Mercedes-Benz E-Classproblems, repair costs and recalls
Problems reported across 1996–2026. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
25 documented issues across all years, most serious first.
Rust, including front spring mounts that can tear away from the body
- What you'll notice
- Rust bubbles around the wheel arches, door edges and trunk lock, or a loud bang and one front corner suddenly dropping.
- Why it happens
- This generation is known for poor rust protection. The welded mount that holds the top of the front spring can corrode and separate from the inner fender.
- What to do
- Have the front spring mounts inspected on a lift right away. If one is rusted or cracked, do not drive the car until it is repaired.
Electronic brake system can drop into back-up mode (recall)
- What you'll notice
- A red brake warning with a service brake message, and a pedal that suddenly needs much more effort and travel to stop the car.
- Why it happens
- These cars use an electro-hydraulic brake system. A fault can switch it to a plain hydraulic back-up with no power assist.
- What to do
- Check the VIN for recalls 04V-296 and 05V-133. If the red brake warning appears, stop when safe and have the car towed.
Electronic brake pump unit reaches the end of its service life
- What you'll notice
- A brake service message that keeps returning, then a red warning and a hard pedal with weak braking.
- Why it happens
- The brake pump unit counts brake applications and wears out after a set number. Mercedes-Benz USA extended warranty coverage on this unit to 25 years with no mileage limit.
- What to do
- Ask a Mercedes dealer to replace the unit under the extended coverage. Do not keep driving with a red brake warning.
Balance shaft or timing idler gear teeth wear down
- What you'll notice
- Check engine light for camshaft timing, rough idle, misfires, hard starting and a growing rattle from the front of the engine.
- Why it happens
- A gear on the balance shaft (V6) or the timing idler (V8) was made of metal that was too soft. As the teeth wear, valve timing drifts off. Later engines got a harder gear.
- What to do
- Have the codes read and the engine serial number checked against the affected range. Do not keep driving with a timing rattle, since the chain can skip.
Driveshaft joint can break on all-wheel-drive models (recall)
- What you'll notice
- Vibration or clunking from under the car, or a sudden loss of drive while the engine still runs.
- Why it happens
- A universal joint on the driveshaft of some 4MATIC cars can break.
- What to do
- Check the VIN for recall 26V-216 and have the driveshaft replaced free. Stop driving if you feel new driveline vibration.
Infotainment restart can blank the instrument display (recall)
- What you'll notice
- The center screen reboots while driving and the speedometer and warning display go dark for a time.
- Why it happens
- A software fault can make the infotainment computer reset, and the driver display goes blank with it.
- What to do
- Check the VIN for recall 26V-281 and get the free software update. If the display goes blank, pull over when safe until it returns.
Glass sunroof panel can come loose and fly off
- What you'll notice
- Wind noise or a rattle from the roof, or the glass panel sits unevenly in its frame; in the worst case the panel leaves the car while driving.
- Why it happens
- The bonding that holds the glass sunroof panel to its frame can weaken with age and heat, so the panel is no longer held securely.
- What to do
- Have the sunroof inspected right away and leave it closed until a dealer confirms the panel is secure; the work is free under a safety recall.
Power steering can lose its fluid (recall)
- What you'll notice
- Steering turns heavy, a whine comes from the front of the car and reddish fluid shows up under the front end.
- Why it happens
- A power steering line or connection can lose fluid, so the pump runs short and the help it gives the driver drops away.
- What to do
- Stop driving if the steering goes heavy and have the car checked under the recall; losing assist at speed makes the car hard to control.
Diesel fuel filter can leak
- What you'll notice
- A strong diesel smell under the hood and wet, oily film or drips around the filter housing at the front of the engine.
- Why it happens
- The fuel filter and its housing can seep at the seals, letting diesel escape under pressure.
- What to do
- Have it replaced under the recall without waiting; leaking diesel on hot engine parts is a fire risk.
Oil can leak from the timing chain tensioner gasket (recall)
- What you'll notice
- A burning oil smell, oil drips at the front of the engine and an oil level that falls between changes.
