Mitsubishi i-MiEVproblems, repair costs and recalls
Problems reported across 2012–2017. Pick your model year below to see what applies to your vehicle.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
22 documented issues across all years, most serious first.
Brake assist can fail from water in the vacuum pump (recall)
- What you'll notice
- The brake pedal suddenly feels hard and the car takes much longer to stop. A brake warning light or a loud warning tone may come on.
- Why it happens
- Electric cars have no engine vacuum, so a small electric pump powers the brake booster. Water can get into this pump, corrode it and make it quit. Mitsubishi recalled every 2012-2017 US i-MiEV (NHTSA campaign 19V804).
- What to do
- If the pedal goes hard, press much harder and pull over safely. Ask the dealer to confirm the recall applies to your VIN and have the pump replaced free before driving much more.
Free under the recall. Ask the dealer to check your VIN for open recalls.
Brake vacuum pump can stop from software or road salt (recall)
- What you'll notice
- The brake pedal gets hard and stopping distances grow. A warning light and tone may come on.
- Why it happens
- On cars built through March 2014, the pump's control software or corrosion from road salt could stop the brake vacuum pump. Dealers reprogram the controller, replace the pump or both (NHTSA campaign 14V522).
- What to do
- Check your VIN for this recall as well as the later pump recall. Both repairs are free.
Free under the recall. Ask the dealer to check your VIN for open recalls.
Brake vacuum pump may fail early (recall)
- What you'll notice
- Less brake assist, a firmer pedal and longer stops.
- Why it happens
- Some vacuum pumps fitted to 2012 cars built December 2011 to September 2012 could fail inside. Mitsubishi replaced them under NHTSA campaign 13V031.
- What to do
- Check your VIN for open recalls. Several brake pump recalls cover this car, and all are free.
Free under the recall. Ask the dealer to check your VIN for open recalls.
Passenger airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. In a crash, the front passenger airbag inflator can burst and throw metal pieces into the cabin.
- Why it happens
- These Takata inflators break down after years of heat and humidity. The 2012 and 2014 cars are in campaign 17V022, and the 2016-2017 cars are in campaign 17V793.
- What to do
- This is urgent. Ask the dealer to confirm the recall applies to your VIN and get the free inflator replacement. Until then, keep passengers out of the front seat.
Free under the recall. Ask the dealer to check your VIN for open recalls.
Airbag impact sensor may delay deployment (recall)
- What you'll notice
- The SRS airbag warning light comes on.
- Why it happens
- Resistance can build up in the impact sensors on cars built October 2011 to September 2012. That can delay the front airbags, or stop the side and curtain airbags while the light is on (NHTSA campaign 15V594).
- What to do
- Check your VIN and get the sensors replaced free. Don't ignore an airbag light on this car.
Free under the recall. Ask the dealer to check your VIN for open recalls.
Airbags may switch off from sensor mismatch (recall)
- What you'll notice
- The SRS airbag warning light stays on.
- Why it happens
- On early 2012 cars built in late 2011, some airbag sensors didn't match the system's self-check software, which could switch off the front and side airbags (NHTSA campaign 12V372).
- What to do
- Check your VIN for this recall and have the sensors replaced free.
Free under the recall. Ask the dealer to check your VIN for open recalls.
Car won't charge, with 12-volt and power warning lights
- What you'll notice
- The car stops charging from a normal plug, or charges for a moment and quits. The 12-volt battery light and the power system warning light come on, and the small 12-volt battery runs down.
- Why it happens
- Capacitors inside the on-board charger can short and blow a high-voltage fuse, which also takes out the converter that keeps the 12-volt battery charged. Mitsubishi extended coverage on this charger and converter to 10 years from sale with unlimited miles.
- What to do
- Don't keep trying to charge. Ask a Mitsubishi EV dealer whether the 10-year coverage still applies to your VIN. If not, ask about a rebuilt or used charger, since a new one is expensive.
Main battery won't fully charge or a cell fails
- What you'll notice
- The battery gauge won't reach all 16 bars after a full charge, range falls sharply, or the turtle light comes on around half charge.
- Why it happens
- A weak or failed cell inside the main lithium-ion pack. Mitsubishi extended main battery coverage to 10 years or 100,000 miles on 2012 cars when the pack can't charge to full capacity.
- What to do
- Ask a Mitsubishi EV dealer to test the pack and check whether your car is still inside the battery coverage. A replacement pack outside coverage is very costly.
Turtle mode from motor control unit fault (campaign)
- What you'll notice
- Power drops sharply and the turtle light comes on. In the worst case the car won't start or charge.
- Why it happens
- Some parts inside the motor control unit were not built to spec, which can make its voltage unstable. Mitsubishi ran service campaign SC-15-002 to replace the unit free.
- What to do
- If power drops, move to a safe place. Ask a dealer whether SC-15-002 was completed on your VIN.
Free under service campaign SC-15-002 if your VIN is included.
Won't go into READY from inverter failure
- What you'll notice
- The car won't switch to READY and can't be driven, even with a good 12-volt battery.
- Why it happens
- A failure in the motor's power inverter (the motor control unit) can stop the car from starting. Owners report dealers taking weeks to diagnose it.
- What to do
- Rule out the 12-volt battery first. Then go to a Mitsubishi EV-certified dealer or EV specialist, and ask whether any campaign or extended coverage applies.
Weak 12-volt battery: won't go READY or warning lights
- What you'll notice
- The car won't switch to READY, beeps and whistles, or lights up many warning icons, including the turtle symbol. Wipers and screens may be slow or dim.
- Why it happens
- The small 12-volt battery powers the computers that start the car. The factory battery is a basic flooded type, and it drains if the car sits unplugged. Low voltage at start-up can confuse the car's modules.
