Your 2007 Mercedes-Benz CLSproblems, repair costs and recalls
What we've documented about the 2007 Mercedes-Benz CLS: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Mercedes-Benz CLS
11 documented issues apply to 2007, most serious first.
Air suspension (Airmatic) sagging or compressor failure
- What you'll notice
- One corner or the whole car sits low after parking, the car is slow to rise, the compressor runs loudly or often, or a 'Car too low' warning appears.
- Why it happens
- The rubber air bags in the struts crack and leak with age, and the compressor wears out from running constantly to make up for leaks. If the compressor dies, the car can become undrivable.
- What to do
- Don't drive on a sagging corner, as it overworks the compressor. Have an independent Mercedes specialist find the leak; fixing a leaking strut early can save the compressor.
Balance shaft or timing idler gear wears out
- What you'll notice
- Check engine light with camshaft/crankshaft timing codes (P0016 or P0017), then a rattle from the timing chain. Left alone, the engine can be destroyed.
- Why it happens
- On early 5.5L V8 engines the idler gear that drives the timing system was made of a soft metal that wears prematurely, letting the timing chain go slack. Engines built from about 2008 on got improved gears.
- What to do
- If you see P0016/P0017, stop driving hard and get a specialist diagnosis right away. Check the engine serial number to see if yours has the improved gear.
Glass sunroof panel can come loose (recall)
- What you'll notice
- Usually no warning. The glass panel of the sliding sunroof can separate from its frame and fly off while driving.
- Why it happens
- The bond between the glass and the sliding roof frame can deteriorate with age.
- What to do
- Check your VIN for recalls 19V-918, 21V-196, 22V-954 and 24V-874. The dealer will inspect the bonding and replace the sunroof panel free if needed.
Head bolts corrode and leak coolant (AMG 6.2L V8)
- What you'll notice
- Coolant level keeps dropping while the oil level rises, milky sludge in the oil, white smoke from the exhaust and a rough idle. A large leak can lock up the engine.
- Why it happens
- The head bolts on early 6.2L AMG engines corrode and lose clamping force, letting coolant leak into the cylinders and oil. Engines built after about mid-2010 have improved bolts.
- What to do
- Stop driving if coolant is disappearing and the oil looks milky. Have a cooling-system pressure test and oil analysis done; replacing the bolts early is cheaper than a ruined engine.
Ticking from worn camshafts (AMG 6.2L V8)
- What you'll notice
- A ticking noise for a few seconds on a cold start that gradually lasts longer, later misfires and lost power.
- Why it happens
- The camshaft lobes and the followers that ride on them wear on the 6.2L AMG engine. Severe wear can break followers.
- What to do
- Have a specialist inspect the cams through the valve covers. Keep oil changes frequent with the correct oil.
Intake manifold flaps stick or break
- What you'll notice
- Reduced power, worse fuel economy, a poor idle and sometimes a check engine light.
- Why it happens
- The variable-length intake manifold's flaps get gummed up with oil and carbon, and its plastic parts get brittle and break.
- What to do
- Have the codes read. Repair kits for the flap linkage cost much less than a whole manifold.
Harsh shifts or transmission limp mode
- What you'll notice
- Harsh or jerky gear changes, or the car gets stuck in one gear with a warning message.
- Why it happens
- The 7-speed automatic's fluid is called 'lifetime' but breaks down, causing harsh shifts. The conductor plate (the internal circuit board with the speed sensors) can also fail at higher mileage.
- What to do
- Have the transmission scanned. A fluid and filter service often helps harsh shifts; speed-sensor codes usually point to the conductor plate.
Oil leaks from valve covers and rear main seal
- What you'll notice
- Oil spots under the car, a burning-oil smell, or oil on the engine and transmission.
- Why it happens
- The valve cover gaskets and the rear crankshaft seal harden and leak at higher mileage.
- What to do
- Have the leak pinpointed. Valve cover gaskets are a moderate job; the rear main seal needs the transmission removed.
Fuse/relay module (SAM) fails from water
- What you'll notice
- Random electrical faults: lights, windows, wipers or locks acting up, and false warning messages.
- Why it happens
- The signal acquisition modules (SAMs) that control many functions corrode when water gets in, often from blocked drains.
- What to do
- Check for wet carpets and clear any blocked drains. A specialist can test and replace or repair the affected module.
Secondary air pump failure
- What you'll notice
- Check engine light with emissions codes, sometimes a failed inspection. The car usually drives normally.
- Why it happens
- The secondary air pump that helps the engine warm up the catalytic converters fails, often from moisture.
- What to do
- Have the codes read and the pump and valves checked before an emissions test.
Front control arm bushings and ball joints wear
- What you'll notice
- Clunking over bumps, vague or wandering steering and uneven tire wear.
- Why it happens
- The rubber bushings and ball joints in the front suspension wear out over time on every generation.
- What to do
- Have the front suspension inspected and get an alignment after any parts are replaced.
Repair prices for your 2007 Mercedes-Benz CLS
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace one leaking air strut (compressor if worn out)
- Replace timing idler gear, timing chain and related parts
- Replace cylinder head bolts and head gaskets (both heads)
- Replace camshafts and followers (one or both banks)
- Repair or replace variable intake manifold
- Transmission fluid service or conductor plate replacement
- Replace secondary air pump
- Replace valve cover gaskets (rear main seal costs more)
- Replace and program SAM module
- Replace front control arm (one side) and align
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect and replace sliding sunroof panel under recallNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…