Mitsubishi Mirageproblems, repair costs and recalls
Problems reported across 1997–2024. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
21 documented issues across all years, most serious first.
CVT hesitation, shudder or whine
- What you'll notice
- The car hesitates or lunges when pulling away, jerks at low speed, whines, or feels like it is slipping. In bad cases the transmission stops changing ratio properly.
- Why it happens
- The Mirage uses a continuously variable transmission (CVT). Owners report hesitation, shift shock, slipping and failures, and Mitsubishi issued bulletins to reprogram the CVT computer and update CVT service procedures.
- What to do
- Have the CVT fluid level and condition checked and ask a dealer about software updates. Change the CVT fluid on schedule. A CVT that slips or whines loudly usually needs replacement, so check warranty coverage first.
Airbags may be switched off by an SRS computer error (recall)
- What you'll notice
- The airbag warning light may come on, and the airbags might not deploy in a crash.
- Why it happens
- Vibration from rough roads or a flat tire could make the airbag computer think its own sensor had failed, so it disabled the airbags. Dealers reprogram the computer (campaign 17V686).
- What to do
- Check your VIN for open recalls and get this done; it is free.
Airbag impact sensor can delay deployment (recall)
- What you'll notice
- The SRS airbag light may come on.
- Why it happens
- High resistance in an airbag impact sensor on early 2014 Mirages could delay the front airbags or stop the side and curtain airbags. Dealers replace the sensors (campaign 15V594).
- What to do
- Check your VIN for open recalls.
Wiring connector under driver carpet can corrode (recall)
- What you'll notice
- Often no symptoms; an airbag light may come on. Wet carpet near the driver's left foot is a clue.
- Why it happens
- Water and road salt can soak through the carpet and corrode a connector behind the kick panel, which could delay the front airbags. Dealers replace corroded connectors and add a waterproof sheet (campaign 15V815).
- What to do
- Have the recall done, and dry out any wet carpet promptly.
Automatic transmission harsh shifts or slipping
- What you'll notice
- Hard or violent shifts, slipping, the transmission dropping into neutral, or gears failing, sometimes at highway speed.
- Why it happens
- The automatic transmission is the most common complaint on the 1997-2002 Mirage. Owners report repeated failures.
- What to do
- Check the fluid level and condition. If it slips or shifts violently, avoid highway driving until it is diagnosed.
Crankshaft pulley bolt can loosen (recall)
- What you'll notice
- A wobbling pulley, squealing belts, and in the worst case the pulley falling off and loss of power steering.
- Why it happens
- On Mirages with the 1.5L engine, the crankshaft pulley bolt could loosen. Dealers installed an improved bolt or retightened it (campaign 00V311).
- What to do
- Have a dealer confirm the recall was done. Any wobbling pulley needs attention right away.
Crankshaft pulley bolt can loosen on 2000 models (recall)
- What you'll notice
- A wobbling pulley, belt noise, and possible loss of power steering if the pulley comes off.
- Why it happens
- The crankshaft pulley bolt on some 2000 Mirages could loosen. Dealers checked and retightened it and replaced damaged parts (campaign 01V340).
- What to do
- Have a dealer confirm the recall was done.
Brake booster vacuum valve can stick (recall)
- What you'll notice
- The brake pedal feels hard and the car takes more effort to stop.
- Why it happens
- A badly made vacuum check valve in the hose to the brake booster could stick. Dealers replaced the hose (campaign 97V179).
- What to do
- Have a dealer confirm the recall was done. A hard brake pedal needs immediate attention.
Airbags not deploying in crashes
- What you'll notice
- Owners report airbags that stayed closed in crashes, or in a few cases deployed without a crash.
- Why it happens
- Airbag complaints are among the most common NHTSA reports for the 1997-2002 Mirage. Sensors and wiring age and can fail.
- What to do
- If the airbag light is on, have the system scanned. Check your VIN for open recalls.
Front brakes wear out early or calipers stick
- What you'll notice
- Grinding or squealing brakes, a burning smell, pulsing in the pedal, or pads and rotors needing replacement after only 10,000-30,000 miles.
- Why it happens
- Premature front brake wear is the most-reported problem on the 2015 Mirage. Some owners found sticking or seized calipers that kept wearing out new pads and rotors.
- What to do
- Have the brakes inspected at every oil change. If pads wear out quickly, ask the shop to check that the calipers and slide pins move freely.
Pulling, drifting and fast front tire wear
- What you'll notice
- The car drifts or pulls to one side, the steering wheel sits off-center, or the front tires wear out early. Owners also notice it gets pushed around by crosswinds.