- What to do
- Test or charge the 12-volt battery first; it's the cheapest fix for many warning lights. Use a battery maintainer if the car will sit more than a week, and consider a better-quality replacement.
Driving range drops as the main battery ages
- What you'll notice
- The car goes noticeably fewer miles on a full charge than it used to, especially in cold weather or with the heater on.
- Why it happens
- The i-MiEV started with a small 16 kWh battery and about 62 miles of range, so any capacity loss is very noticeable. Older 2012 packs often hold far less than new. Later cars got improved cells that age better.
- What to do
- Have the battery capacity read with a scan tool or at a dealer, especially before buying used. Plan trips around today's real range, and use preheating while plugged in during winter.
Won't go into READY in extreme cold
- What you'll notice
- In very cold weather, around -13 F, the car won't switch to READY.
- Why it happens
- The EV control relay can freeze. Mitsubishi bulletin TSB-12-54-016 introduced an improved relay.
- What to do
- Park in a garage or keep the car plugged in during deep cold. If it happens, ask a dealer about the improved relay.
Main battery cooling fan failure
- What you'll notice
- A warning light, reduced power, or less charging speed; you may not hear the battery fan running.
- Why it happens
- The main battery is air-cooled by a fan. Mitsubishi updated its troubleshooting for failed battery fans on 2012-2013 cars (TSB-13-54-003).
- What to do
- Have a dealer read the codes and check the fan. Avoid fast charging in hot weather until it's fixed.
Rust on battery mounting bolts and ground points (campaign)
- What you'll notice
- Rust under the car around the main battery bolts and frame, often in salt-belt states.
- Why it happens
- The underbody has little rust protection. Mitsubishi ran service campaign SC-14-003 to inspect and treat rust on the battery bolts and ground connections.
- What to do
- Ask a dealer whether SC-14-003 was done. Wash salt off the underside in winter and have the battery mounts checked before buying used.
Free under service campaign SC-14-003 if your VIN is included.
Front seat belt frays at the recline lever
- What you'll notice
- The front seat belt webbing looks frayed or cut near the bottom of the seat.
- Why it happens
- The belt can get trapped under the seat recline lever, and the lever's edge rubs it. Mitsubishi's bulletin replaces the belt and fits a new lever on cars built before April 2017.
- What to do
- A frayed belt may not hold in a crash. Have it replaced right away and ask a dealer about the bulletin.
Weak or no cabin heat
- What you'll notice
- The heater blows cool air while driving, or works only after preheating. A code B1108 may be stored.
- Why it happens
- The car uses an electric heater to warm coolant. If the heater element weakens or isn't sensed warming up, the system shuts it off. Mitsubishi issued bulletins for the B1106 and B1108 codes.
- What to do
- Check the coolant level first. Have a shop read the A/C and heater codes; a failing heater unit usually has to be replaced. Clear frost from the windows before driving.
Air conditioning stops working
- What you'll notice
- The A/C blows warm air or won't turn on.
- Why it happens
- Owners report failures of the electric A/C unit on 2012 cars. The system is also used to cool the battery during fast charging, so a fault matters beyond comfort.
- What to do
- Get an A/C diagnosis. Repairs to the electric compressor can be costly, so get a quote before deciding.
Battery gauge doesn't show fully charged
- What you'll notice
- After a full charge, the battery gauge still doesn't show full.
- Why it happens
- Mitsubishi issued service bulletins (TSB-13-54-002 and its revision) with added troubleshooting steps for this gauge reading on 2012-2014 cars.
- What to do
- Try a complete Level 2 charge and note whether it stops early. If it keeps happening, have a dealer follow the bulletin to check the battery and charger.
Won't charge on some Clipper Creek chargers (campaign)
- What you'll notice
- Charging won't start or stops when using certain Clipper Creek home or public chargers.
- Why it happens
- The car's EV computer software didn't communicate properly with these chargers. Mitsubishi campaign SC-13-001 updated the software.
- What to do
- Ask a dealer whether the update was done. Try another charger to confirm the car itself charges.
Free under service campaign SC-13-001 if your VIN is included.
Quick charging stops or won't start
- What you'll notice
- DC fast charging (CHAdeMO) won't start or quits after about two minutes, especially on ABB chargers.
- Why it happens
- Software in the EV computer and battery management unit could flag a false fault with some quick chargers. Mitsubishi released reprogramming bulletins (TSB-18-54-007 and TSB-19-54-001).
- What to do
- Ask a dealer to apply the software updates. Level 2 charging is not affected.
Heated seat stops working
- What you'll notice
- One of the heated seats no longer warms up.
- Why it happens
- Owners report the seat heater element or its controls failing.
- What to do
- Check the fuse first, then have the seat heater tested.
Repair prices for your Mitsubishi i-MiEV
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace on-board charger and DC-DC converter
- Replace 12-volt battery
- Main battery capacity check
- Main battery diagnosis
- Battery and charging diagnosis
- Replace motor control unit (inverter)
- No-start diagnosis
- Battery fan diagnosis
- Charging diagnosis and software update
- Heater diagnosis
- A/C diagnosis
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace brake vacuum pumpNo charge if your vehicle is included
- Reprogram pump controller and/or replace vacuum pumpNo charge if your vehicle is included
- Replace passenger airbag inflatorNo charge if your vehicle is included
- Replace airbag impact sensorsNo charge if your vehicle is included
- Replace airbag sensorsNo charge if your vehicle is included
- Replace motor control unit under campaignNo charge if your vehicle is included
- Inspect and treat rust under campaignNo charge if your vehicle is included
- EV computer software update under campaignNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.