Your 2007 Mercury Montereyproblems, repair costs and recalls
What we've documented about the 2007 Mercury Monterey: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Mercury Monterey
11 documented issues apply to 2007, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Revs climb but the van barely moves, shifts stop, or it suddenly won't go forward or reverse. ABS and traction control lights sometimes come on at the same time.
- Why it happens
- The four-speed automatic shared with the Ford Freestar is this van's biggest weak spot. Torque converter and internal failures are common, often between 50,000 and 100,000 miles, and some vans failed again after repair.
- What to do
- If it slips or loses drive, get off the road safely and don't keep driving it. Have the codes read and the fluid checked, and ask a Ford dealer to confirm the torque converter recall was done before paying for a rebuild.
Third-row seat anchor can rust loose (recall)
- What you'll notice
- The third-row seat may rattle, feel loose, or not latch firmly in place.
- Why it happens
- Under recall 13V-081, the sheet metal that holds the third-row seat latch strikers can rust through, so the seat may come unlatched in a rear crash.
- What to do
- Don't seat anyone in the third row if it feels loose. Check your VIN for this recall and have it repaired free at a Ford dealer.
Free at a Ford/Lincoln dealer if still open; ask the dealer to check your VIN for open recalls.
Fuel connection can leak (recall)
- What you'll notice
- A raw gasoline smell, or fuel dripping under the van.
- Why it happens
- Recall 06E-056 covered a fuel connection that could fail and leak fuel, creating a fire risk near an ignition source.
- What to do
- If you smell gasoline, don't drive the van; have it towed. Check your VIN for open recalls.
Free at a Ford/Lincoln dealer if still open; ask the dealer to check your VIN for open recalls.
Engine computer damaged by water leaks
- What you'll notice
- Flickering dash lights, radio or A/C cutting out, stalling, a limp-mode speed limit, or no reverse, often during or after rain. A camshaft sensor code may appear.
- Why it happens
- On this van and its twin, the Ford Freestar, water can get past the under-hood shield and onto the engine computer (PCM), corroding it. A new sensor alone usually doesn't fix it.
- What to do
- If it acts up in rain, have the PCM area checked for water. Fix the water shield or leak at the same time as any PCM replacement, or it can come back.
Misfire from clogged EGR ports in the intake
- What you'll notice
- Check engine light, rough idle or shaking, especially at higher mileage.
- Why it happens
- The small exhaust gas recirculation (EGR) passage in the intake manifold can plug with carbon sludge, so one or more cylinders run poorly. RepairPal lists it as the most common Monterey problem.
- What to do
- Have the misfire codes read. Ask the shop to check the EGR ports in the intake before replacing coils or injectors.
Misfire from a failing ignition coil pack
- What you'll notice
- Rough running, shaking at idle, loss of power and a flashing or steady check engine light. Wet weather can make it worse.
- Why it happens
- The 4.2L V6 uses one coil pack with plug wires. A cracked or damp coil pack, or worn plugs and wires, causes misfires.
- What to do
- A flashing check engine light means a severe misfire; drive gently and get it checked soon to protect the catalytic converter. Replacing plugs, wires and the coil pack together is common.
Squealing camshaft synchronizer
- What you'll notice
- A screech or squeal from the engine that rises with RPM. Some vans also stall at stops.
- Why it happens
- The camshaft synchronizer, which drives the cam position sensor, wears its internal bearing. If it fails it can also leak oil.
- What to do
- Have the noise pinned down with a stethoscope. Replace the synchronizer soon; a failed one can cause stalling and a no-start.
Alternator stops charging
- What you'll notice
- Battery light on, dim lights, a dead battery, or the van stalling.
- Why it happens
- The alternator is one of the most common repairs reported on these vans past about 100,000 miles.
- What to do
- Have the charging system tested before buying a new battery. If the battery light comes on while driving, head straight to a shop.
A/C compressor fails
- What you'll notice
- The A/C blows warm, the compressor clutch doesn't engage, or there is a grinding noise with the A/C on.
- Why it happens
- Owners report A/C compressor replacements, sometimes after the compressor belt broke.
- What to do
- Have the A/C pressures and clutch checked. If a compressor fails internally, the system should be flushed and the drier replaced too.
Power steering leak or hard steering
- What you'll notice
- Whining while turning, fluid spots under the front, or steering that feels heavy or slow to return to center.
- Why it happens
- Owners report power steering pump leaks and, in some cases, pump and steering rack replacement.
- What to do
- Check the power steering fluid level. If it keeps dropping or steering gets heavy, have the pump, hoses and rack inspected.
Blower fan only works on high
- What you'll notice
- The heater and A/C fan only blows on the highest setting; lower speeds don't work.
- Why it happens
- On vans with manual fan controls, the blower motor resistor fails, leaving only the high-speed circuit working.
- What to do
- This isn't urgent. Replace the blower resistor, and check the blower motor if it is noisy or draws too much current.
Repair prices for your 2007 Mercury Monterey
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace transmission with rebuilt or used unit
- Replace and program engine computer (PCM); repair water shield
- Clean intake EGR passages (upper intake removed)
- Replace ignition coil pack, spark plugs and wires
- Replace camshaft synchronizer
- Replace blower motor resistor
- Replace alternator
- Replace A/C compressor, drier and recharge
- Replace power steering pump
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Reinforce or replace third-row seat striker mountsNo charge if your vehicle is included
- Inspect and repair fuel connectionNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…