Your 2010 Mercedes-Benz GL / GLSproblems, repair costs and recalls
What we've documented about the 2010 Mercedes-Benz GL / GLS: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Mercedes-Benz GL / GLS
11 documented issues apply to 2010, most serious first.
Airmatic air suspension sags and the compressor wears out
- What you'll notice
- A corner or the whole SUV sits low after parking, a suspension warning shows on the dash, or the air compressor runs for a long time.
- Why it happens
- Every first-generation GL rides on Airmatic air suspension. With age the rubber air springs and struts crack and leak, valve blocks and lines lose air, and the compressor wears itself out trying to keep up.
- What to do
- Have the leak found before paying for a compressor, or the new one will fail the same way. Don't drive far with a corner sitting on its bump stops.
Brake booster housing can rust through (recall)
- What you'll notice
- The brake pedal feels hard or inconsistent and the SUV takes longer to stop. In the worst case braking help can be lost.
- Why it happens
- Moisture gets trapped under a rubber sleeve on the brake booster and rusts the housing. Mercedes told owners not to drive affected vehicles until they are repaired.
- What to do
- Stop driving it and call a Mercedes-Benz dealer with your VIN. The inspection and any booster replacement are free under recalls 22V-315 and 24V-298.
7-speed automatic slips, hesitates or gets stuck in gear
- What you'll notice
- Delayed or harsh shifts, the engine revving without the SUV speeding up, or the transmission stuck in one gear until the engine is restarted. Codes such as P2767 or P2768 may be stored.
- Why it happens
- The electronic conductor plate inside the 7-speed transmission's valve body fails, and its speed sensors can stop reading correctly.
- What to do
- Have the transmission codes read by a shop that knows Mercedes. Replacing and programming the conductor plate usually fixes it without a new transmission.
Water leaks damage the SAM control modules
- What you'll notice
- Strange electrical faults: windows moving by themselves, wipers stopping, random warning lights for the parking brake or tire pressure.
- Why it happens
- Water gets in through the battery area, rear pillar, cabin filter box, sunroof seals or tail lights and corrodes the front and rear SAM modules and wiring.
- What to do
- Check the battery first, since a weak one causes similar faults. Then find and seal the leak before replacing any modules, or the new ones will be ruined too.
Driver's airbag inflator can rupture (recall)
- What you'll notice
- Usually no warning signs. The danger only shows up if the airbag goes off.
- Why it happens
- These GLs use a Takata driver's airbag inflator that can break down in heat and humidity and burst, throwing metal pieces at the driver.
- What to do
- Check your VIN for recall 16V-081 and get the free driver airbag replacement as soon as possible.
Transfer case chain stretches and clunks
- What you'll notice
- Clunking or popping from under the SUV, grinding, noise at full steering lock, or a lurch when you accelerate.
- Why it happens
- The chain inside the 4MATIC transfer case stretches with mileage and starts slapping and skipping.
- What to do
- Get it checked soon. Replacing the chain is cheap compared with a whole transfer case, which a dealer may quote at several thousand dollars.
Coolant leaks from hoses, pump and radiator
- What you'll notice
- Sweet coolant smell, drips under the front, a low coolant warning, or the heater blowing cold. It can lead to overheating.
- Why it happens
- Plastic lines, hoses and seals get brittle with heat and age. The water pump, thermostat, turbo coolant lines and radiator are common leak points; cracked radiators and turbo lines show up more on the second generation.
- What to do
- Top up only with Mercedes-approved coolant and have the leak pressure-tested. Fix it quickly; overheating these engines is far more expensive than a hose.
Front suspension bushings and links wear and clunk
- What you'll notice
- Squeaks or clunks from the front over bumps, or creaking from a rear corner.
- Why it happens
- The GL is heavy, and its control arm bushings, ball joints and sway bar end links wear out with mileage.
- What to do
- Have the front end inspected. Worn arms and links are normal repairs, but get an alignment afterward to protect the tires.
Diesel emissions settlement repair and extended warranty
- What you'll notice
- Usually none. Some owners notice the emissions warning or AdBlue (DEF) messages.
- Why it happens
- Mercedes diesels from 2009-2016 carried emissions software that regulators said was not disclosed. A 2020 settlement requires a software update and some new NOx parts, with an extended warranty on those parts.
- What to do
- Ask a dealer whether the settlement update has been done on your VIN. It's free, and it brings extended coverage on related emissions parts.
Covered by the 2020 settlement, not an NHTSA recall.
Door handles and lock actuators stop working
- What you'll notice
- A door won't lock or unlock with the key fob, the touch-sensitive outside handle stops responding, or a lock button fails. The rear driver's door often goes first.
- Why it happens
- The exterior handles wear and get weathered, and the electric lock actuators inside the doors fail.
- What to do
- You can still open the door mechanically. Have the handle or actuator replaced; it's a routine door-panel job.
Secondary air pump fails on start-up
- What you'll notice
- Check engine light with code P0410, or a loud electric whine for the first minute after a cold start.
- Why it happens
- The secondary air injection pump, which helps warm the catalytic converters, fails, often because its relay or 40-amp fuse goes bad.
- What to do
- Check the relay and fuse first, since they cost very little. If the pump itself is dead, an aftermarket unit is much cheaper than a dealer part.
Repair prices for your 2010 Mercedes-Benz GL / GLS
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace leaking air strut and air suspension compressor
- Replace and program the transmission conductor plate
- Replace transfer case chain (or remanufactured transfer case)
- Seal water leak and replace SAM module
- Replace leaking coolant hose, line or radiator
- Replace door handle or door lock actuator
- Replace secondary air pump (or relay)
- Replace front control arms and sway bar links, then align
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
- Emissions software update and NOx parts under settlementNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…