- Why it happens
- The gasket at the chain tensioner can seep, and the oil it lets out runs onto hot parts of the engine.
- What to do
- Have the gasket replaced under the recall without delay; oil on a hot engine can catch fire.
Transmission wiring connection can corrode and short (recall)
- What you'll notice
- A hot plastic smell, transmission warning messages or the car dropping into a limited limp-home mode.
- Why it happens
- The transmission wiring connection was put together wrongly, so moisture gets in, corrodes the pins and can short across them.
- What to do
- Have it corrected under the recall right away; a short in this harness can start a fire.
Loose battery ground connections can overheat (recall)
- What you'll notice
- A hot electrical smell, odd electrical faults around the car or an engine that will not start.
- Why it happens
- The 12-volt and 48-volt ground connections may not have been tightened properly in build, so they heat up when current runs through them.
- What to do
- Have the grounds checked and tightened under the recall promptly; a hot connection can start a fire.
Rear camber strut bracket can break away from the axle carrier (recall)
- What you'll notice
- The back of the car feels loose or wanders in a straight line, often with a clunk from the rear over bumps.
- Why it happens
- The bracket that holds the rear camber strut may have been welded badly and can separate from the rear axle carrier.
- What to do
- Do not drive the car until a dealer has inspected it under the recall; if the bracket lets go the rear wheel can steer on its own.
Automatic transmission gets stuck in one gear from a failed control plate
- What you'll notice
- The car suddenly will not shift, pulls away sluggishly as if it started in a high gear, or holds one gear with the check engine light on. Some cars shift hard or refuse to engage Reverse.
- Why it happens
- The electrical plate that sits on the valve body carries the shift solenoids and speed sensors. Its contacts break down, and transmission fluid can wick up the plug and soak the control module, so the transmission drops into a protective limp mode.
- What to do
- Have it read for transmission codes soon and keep speeds low until it is fixed. Driving on a failed plate is hard on the gearbox, and the plug and connector should be replaced along with the plate so fluid cannot track up the wiring again.
Crankshaft pulley can come apart and throw the drive belt
- What you'll notice
- A rumble or wobble from the front of the engine, a squealing belt, then the belt comes off. Once it is gone the battery light comes on, the steering goes heavy and the engine heats up quickly.
- Why it happens
- The crankshaft pulley is built in two pieces with a rubber ring between them to damp vibration. The rubber hardens and breaks down with age and heat, the outer ring shifts, and the belt is no longer tracked properly.
- What to do
- Stop driving once the belt is off, because the water pump stops turning and the engine will overheat. Have the pulley inspected for wobble or a shifted outer ring at regular services on a car of this age.
Air suspension struts and compressor leak or fail
- What you'll notice
- One corner or the whole car sitting low after parking, a car too low message, a compressor that runs constantly or a harsh, thumping ride.
- Why it happens
- On cars with air suspension, the rubber in the air struts cracks with age and leaks. The compressor and valve block then wear out from running too much.
- What to do
- Have the system leak-tested soon. Do not drive on a fully collapsed corner, and fix leaks before they burn out the compressor.
48-volt battery fails and the car will not start
- What you'll notice
- A 48V battery or stop vehicle message, then the car will not start or will not restart after a stop.
- Why it happens
- The mild-hybrid system uses a separate 48-volt battery to start the engine. Owners and the auto press report that this battery or its electronics can fail early.
- What to do
- Have a dealer test the 48-volt system and check for software updates and warranty coverage. Expect a tow if it will not start.
Crankshaft vibration damper ring can separate (recall)
- What you'll notice
- A knock or rumble from the front of the engine, or a loose metal ring found lying in the engine bay.
- Why it happens
- Too little adhesive was used in build, so the inner mass ring of the vibration damper can come away from the pulley.
- What to do
- Have the damper inspected and replaced under the recall; a loose ring can wreck the belt drive and hurt someone working under the hood.
Harsh or jerky automatic gear changes
- What you'll notice
- A thump or jerk shifting from first to second and second to third, and the gearbox can feel like it hunts before it settles.