- Why it happens
- Mitsubishi issued repeated dealer notices on wheel alignment checks for Mirage pulling and drifting complaints. Light weight and narrow tires make it more sensitive to wind and road crown.
- What to do
- Check tire pressures first, then get an alignment. If it still pulls, ask the dealer to follow Mitsubishi's alignment bulletin.
Forward collision mitigation warning or not working
- What you'll notice
- A forward collision or "system malfunction" warning comes on, or the automatic emergency braking does not warn or brake for cars or people ahead.
- Why it happens
- Owners of 2021 and newer Mirages, which added forward collision mitigation, report the system faulting or not working, and dealers sometimes cannot find the cause.
- What to do
- Keep the windshield area in front of the camera and the front sensor clean. Have the codes read by a dealer, and don't rely on the system until it is fixed.
HID headlights can be mis-aimed (recall)
- What you'll notice
- Poor night vision or other drivers flashing their lights at you.
- Why it happens
- On 2017 Mirages with HID headlights, the horizontal aiming lock clips may not be secured, so the beams can be knocked out of aim. Dealers secure the clips (campaign 16V675).
- What to do
- Check the recall status and have the headlight aim checked.
Mirage G4 airbag warning light (recall)
- What you'll notice
- The SRS airbag warning light comes on.
- Why it happens
- Certain 2017-2018 Mirage G4 sedans built through November 2017 were recalled for a possible SRS warning lamp fault (campaign 19V330).
- What to do
- Check your VIN for open recalls and schedule the free repair.
Cold-start engine knocking noise (service campaign)
- What you'll notice
- A knocking or rattling noise from the engine for a short time after a cold start.
- Why it happens
- Mitsubishi ran a service campaign (SC-16-001) to reflash the engine computer for a cold-start engine noise; some engines were replaced, and replacement engines were back-ordered for a time.
- What to do
- Ask a Mitsubishi dealer whether your car had the campaign done. If the noise continues, have it checked while the engine is cold.
Covered by Mitsubishi campaign SC-16-001.
Stalling at low speed in hot weather
- What you'll notice
- The engine stalls when slowing down or idling, mostly when it is hot outside.
- Why it happens
- An overly rich air-fuel mixture could stall the engine. Mitsubishi released a bulletin to reprogram the engine computer and check a PCV hose that could come off (TSB-15-13-001).
- What to do
- Ask a dealer to check for the engine computer update and inspect the PCV hose.
Clutch wears out quickly (manual)
- What you'll notice
- The clutch slips, the engine revs without the car speeding up, or the pedal feels different. Some owners needed a clutch around 20,000 miles.
- Why it happens
- Clutch wear is reported early on manual-transmission Mirages, often in stop-and-go driving.
- What to do
- Avoid riding the clutch and holding the car on hills with it. If it slips, replace it before it leaves you stranded.
Stalling or no-start from a failed distributor
- What you'll notice
- The engine cranks but won't start, or it cuts out while driving and may not restart.
- Why it happens
- RepairPal lists internal distributor faults as a common no-start cause on the older Mirage, and NHTSA complaints describe sudden stalling.
- What to do
- Have the ignition system checked for spark. A failed distributor is usually replaced as a unit.
Door hinges crack and doors sag
- What you'll notice
- Doors creak, sag, drop when opened, or are hard to close; in bad cases the hinge breaks.
- Why it happens
- Owners report door hinges cracking or collapsing. CarComplaints lists this on the 2001 Mirage, sometimes needing a new door.
- What to do
- Lubricate the hinges and have sagging doors checked early, before the hinge or door mount cracks.
Grinding brakes and warped rotors
- What you'll notice
- Grinding or squealing when stopping, or a pulsing pedal and shaking steering wheel.
- Why it happens
- Front pads and rotors wear and warp early on these cars, according to owner complaints and RepairPal.
- What to do
- Have the pads and rotors measured and replace them together.
Rusted control arms and crossmember
- What you'll notice
- Clunking from the front suspension, wandering steering, or rust holes in the control arms.
- Why it happens
- In salt-belt states the front control arms and crossmember can rust through on these older cars.
- What to do
- Have the suspension inspected for rust at every oil change or inspection. Rusted-through arms must be replaced.
Repair prices for your Mitsubishi Mirage
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace CVT
- Front pads and rotors (plus calipers if sticking)
- Four-wheel alignment
- Reprogram engine computer (and reconnect PCV hose) per TSB 15-13-001
- Replace clutch kit
- Replace distributor
- Replace door hinges (or door if damaged)
- Front brake pads and rotors
- Replace front lower control arm (one side)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
- Free dealer service campaign (engine computer update)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.