Your 1998 Mercury Sableproblems, repair costs and recalls
What we've documented about the 1998 Mercury Sable: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1998 Mercury Sable
16 documented issues apply to 1998, most serious first.
Transmission stops engaging Drive or Reverse
- What you'll notice
- The car suddenly acts like it is in Neutral and coasts, the engine revs without moving, shifts slip or flare, or the overdrive light flashes. Park usually still works.
- Why it happens
- The four-speed automatic in these years is the Sable's biggest weak spot. Torque converter, pump and internal shaft failures are common between about 60,000 and 160,000 miles.
- What to do
- If it slips or won't engage, stop driving and get it towed to avoid more damage. Get a transmission shop diagnosis; a rebuild is the usual fix.
Timing chain tensioner failure
- What you'll notice
- A rattle from the front of the engine, misfires, or the engine won't run.
- Why it happens
- The timing chain tensioner can wear out, letting the chain slap.
- What to do
- Have any rattle diagnosed quickly; a jumped chain can damage the engine.
Rear coil spring breaks
- What you'll notice
- A clunk from the back over bumps, a rear corner sitting low, or the tire rubbing.
- Why it happens
- Rear springs rust and crack with age, often along with worn rear struts.
- What to do
- Have the rear suspension inspected; replace springs in pairs.
Worn struts and strut mounts
- What you'll notice
- Bouncy ride, clunking over bumps, front end noise when turning, or uneven tire wear.
- Why it happens
- Struts and their upper mounts are the most-reported repair on the Sable in TrueDelta's survey. On 2008–2009 cars, front strut mounts can clunk early.
- What to do
- Have the struts and mounts checked. Replacing them as complete assemblies is often simplest.
Worn ball joints and tie rod ends
- What you'll notice
- Loose or wandering steering, clunks over bumps, or tires wearing on the edges.
- Why it happens
- Ball joints and inner and outer tie rod ends wear with mileage on these cars.
- What to do
- Have the front end checked for play and get an alignment after repairs.
Misfire from a failed ignition coil
- What you'll notice
- Check engine light (sometimes flashing), rough idle, shaking, or hesitation when accelerating.
- Why it happens
- Ignition coils fail with age. The DOHC and 3.5L engines use one coil per cylinder; the pushrod V6 uses a coil pack.
- What to do
- Have the misfire codes read and the coil and plugs checked. Avoid hard driving with a flashing light.
Fuel pump failure
- What you'll notice
- Cranks but won't start, stalls, or sputters and loses power at speed.
- Why it happens
- The in-tank fuel pump wears out; owners report replacements from about 68,000 miles on.
- What to do
- Check whether you hear the pump hum at key-on and have fuel pressure tested.
Alternator stops charging
- What you'll notice
- Battery light on, dim lights, dead battery or stalling.
- Why it happens
- Alternators wear out on these cars, and rebuilt units have been unreliable for some owners.
- What to do
- Have the charging system tested and buy a quality replacement.
Water pump leaks coolant
- What you'll notice
- Coolant drips at the front of the engine, a sweet smell, low coolant, or poor heat.
- Why it happens
- The water pump seal wears. On some pushrod V6 engines the timing cover around the pump also warps.
- What to do
- Watch the temperature gauge and replace the pump before it overheats the engine.
A/C compressor or clutch fails
- What you'll notice
- A/C blows warm, a grinding or rattling noise when the A/C is on.
- Why it happens
- The compressor clutch and bearing or the compressor itself wear out.
- What to do
- Have the system diagnosed before recharging; a failed clutch alone is cheaper than a full compressor.
Clicking when turning from a worn CV axle
- What you'll notice
- Clicking or popping when turning sharply, or grease thrown inside the wheel from a torn boot.
- Why it happens
- The CV joint boots tear and the joint wears once dirt gets in.
- What to do
- Replace the axle once it clicks; it can eventually break.
Stalling or rough idle from a dirty idle air valve
- What you'll notice
- Hard starting when cold, stalling at stops or idle, an idle that hunts up and down, or hesitation when accelerating.
- Why it happens
- The idle air control (bypass) valve gets clogged with carbon or fails. RepairPal lists it as the most commonly reported Sable problem.
- What to do
- Have the valve cleaned or replaced, and check for vacuum leaks at the same time.
Clunking from sway bar end links
- What you'll notice
- A rattle or knock from the front or rear over small bumps.
- Why it happens
- Stabilizer bar end links and bushings wear out; they are among the most common repairs on these cars.
- What to do
- Have the links checked; it is a low-cost fix.
Clicking behind the dash or temperature stuck
- What you'll notice
- Clicking or tapping behind the dash, or air that stays hot or cold no matter the setting.
- Why it happens
- The small motor that moves the blend door wears its plastic gears.
- What to do
- Have the actuator tested and replaced.
Rear drum brake wheel cylinder leaks
- What you'll notice
- Brake fluid inside the rear wheels, a soft pedal, or grabbing rear brakes.
- Why it happens
- The rear wheel cylinders on drum-brake versions start to leak with age.
- What to do
- Have the rear brakes inspected and replace both cylinders with new shoes if fluid has soaked them.
Oil pan gasket leak
- What you'll notice
- Oil spots under the engine, a burning oil smell, or smoke when oil drips onto the exhaust.
- Why it happens
- The oil pan gasket hardens and leaks with age.
- What to do
- Keep the oil topped up and have the gasket replaced, since oil on the exhaust can be a fire risk.
Repair prices for your 1998 Mercury Sable
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace automatic transaxle
- Replace rear coil springs (pair)
- Replace front struts as complete assemblies (pair)
- Replace sway bar end links (pair)
- Replace tie rod ends and ball joint (one side)
- Replace ignition coil (one) and spark plugs
- Replace blend door actuator
- Replace fuel pump module
- Replace alternator
- Replace water pump
- Replace A/C compressor and recharge
- Replace rear wheel cylinders and brake shoes
- Replace front CV axle (one side)
- Replace timing chain, guides and tensioner
- Replace idle air control valve
- Replace oil pan gasket
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…