Your 2010 Mercury Marinerproblems, repair costs and recalls
What we've documented about the 2010 Mercury Mariner: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2010 Mercury Mariner
8 documented issues apply to 2010, most serious first.
Transmission stops working or goes into limp mode
- What you'll notice
- The transmission slips, will not shift, drops into a reduced-power limp mode, or stops moving the vehicle.
- Why it happens
- Owners of 2009-2011 Mariners, including the hybrid, report transmission failures, usually from about 60,000 to 110,000 miles.
- What to do
- Have the codes read and the fluid checked as soon as shifting changes. Ask a dealer about software updates for your VIN before agreeing to a replacement.
Electric power steering assist cuts out (recall)
- What you'll notice
- A power steering warning appears and the steering suddenly becomes very heavy, often while turning at low speed.
- Why it happens
- A torque sensor in the electric power steering can stop reading the driver's input and shut off the assist. Ford recalled 2008-2011 Mariners built from August 2006 to September 2010, and steering failures are the most-reported Mariner problem.
- What to do
- Check your VIN for recall 14V-284. If the assist drops out, grip the wheel firmly, slow down and pull over. Have it fixed before regular driving.
Free under recall 14V-284. Owners who paid report a costly repair.
Throttle body failure cuts engine power
- What you'll notice
- A wrench light or a message to pull over, then the engine loses power or stalls, sometimes at highway speed. It may run normally after a restart and then do it again.
- Why it happens
- The electronic throttle body's motor and sensor wear out, so the engine computer can no longer trust it and cuts power. Owners most often fix it with a new throttle body.
- What to do
- Have the throttle body tested and replaced; losing power in traffic is dangerous. Ask a dealer whether any Ford extended coverage applies to your VIN.
Fuel pump module can crack and leak (recall)
- What you'll notice
- A gasoline smell, especially after filling up, or fuel wetness near the rear of the vehicle.
- Why it happens
- The fuel delivery module on top of the tank could crack and leak fuel. Ford recalled 3.0L V6 Mariners built from February 2009 to December 2010.
- What to do
- Check your VIN for recall 16V-777. Avoid topping off the tank and have any fuel smell checked right away.
Free under recall 16V-777.
Hybrid brake system warning and brake failure
- What you'll notice
- ABS, brake and 'regen brakes disabled' warnings, a 'service brake system' message, dragging brakes, or the brakes failing to stop the vehicle as expected.
- Why it happens
- The hybrid uses an electronically controlled brake system that blends regenerative and friction braking. Owners report failures of its hydraulic control unit, which are costly to fix.
- What to do
- Do not drive with brake warnings on. Have the brake system diagnosed by a dealer or hybrid specialist right away.
Rust in rear wheel wells and quarter panels
- What you'll notice
- Blistering paint and rust around the rear wheel openings and lower rear doors.
- Why it happens
- Owners report rust starting around the rear wheel wells at about 80,000-90,000 miles.
- What to do
- Have rust treated early while it is still on the surface. Rinse salt from the wheel wells in winter.
Knock or pop from the steering column when turning
- What you'll notice
- A knock, pop or clunk felt in the steering wheel when turning, especially at low speed or when parking.
- Why it happens
- Looseness in the steering shaft or its U-joint coupling. RepairPal lists this as the most common Mariner problem.
- What to do
- Have the steering shaft and coupling checked. It is usually a noise problem, but any looseness in the steering should be repaired.
A/C blows warm air
- What you'll notice
- The air conditioning blows warm or only slightly cool air, or works only some of the time.
- Why it happens
- Owners of 2009 and 2010 Mariners report A/C systems that stop cooling properly. Refrigerant leaks and compressor or clutch faults are the usual causes.
- What to do
- Have the system leak-tested and the compressor checked before paying for a recharge.
Repair prices for your 2010 Mercury Mariner
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with remanufactured unit
- Replace electronic throttle body
- Replace intermediate steering shaft
- Replace hybrid brake hydraulic control unit
- Repair rust and refinish rear wheel arch (one side)
- A/C leak repair and recharge
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace steering gear or torque sensor under recallNo charge if your vehicle is included
- Replace fuel delivery moduleNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…