Mitsubishi Monteroproblems, repair costs and recalls
Problems reported across 1996–2006. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
19 documented issues across all years, most serious first.
Crankshaft pulley bolt breaks or loosens
- What you'll notice
- Power steering suddenly goes heavy, warning lights come on, the battery stops charging, or the A/C quits. You may hear a wobble or knock from the front of the engine, and belts can come off.
- Why it happens
- The bolt that holds the crankshaft pulley can loosen or snap, letting the pulley wobble or fall off so it no longer drives the belts. RepairPal lists it as the most common Montero problem, and some owners report it coming back after a repair.
- What to do
- If steering goes heavy and lights come on at once, pull over safely. Have the pulley and bolt replaced with new parts torqued to spec, and have the crankshaft nose checked for damage.
Crankshaft pulley bolt may loosen (recall)
- What you'll notice
- A wobbling crank pulley, belt noise, or loss of power steering and charging.
- Why it happens
- On 1996 Monteros with the 3.0L V6, the crank pulley bolt could loosen and let the pulley fall off. Dealers tighten the bolt to spec and replace damaged bolts.
- What to do
- Ask a Mitsubishi dealer whether recall 00V311001 was done on your truck.
Free at a Mitsubishi dealer if the recall was never done.
Hydraulic brake booster failure
- What you'll notice
- A loud buzzing or chirping noise from under the hood, the ABS or brake light coming on, a hard pedal, or lost power assist so the truck is hard to stop.
- Why it happens
- These Monteros use an electric-hydraulic brake booster instead of a vacuum one. Its pump, accumulator or control parts wear out, and owners report loss of assist at higher mileage.
- What to do
- Treat a hard pedal or brake light as urgent and have the brake booster system diagnosed. Don't drive it if the pedal is hard or sinks.
Brake booster accumulator can leak gas (recall)
- What you'll notice
- A noise when braking, and the first brake press after the truck has been parked may get little or no power assist.
- Why it happens
- The nitrogen-filled accumulator on the hydraulic brake booster could be built wrong and slowly leak. Dealers install an improved accumulator. Some owners report their VIN was left out of the recall.
- What to do
- Have a dealer check recall 01V254001. If you have these symptoms and the recall doesn't apply, get the booster checked anyway.
Free at a Mitsubishi dealer if the recall was never done.
Automatic transmission not shifting properly
- What you'll notice
- Slow or delayed shifts, the engine flaring between gears, slipping in 2nd or 3rd, or the transmission dropping into neutral and not engaging.
- Why it happens
- Transmission shifting faults are the top reported 2001 Montero problem, averaging about 119,000 miles. Fluid leaks and internal wear are suspected causes.
- What to do
- Check the fluid level and look for leaks. Have the transmission codes read and the fluid serviced before damage gets worse.
Frame and underbody rust
- What you'll notice
- Heavy rust or holes on the frame, wheel wells or underbody. In bad cases the frame cracks.
- Why it happens
- Owners report frame rot and fractures on these trucks, especially in road-salt areas, past 90,000 miles or so.
- What to do
- Have the frame inspected on a lift, especially before buying. Severe frame rust can make the truck unsafe to drive.
Fuel tank valve can leak when parked uphill (recall)
- What you'll notice
- A gas smell or fuel dripping near the tank after filling up and parking nose-up on a warm day.
- Why it happens
- The fuel tank leveling valve might not seal when a full tank expands in the heat. Dealers replace the valve.
- What to do
- Avoid parking uphill on a full tank. Ask a dealer to check recall 04V319000.
Free at a Mitsubishi dealer if the recall was never done.
Fuel leaking from the tank area or pump hoses
- What you'll notice
- A raw gas smell or fuel dripping from under the rear of the truck.
- Why it happens
- Owners report fuel leaking from the hoses at the fuel pump, the fill pipe and rusted parts of the tank.
- What to do
- Don't ignore a fuel smell. Have the tank, pump hoses and filler neck inspected right away.
Driver airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. In a crash the driver airbag could rupture or not inflate correctly.
- Why it happens
- The driver airbag inflator can absorb moisture over time, which may cause it to burst or underinflate. Mitsubishi replaces the inflator for free.
- What to do
- Have a Mitsubishi dealer check recall 20V035000 right away.
Free at a Mitsubishi dealer if the recall was never done.
Front brake lines can chafe through (recall)
- What you'll notice
- The brake warning light comes on, the pedal feels low, or brake fluid leaks near the front wheels.
- Why it happens
- The front brake lines could rub against the edge of a hole in the inner fender until they wore pinholes. Dealers reposition or replace them.
