leaks (recall)
- What you'll notice
- A fuel smell under the car or wet staining on the tank, usually after years of road salt and moisture.
- Why it happens
- The protective coating on California specification tanks can be damaged, which lets the steel underneath corrode and eventually weep fuel.
- What to do
- Have the tank inspected under the recall and repaired or replaced; a rusting fuel tank is a fire risk and should not wait.
Weld debris can damage passenger seat airbag wiring (recall)
- What you'll notice
- Airbag warning light, a passenger airbag off light with an adult in the seat, and in some cases heavy steering from lost power assist.
- Why it happens
- Metal debris left from welding can chafe the wiring for the passenger seat occupant sensor and short it out.
- What to do
- Have the dealer fit the protective pad under the recall; until it is done treat the front passenger airbag as not working.
Spider webs block fuel tank vent (recall)
- What you'll notice
- Check engine light, a fuel smell, or trouble refueling.
- Why it happens
- Yellow sac spiders can build webs inside the evaporative vent line. The blockage creates vacuum in the tank that can crack it over time. Mazda recalled cars to update software and replace damaged tanks.
- What to do
- Check your VIN for open recalls. Any raw fuel smell should be inspected promptly because of fire risk.
Rear parking brake sticks from corrosion (recall)
- What you'll notice
- The parking brake drags, will not fully release, or the car feels like it is being held back after you release it.
- Why it happens
- Water can get into the rear brake calipers and rust the parking brake mechanism inside. Mazda recalled cars to inspect and replace corroded parts.
- What to do
- Check your VIN for the recall. If a rear wheel feels hot after driving or the car drags, have the rear brakes looked at soon.
Door latch screws can work loose (recall)
- What you'll notice
- A door that rattles, is hard to latch, or does not feel fully closed.
- Why it happens
- The screws holding the door latches can back out over time. Mazda recalled the cars so dealers could apply thread-locking compound and retighten them.
- What to do
- Check your VIN for this recall and have it done soon. If a door will not latch firmly, do not carry passengers on that side until it is fixed.
Thermostat sticks open (code P0126)
- What you'll notice
- Check engine light, the engine taking a long time to warm up, a temperature gauge that wanders, weak heat, or a low coolant level.
- Why it happens
- The thermostat can stick open so the engine runs too cool. Mazda issued a series of service bulletins covering this code.
- What to do
- Have the code read and the coolant level checked. Ask a Mazda dealer about bulletin 01-011/21 and its later updates.
Cylinder deactivation fault (code P3400)
- What you'll notice
- Check engine light with code P3400, sometimes with rough running.
- Why it happens
- Small bits of plastic debris can plug the oil control valve that operates the cylinder deactivation system, according to a Mazda service alert.
- What to do
- Have the code read soon and ask a Mazda dealer about service alert SA-047/21. Do not keep driving with a flashing check engine light.
Fog light socket can drop into the bumper (recall)
- What you'll notice
- A fog light stops working, rattles behind the bumper, or in rare cases the bumper is scorched where the hot bulb rests against it.
- Why it happens
- The socket holder can separate from the fog light housing and let the lit bulb fall inside the bumper cover.
- What to do
- Have the dealer fit the retaining spring under the recall; until then leave the fog lights switched off.
Brake fluid warning light may not come on (recall)
- What you'll notice
- No warning light even when the brake fluid is low, so a leak can go unnoticed until the pedal feels soft or sinks.
- Why it happens
- The float in the brake fluid reservoir sensor can slip off its guide, so it no longer signals a low level.
- What to do
- Check the fluid level in the reservoir yourself and ask the dealer about the recall repair; a brake fluid leak needs attention immediately.
Alternator belt can slip in heavy rain and trigger a charging warning (recall)
- What you'll notice
- In a downpour or through deep water the charging warning appears and the car may go into a reduced power mode.
- Why it happens
- Water on the accessory belt makes it slip, and the engine computer reads the dip in output as a charging failure.
- What to do
- Get the free software reprogramming at a dealer; if it happens before then, pull over somewhere safe and restart the car.
Overfilling the tank can push fuel into the charcoal canister (recall)
- What you'll notice
- A strong fuel smell after topping off at the pump, sometimes with a rough start or a check engine light.
- Why it happens
- Without a shut-off valve the tank can be filled past its design level, so liquid fuel reaches the charcoal vapor canister.
- What to do
- Have the recall adapter and canister inspection done, and in the meantime stop filling at the first click of the pump.
Dashboard top turns soft and sticky
- What you'll notice
- The dash surface becomes tacky, shiny or soft on hot days and reflects glare onto the windshield.
- Why it happens
- The dash material can degrade in heat and humidity, most often on cars from around 2010. A Mazda coverage extension existed but has since ended.
- What to do
- Use a sunshade and a dash cover to cut glare. Replacement of the dash pad is the permanent fix.
Tire pressure warning may miss a slow leak in all four tires (recall)
- What you'll notice
- No low tire pressure light even though all four tires have slowly lost air.
- Why it happens
- The tire pressure monitoring software may not notice when all four tires lose pressure gradually at the same rate. Mazda recalled the cars for a software fix.
- What to do
- Check your VIN for this recall. Until it is done, check tire pressures with a gauge once a month.
Turn signals may not switch off on their own (recall)
- What you'll notice
- After a turn the signal keeps flashing instead of cancelling, so other drivers cannot tell what you plan to do.
- Why it happens
- Some cars with fog lights were built with the wrong combination switch behind the steering wheel.
- What to do
- Have the switch replaced under the recall, and until then cancel the signal by hand after every turn.
Navigation card makes the screen restart in cold weather
- What you'll notice
- On cold mornings the infotainment screen reboots itself over and over, and it stops if the navigation card is pulled out.
- Why it happens
- A batch of navigation memory cards misbehaves at low temperature and crashes the system.
- What to do
- Ask a dealer to check the card against the bulletin and replace it; nothing else in the car is harmed by this.
Infotainment screen goes blank or restarts by itself
- What you'll notice
- The centre display goes dark or reboots on its own while driving, taking the radio, phone connection and backup camera view with it. It often comes back after a restart, and Bluetooth pairing can be lost.
- Why it happens
- Mazda issued a troubleshooting bulletin for Mazda Connect units that reboot or show a blank screen; the fix is usually a software update or replacing the faulty part the chart points to. Owners of this generation describe the system as slow and glitchy in general.
- What to do
- Note when it happens and have a dealer check the Mazda Connect software level against the bulletin and update it. It is an annoyance rather than a safety problem, but get it fixed if the backup camera view drops out.
Repair prices for your Mazda Mazda6
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace airbag module with recall-remedy inflator
- Replace front crossmember (subframe) and align
- Replace dashboard upper panel (crash pad)
- Clean canister vent line, replace check valve, update PCM
- Replace rear parking brake actuators or calipers (pair)
- Update engine computer (PCM) software
- Replace in-tank fuel pump module
- Reprogram tire pressure monitoring software
- Apply thread locker and retorque door latch screws
- Replace thermostat and top up coolant
- Replace oil control valve for cylinder deactivation
- Inspect and reseal or replace the fuel tank top
- Install fog light socket retaining spring
- Replace brake fluid level sensor assembly
- Replace rear seat belt retractor
- Inspect fuel tank coating, replace tank if corroded
- Reprogram the powertrain control module
- Install fuel shut-off valve adapter and inspect canister
- Protect occupant sensor wiring, repair if damaged
- Replace the combination switch
- Replace the navigation SD card
- Mazda Connect software update, replace display unit if needed
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.