- Why it happens
- The shift software and the torque converter lock-up clutch can work against each other, and aged fluid or a worn valve body makes it worse.
- What to do
- Have the fluid level and the transmission software checked at the next service; it is safe to keep driving, but shift quality only gets worse if it is left.
Diesel oil cooler seals leak oil into the engine valley
- What you'll notice
- Low oil warnings, an oil smell through the vents and oil pooling at the back of the engine and around the bell housing.
- Why it happens
- The oil cooler sits in the V of the engine, and its rubber seals harden with heat until they no longer hold oil in.
- What to do
- Have the seals replaced before the level gets low; the intake has to come off for the job, so a small leak is cheaper to fix than a big one.
Rattle from the engine for a few seconds on a cold start
- What you'll notice
- A rattle or chatter for a second or two after a cold start, sometimes with a slow crank and a check engine light for cam timing.
- Why it happens
- The camshaft adjusters bleed down overnight and the secondary chain tensioners have no oil pressure until the engine builds it, so the chain slaps.
- What to do
- Have the cam timing codes read at the next service; a rattle that lasts longer as the months pass needs attention before the chain guides wear.
Tires marked with the wrong maximum pressure (recall)
- What you'll notice
- Nothing shows while driving; the pressure number moulded into the tire sidewall is higher than the tire is actually built for.
- Why it happens
- The tires were marked with a maximum inflation pressure they do not meet, so anyone filling to the sidewall number overinflates them.
- What to do
- Have the tires replaced under the recall, and in the meantime set pressures to the door sticker rather than the sidewall; an overinflated tire can fail.
Cross-traffic automatic braking can stop working (recall)
- What you'll notice
- The car no longer brakes by itself when something crosses behind while reversing, usually with no warning message.
- Why it happens
- A software fault in the infotainment system switches off the braking part of the cross-traffic alert.
- What to do
- Have the software updated under the recall and keep looking behind you yourself when backing out.
Power window falls into the door and will not come back up
- What you'll notice
- A window goes down and stops part way or drops out of sight into the door, often with a clatter from inside the door panel. The switch and motor may still buzz.
- Why it happens
- The window regulator uses a cable and plastic guide pieces that go brittle with age. When a guide or cable lets go the glass is no longer held, so it slides down into the door.
- What to do
- Stop using that switch so the loose glass is not dragged further, and have the regulator replaced. The door trim has to come off, so it is worth checking the other windows at the same time.
Diesel emissions settlement repair and extended warranty
- What you'll notice
- Usually nothing to notice. Some owners see a check engine light or more frequent diesel exhaust fluid top-ups.
- Why it happens
- Under a 2020 settlement with US regulators over emissions software, Mercedes-Benz agreed to update the software and some hardware on these diesels and extend the emissions warranty.
- What to do
- Ask a Mercedes dealer whether the approved emissions modification has been done on your VIN and what the extended warranty covers.
Repair prices for your Mercedes-Benz E-Class
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Weld in new front spring perch (one side)
- Update or replace brake control unit (SBC)
- Replace SBC hydraulic brake unit
- Replace balance shaft and timing chain (engine out)
- Replace one air suspension strut
- Approved emissions modification (software and parts)
- Replace driveshaft
- Replace 48-volt battery
- Update infotainment software
- Re-bond or replace the glass sunroof panel
- Replace leaking power steering line and refill
- Replace diesel fuel filter and housing
- Replace crankshaft vibration damper
- Transmission fluid service and shift software update
- Replace timing chain tensioner gasket
- Replace engine oil cooler seals
- Replace camshaft adjusters and secondary chain tensioners
- Repair or replace transmission wiring connector
- Replace the affected tires
- Inspect and retighten 12-volt and 48-volt ground connections
- Inspect and repair rear camber strut bracket
- Update infotainment and driver assistance software
- Replace transmission conductor plate, plug and connector
- Replace one power window regulator
- Replace crankshaft pulley and serpentine belt
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.