Your 2003 Mercury Grand Marquisproblems, repair costs and recalls
What we've documented about the 2003 Mercury Grand Marquis: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Mercury Grand Marquis
15 documented issues apply to 2003, most serious first.
Automatic transmission slips, shifts erratically or fails
- What you'll notice
- Slipping, a lost gear (often second), erratic shifting, hard engagement into first, or no movement at all.
- Why it happens
- The 4-speed automatic wears out with high mileage. Owners report clutch, band, solenoid and torque converter failures, often needing a rebuild.
- What to do
- Check the fluid level and condition. Get a transmission diagnosis early, since solenoid or valve body faults are cheaper than a full rebuild.
Headlights suddenly go out (recall)
- What you'll notice
- The headlights shut off by themselves while driving, sometimes coming back on after flicking the switch.
- Why it happens
- The lighting control module can fail and cut power to the headlights. This is the most-reported Grand Marquis problem on RepairPal and led to recall 15V-861.
- What to do
- Check your VIN for recall 15V-861. Have it fixed right away, since losing headlights at night is dangerous.
Free at a Ford or Lincoln dealer if the recall has not been done. Ask the dealer to check your VIN for open recalls.
Coolant seeping at the front of the intake manifold
- What you'll notice
- Slow coolant loss, dried coolant crust at the front of the intake near the thermostat, or a faint sweet smell after driving.
- Why it happens
- Later intake manifolds have an aluminum coolant crossover, but the plastic manifold and its seals can still leak where they meet, and some cars still develop cracks.
- What to do
- Watch the coolant level and look for crust at the front of the intake. A shop can pressure-test the system. A leaking manifold is usually replaced as a unit.
Misfire from a failed ignition coil
- What you'll notice
- Rough running, a shaking idle, loss of power and a flashing or steady check engine light.
- Why it happens
- Ignition coils are the most-reported repair in TrueDelta's Grand Marquis survey. They weaken with heat and age, and worn spark plugs and boots put extra strain on them.
- What to do
- Have the misfire codes read to find the cylinder. Replace the bad coil and check the plugs and boots. Avoid long drives with a flashing check engine light.
Clicking behind the dash or air stuck on hot or cold
- What you'll notice
- A repeated clicking or ticking behind the dash, or air that stays hot or cold no matter where you set the temperature.
- Why it happens
- The small electric motor that moves the heater blend door fails, or the door itself breaks. Repairs can require removing part of the dashboard.
- What to do
- A shop can check whether the actuator or the door is at fault. Ask for an estimate first, because labor varies a lot.
Worn ball joints and loose front end
- What you'll notice
- Clunking or popping over bumps, vague or wandering steering, vibration, or uneven tire wear.
- Why it happens
- This heavy car wears out its front ball joints, shocks and stabilizer links. Owners often replace ball joints around 100,000 miles.
- What to do
- Have the front end checked for play at every tire rotation once the car is past 80,000 miles. A failed ball joint can let a wheel collapse, so do not wait.
Loose steering from worn tie rods or steering linkage
- What you'll notice
- Loose, wandering steering, play in the steering wheel, or clunks when turning.
- Why it happens
- Tie rod ends and other steering linkage parts wear out on high-mileage cars, and owners report replacing tie rods, idler arms and Pitman arms.
- What to do
- Have the steering linkage inspected and replace worn parts, then get an alignment.
Fuel pump failure causes stalling or no start
- What you'll notice
- The engine cranks but will not start, stalls, or loses power, especially at highway speeds or when hot.
- Why it happens
- The electric fuel pump in the tank wears out. It is among the more common repairs owners report.
- What to do
- A shop can check fuel pressure to confirm. If the car stalls while driving, get it off the road safely and have it towed.
A/C stops blowing cold
- What you'll notice
- Warm air from the vents with the A/C on, a noisy compressor, or the A/C cycling on and off.
- Why it happens
- The A/C compressor, hoses, seals and the accumulator are common failures as these cars age.
- What to do
- Have the system leak-checked before recharging it. If the compressor failed, the accumulator and orifice tube should be replaced too.
Heater core leak
- What you'll notice
- A sweet coolant smell inside the car, a foggy windshield, wet carpet on the passenger side, or coolant loss.
- Why it happens
- The heater core inside the dash corrodes and leaks over time.
- What to do
- Have it checked soon; coolant fumes are unpleasant and coolant loss can cause overheating. The repair is labor heavy because the core is behind the dash.
Rear air suspension sags
- What you'll notice
- The rear of the car sits low, especially after being parked, or the air compressor runs often.
- Why it happens
- On cars with rear air suspension, the rubber air springs crack and leak with age.
- What to do
- Replace the leaking air springs, or have a shop install a coil spring conversion kit, which many owners choose.
Alternator failure
- What you'll notice
- A battery or charging light, dim lights, a dead battery, or stalling in traffic.
- Why it happens
- The alternator wears out with mileage, and owners report replacing it on many cars.
- What to do
- Have the charging system tested. A failing alternator can leave you stranded, so replace it soon.
Gas pump keeps shutting off when refueling
- What you'll notice
- The pump nozzle clicks off over and over when filling the tank, making it hard to fill up.
- Why it happens
- The fuel tank vent or evaporative emissions parts become clogged or fail, so air cannot escape the tank while fueling.
- What to do
- Have the evaporative emission system and tank vent checked. Some cars need a new vent valve or canister.
Power window stops working from a broken regulator
- What you'll notice
- A window will not go up or down, moves slowly, or makes a grinding or popping noise.
- Why it happens
- The window regulator wears out or breaks.
- What to do
- Replace the regulator, and the motor too if it is weak.
Squealing or chirping from the belt idler or tensioner
- What you'll notice
- A squeal, chirp or rattle from the front of the engine, especially at startup.
- Why it happens
- The bearings in the belt idler pulley and tensioner wear out.
- What to do
- Have the pulleys spun by hand to find the noisy one. Replace it along with the belt if the belt is worn.
Repair prices for your 2003 Mercury Grand Marquis
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace intake manifold and gaskets
- Rebuild or replace automatic transmission
- Replace ignition coil
- Replace blend door actuator (or blend door)
- Replace front ball joints
- Replace tie rod ends or idler/Pitman arm and align
- Replace in-tank fuel pump
- Replace evaporative emissions vent valve or canister
- Replace power window regulator
- Replace A/C compressor, accumulator and orifice tube, then recharge
- Replace rear air springs or install coil spring conversion
- Replace idler pulley or belt tensioner and belt
- Replace alternator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace lighting control module (recall 15V-861)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…