Your 2000 Mitsubishi Montero Sportproblems, repair costs and recalls
What we've documented about the 2000 Mitsubishi Montero Sport: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Mitsubishi Montero Sport
11 documented issues apply to 2000, most serious first.
Automatic transmission overheats, slips or fails
- What you'll notice
- Harsh or late shifts, slipping, a transmission overheat warning, a burning smell or smoke, or the truck refusing to move in gear.
- Why it happens
- The 4-speed automatic is the most-reported failure on these trucks in NHTSA owner complaints. Heat is the main enemy, especially when towing, climbing or driving in four-wheel-drive low.
- What to do
- If the overheat light comes on, pull over and let it idle to cool. Check the fluid level and smell. Old, burnt fluid or slipping needs a transmission shop's diagnosis before it gets worse.
Crankshaft pulley bolt loosens and pulley comes off
- What you'll notice
- A wobble or knocking at the front of the engine, then a sudden loss of power steering and charging. In bad cases the belts and pulley fall off and the engine quits.
- Why it happens
- The bolt that holds the crankshaft pulley on the V6 can lose its tightness over time. Once it backs out, the pulley that drives the power steering pump and alternator works loose.
- What to do
- If you hear a knock at the front of the engine or the steering suddenly goes heavy, stop driving. Have a shop check the pulley and bolt; catching it early can save the crankshaft.
Frame and subframe rust-through
- What you'll notice
- Heavy flaking rust under the truck, holes in the frame rails, the truck pulling or wandering, or a failed safety inspection.
- Why it happens
- Owners in salt-belt states report frames and the rear subframe rotting through, sometimes with cracks. Road salt collects in the frame and rusts it from the inside.
- What to do
- Have the frame inspected on a lift, tapping suspect spots with a hammer. Serious frame rot is a safety problem and often costs more to fix than an older truck is worth.
Brake vacuum hose can burst (recall)
- What you'll notice
- A hard brake pedal and longer stopping distances if the hose fails.
- Why it happens
- The brake booster vacuum hose on 3.5L trucks did not meet the federal brake hose standard and could burst (NHTSA campaign 01V027).
- What to do
- Check the VIN for open recalls. If the pedal feels hard, have the vacuum hose and booster checked right away.
Front brakes wear fast and rotors warp
- What you'll notice
- A pulsing brake pedal or shaking steering wheel when stopping, squealing or grinding, and pads that need replacing well before 30,000 miles.
- Why it happens
- Many owners report short pad life and warped front rotors on these trucks. The brakes work hard on a heavy SUV and heat builds up in the rotors.
- What to do
- Have the pads and rotors measured. Replace rotors in pairs with quality parts, and check that the caliper slides move freely.
Worn tie rods and loose steering
- What you'll notice
- The truck wanders or pulls, the steering feels loose, the wheel shimmies, or the front tires wear unevenly. A tie rod that separates can cause a sudden loss of steering.
- Why it happens
- Front steering and suspension parts such as tie rod ends and the pitman arm wear with age and mileage. RepairPal lists worn front steering parts as a common problem for this SUV.
- What to do
- Have the front end checked for play, then replace worn parts and get an alignment. Don't ignore clunks or wandering.
Oil leaks and burning oil smell
- What you'll notice
- A burning oil smell after driving, oil spots under the truck, oil on the spark plug wires, or the engine using oil between changes.
- Why it happens
- Camshaft and valve cover seals harden with age and leak oil onto hot engine parts. Some high-mileage engines also burn oil, and a few owners report oil sludge from skipped oil changes.
- What to do
- Find where the oil is coming from and fix the seals or gaskets. Keep up with oil changes and check the level often.
Alternator failure and dead battery
- What you'll notice
- Battery light on, dim lights, a dead battery, or the alternator overcharging and blowing fuses.
- Why it happens
- Several owners report repeated alternator failures, sometimes several in a row, and battery damage from overcharging.
- What to do
- Have the charging system tested. Use a quality alternator and check the wiring and belt when replacing it.
Catalytic converter or oxygen sensor failure
- What you'll notice
- Check engine light, poor fuel economy, hesitation, a rotten-egg smell, or a failed emissions test.
- Why it happens
- High-mileage engines often fail oxygen sensors and catalytic converters. Burning oil or misfires speed up converter damage.
- What to do
- Have the codes read. Fix any misfire or oil burning first so a new converter doesn't fail too.
Windshield wiper motor stops working
- What you'll notice
- The wipers stop working, work only some of the time, or stall partway across the glass.
- Why it happens
- Owners report wiper motor burnout, especially after the wipers were frozen to the glass. A loose wiper linkage can cause the same symptom.
- What to do
- Free iced wipers before turning them on. Have the motor and linkage checked; driving in rain without wipers is dangerous.
A/C compressor failure
- What you'll notice
- The A/C blows warm air, or there is a grinding or squealing noise when it turns on.
- Why it happens
- Owners report A/C compressor failures, sometimes at low mileage.
- What to do
- Have the A/C system checked for leaks and compressor clutch operation before replacing parts.
Repair prices for your 2000 Mitsubishi Montero Sport
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with a used or remanufactured unit
- Replace crankshaft pulley and bolt, and inspect the crank nose and keyway
- Cut out and weld in frame repair sections
- Replace front brake pads and rotors
- Replace inner and outer tie rod ends and align
- Replace camshaft seals and valve cover gaskets
- Replace alternator
- Replace catalytic converter
- Replace A/C compressor, drier, and recharge
- Replace windshield wiper motor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a Mitsubishi dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…