Your 2005 Mazda RX-8problems, repair costs and recalls
What we've documented about the 2005 Mazda RX-8: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2005 Mazda RX-8
20 documented issues apply to 2005, most serious first.
Rotary engine loses compression
- What you'll notice
- Hard starting, especially when the engine is warm, a rough idle, misfires and a gradual loss of power. Eventually the car may not start at all.
- Why it happens
- The rotary engine's apex seals and rotor housings wear, so one or both rotors lose compression. Low oil and lots of short trips speed this up. Many cars needed a replacement engine between about 60,000 and 100,000 miles. Mazda once extended the engine core warranty on 2004-2008 cars to 8 years or 100,000 miles, but that coverage has now run out.
- What to do
- Before buying or repairing, get a rotary-specific compression test (a normal piston-engine tester won't give a valid reading). If compression is low, the fix is a rebuilt or replacement engine, so compare quotes from rotary specialists.
Clogged or failed catalytic converter
- What you'll notice
- Loss of power, the engine feeling choked at higher revs, a check engine light, a rattling or rotten-egg smell from the exhaust, or a failed emissions test.
- Why it happens
- Misfires and flooding send raw fuel into the converter, which overheats and can melt or break up inside.
- What to do
- Fix any misfire first, or a new converter will fail too. Have exhaust back pressure checked and replace the converter if it is blocked.
Oil loss that damages the rotary engine
- What you'll notice
- The oil level drops between changes, a low oil pressure warning, or a puddle of oil under the front of the car.
- Why it happens
- A rotary engine burns some oil on purpose to lubricate its seals, so the level falls even on a healthy car. Corroded oil cooler lines can also start leaking. Running low on oil overheats the seals and is a common cause of engine failure.
- What to do
- Check the oil at every fill-up and top it up as needed. If you see oil leaking near the front of the engine, have the oil cooler lines inspected right away.
Fuel leak from fuel pump seals and pipe (recall)
- What you'll notice
- A smell of gasoline inside or near the car, especially after driving, or wetness around the fuel tank under the rear seat.
- Why it happens
- Heat from the exhaust can wear out the fuel pump's sealing rings, and a fuel pump pipe can crack. Either can leak fuel and cause a fire. Mazda recalled these years (NHTSA 16V-793 and 17V-354).
- What to do
- If you smell fuel, don't drive the car; have it towed. Check the VIN for open recalls; dealers replace the seals and pipe and add a heat shield for free.
Takata driver air bag can rupture (recall)
- What you'll notice
- No warning. The danger appears only when the air bag deploys in a crash.
- Why it happens
- The driver's air bag inflator can be damaged by moisture over time and burst when it deploys, throwing metal fragments. Mazda recalled these cars (NHTSA 17V-474) and has told owners of unrepaired cars not to drive them.
- What to do
- Check the VIN for open recalls right away. If the recall is open, don't drive the car; have it towed to a Mazda dealer for the free repair.
Takata passenger air bag can rupture (recall)
- What you'll notice
- No warning. The danger appears only when the passenger air bag deploys in a crash.
- Why it happens
- The passenger air bag inflator can explode and throw metal fragments into the cabin. These cars were covered by several recalls (NHTSA 18V-402, 18V-403, 19V-488 and 19V-781).
- What to do
- Look up the VIN for open recalls. If one is open, have the car towed to a dealer for the free replacement and don't carry a front passenger until it is fixed.
Engine heat damage and fuel leak at high rpm (recall)
- What you'll notice
- Possible fuel smell or engine running problems after sustained high-rpm driving; often no warning before the fault.
- Why it happens
- Mazda found that long periods at very high engine speed could cause heat damage that leads to a fuel leak and a fire risk (NHTSA 05V-317, about 52,000 early cars).
- What to do
- Check the VIN for this recall and make sure it was completed. If you ever smell fuel, park the car and have it inspected.
Electric power steering loss or jerky steering
- What you'll notice
- Steering suddenly becomes very heavy, a power steering warning light comes on, or the steering jerks or feels notchy while turning.
- Why it happens
- The RX-8 uses electric power steering. Faults in the steering motor, its control unit or low system voltage can switch the assist off or make it uneven.
- What to do
- Grip the wheel firmly and slow down if assist drops out. Test the battery and charging system, then have the steering system scanned for codes.
Engine floods and won't start after a short run
- What you'll notice
- The engine cranks but won't catch, often after the car was started cold and shut off after only a minute or two. You may smell fuel.
- Why it happens
- If a cold rotary is shut off before it warms up, unburned fuel collects in the housings and soaks the plugs. Weak coils, worn plugs or low compression make flooding much more likely.
- What to do
- Avoid starting the car just to move it a few feet; let it warm up before shutting it off. A shop (or the owner's manual de-flood procedure) can clear it. If it keeps flooding, check the plugs, coils, battery and compression.
Ignition coil failure and misfires
- What you'll notice
- Flashing or steady check engine light, sputtering, a rough idle, loss of power under load, and harder starting.