- What to do
- Have a dealer check recall 98V220000 and inspect the front brake lines.
Free at a Mitsubishi dealer if the recall was never done.
Timing belt, tensioner or idler failure
- What you'll notice
- A chattering or whining noise from the front of the engine, or the engine suddenly quitting and not restarting.
- Why it happens
- These V6 engines use a timing belt, and the 3.5L and 3.8L are interference engines, so a broken belt can bend valves. Owners report noisy tensioners and idlers.
- What to do
- Replace the timing belt, tensioner and idler on schedule. Many owners use about 60,000 miles. Don't put off a belt-area noise.
Stalling at speed or when accelerating
- What you'll notice
- The engine dies while driving at highway speed, at low RPM or pulling away from a stop.
- Why it happens
- Several owners report stalling on these years. The cause varies, so stored codes are the best clue.
- What to do
- Have the codes read right after a stall and avoid highway driving until it is found.
Horn sounds by itself, especially in cold weather
- What you'll notice
- The horn honks on its own when it gets cold, when the wheel is turned or in the middle of the night, sometimes running the battery down.
- Why it happens
- A worn contact inside the steering wheel horn pad can short. Many owners pull the horn fuse to stop it.
- What to do
- Have the horn switch in the steering wheel inspected. Don't leave the horn fuse out longer than needed since you lose the horn.
Third-row seat may not latch because of cargo mat (recall)
- What you'll notice
- The folded third-row seat doesn't latch firmly.
- Why it happens
- The accessory cargo mat could get in the way of the third-row seat latches. Dealers trim the mat around the strikers.
- What to do
- Make sure the third-row seats latch firmly. Ask a dealer to confirm recall 98V205000.
Free at a Mitsubishi dealer if the recall was never done.
Front-end vibration and worn steering parts
- What you'll notice
- Shaking or shimmy in the steering wheel at highway speeds, the truck pulling to one side, loose steering or uneven tire wear.
- Why it happens
- Worn front suspension and steering parts, such as tie rods, ball joints, bushings and wheel bearings, are a commonly reported Montero problem.
- What to do
- Have the front end inspected and worn parts replaced, then get an alignment.
4WD, transfer case or ABS lights flashing
- What you'll notice
- The 4WD indicator and ABS lights flash, the transfer case warning light comes back on, or the drive mode gets stuck in AWD.
- Why it happens
- Owners report faults in the transfer case shift system and ABS sensors that set these warning lights.
- What to do
- Have the codes read for both the ABS and the 4WD system. Avoid shifting modes repeatedly until it is diagnosed.
Oil burning from leaking valve guides
- What you'll notice
- Blue smoke from the exhaust, especially at startup, and oil disappearing between changes.
- Why it happens
- The 3.5L and 3.8L V6 engines in these Monteros are known for leaking valve guides, which let oil into the cylinders.
- What to do
- Check the oil level often. Have a compression and leak-down test done if smoke or oil use gets worse.
Warped rotors and fast brake pad wear
- What you'll notice
- Pulsing brake pedal, grinding or squealing, or pads that wear out early.
- Why it happens
- Owners report the heavy truck wearing pads and warping rotors quickly.
- What to do
- Have the brakes inspected. Use quality pads and rotors and replace them as a set.
Passenger mirror doesn't give a wide enough view (recall)
- What you'll notice
- Limited view out of the passenger-side mirror.
- Why it happens
- Some passenger-side mirrors didn't meet the federal visibility standard. Dealers replace the mirror.
- What to do
- Ask a dealer whether recall 00V123002 applies.
Free at a Mitsubishi dealer if the recall was never done.
Repair prices for your Mitsubishi Montero
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace crankshaft pulley (harmonic balancer) and bolt
- Replace hydraulic brake booster / ABS hydraulic unit
- Replace front control arm with bushings and ball joint
- Replace ABS control module
- Replace valve stem seals (heads stay on; timing belt and camshafts removed)
- Replace timing belt, tensioner and idler
- Front brake pads and rotors
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Tighten or replace crank pulley bolt (recall 00V311001)No charge if your vehicle is included
- Install improved accumulator (recall 01V254001)No charge if your vehicle is included
- Replace fuel tank leveling valve (recall 04V319000)No charge if your vehicle is included
- Replace driver airbag inflator (recall 20V035000)No charge if your vehicle is included
- Trim cargo mat around seat strikers (recall 98V205000)No charge if your vehicle is included
- Reposition or replace front brake lines (recall 98V220000)No charge if your vehicle is included
- Replace passenger mirror (recall 00V123002)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.