- Why it happens
- The RX-8's ignition coils and plug wires wear out much sooner than on a normal engine. A weak coil lets the rotary misfire, and the unburned fuel can then damage the catalytic converter.
- What to do
- Don't keep driving with a flashing check engine light. Have the misfire codes read and replace weak coils, usually together with the plugs and wires.
Weak starter and hot no-start
- What you'll notice
- The engine turns over slowly or not at all, especially when it's hot, or you only hear a click.
- Why it happens
- A rotary needs strong cranking speed to start. Starters and batteries that are getting weak, plus heat soak around the starter, leave the engine cranking too slowly to fire.
- What to do
- Test the battery and cables first, since a weak battery causes the same symptoms. If they are good, replace the starter.
Coolant level warning and overheating
- What you'll notice
- The coolant level light comes on, the temperature gauge rises, or coolant is lost from the reservoir.
- Why it happens
- Thermostats that stick closed, a faulty coolant level sensor, and a leaking expansion tank or cap can all cause trouble. Mazda issued a service bulletin about the coolant level warning. Overheating is especially bad for a rotary engine.
- What to do
- Stop if the gauge climbs. Have the cooling system pressure tested and the sensor checked. Don't ignore it, because overheating can ruin the engine.
Broken engine mounts
- What you'll notice
- Heavy vibration at idle, a clunk when shifting or getting on and off the throttle, and the engine rocking more than normal.
- Why it happens
- The rubber in the engine and transmission mounts cracks and collapses with age.
- What to do
- Have the mounts inspected. Replace any that are cracked or sagging; badly broken mounts can strain hoses and the exhaust.
Fuel pump failure
- What you'll notice
- Hard starting, stalling or sputtering under load, or the engine cranking but not starting.
- Why it happens
- The in-tank fuel pump on the RX-8 is one of the more commonly replaced parts, and heat near the tank adds wear.
- What to do
- Have fuel pressure tested before replacing parts. Also make sure the fuel leak recall for your year has been done.
Clutch pedal and hydraulic problems
- What you'll notice
- The clutch pedal feels soft, sticks to the floor, or the car grinds going into gear. Some owners hear a whine from the release bearing.
- Why it happens
- On manual cars, the clutch master cylinder, the pedal pivot and linkage, and the release bearing wear out more often than usual.
- What to do
- Check the clutch fluid level and look for leaks. A shop can tell whether the master cylinder, linkage or clutch itself needs replacing.
Alternator failure
- What you'll notice
- Battery or charging light on, dimming lights, or a battery that keeps going flat.
- Why it happens
- The alternator is among the RX-8's common replacement parts. A weak charging system also makes starting and steering assist problems worse.
- What to do
- Have the charging system tested. Replace the alternator if output is low.
Hesitation from stuck intake shutter valve
- What you'll notice
- The car stumbles or feels flat around 5,000 to 7,000 rpm, sometimes with a check engine light (codes such as P2070 or P0661).
- Why it happens
- Valves in the intake manifold (the secondary shutter valve and related solenoids and actuators) can stick from carbon buildup or have a failed solenoid, so the engine can't breathe properly at higher revs.
- What to do
- Have the codes read. Cleaning and freeing the valve, or replacing a solenoid or actuator, usually fixes it.
Climate control unit fails to adjust temperature
- What you'll notice
- The heat or A/C won't change temperature when you turn the knob, the display is faulty, or the controls stop responding.
- Why it happens
- The climate control panel and head unit fail on these cars, so they can no longer control the system properly.
- What to do
- Have the HVAC system checked to rule out a blend door motor. If the control unit is at fault, it needs to be replaced.
Water inside the tail lights
- What you'll notice
- Fog, water droplets or standing water inside the rear light lenses.
- Why it happens
- The tail light seals let moisture in. Water can eventually corrode the bulb sockets.
- What to do
- Have the light units resealed or replaced. Check the bulbs and sockets for corrosion while you're at it.
Power window regulator or motor failure
- What you'll notice
- A window moves slowly, stops partway, makes grinding noises, or drops into the door.
- Why it happens
- The window regulators and motor gears wear and break.
- What to do
- Have the door opened up and the regulator or motor replaced.
Repair prices for your 2005 Mazda RX-8
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace with rebuilt or remanufactured rotary engine
- De-flood engine and replace spark plugs
- Replace ignition coils (often with plugs and wires)
- Replace catalytic converter
- Replace leaking oil cooler lines
- Replace starter motor
- Clean or free shutter valve, or replace solenoid/actuator
- Replace thermostat, coolant level sensor or expansion tank cap
- Replace engine and transmission mounts
- Replace fuel pump
- Replace power steering control module
- Replace clutch kit (master cylinder or linkage repairs cost less)
- Replace alternator
- Replace window regulator or motor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace fuel pump seals and pipe, add heat insulator (recalls 16V-793, 17V-354)No charge if your vehicle is included
- Replace driver air bag inflator (recall 17V-474)No charge if your vehicle is included
- Replace passenger air bag inflator (recalls 18V-402 and related)No charge if your vehicle is included
- Dealer recall repair (recall 05V-317)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…