Your 2003 Mitsubishi Outlanderproblems, repair costs and recalls
What we've documented about the 2003 Mitsubishi Outlander: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Mitsubishi Outlander
6 documented issues apply to 2003, most serious first.
Front crossmember rust lets control arm detach (recall)
- What you'll notice
- Clunking from the front end over bumps, wandering steering, or in the worst case a front wheel that suddenly tucks in because the lower control arm has broken free.
- Why it happens
- Road salt rots the front crossmember where the lower control arms bolt on. Recall 16V-458 covers 2003-2006 Outlanders and 2007-2013 V6 models, and recall 20V-279 covers 2008-2013 Outlanders, in salt-belt states.
- What to do
- Check your VIN for open recalls. A dealer will inspect the crossmember and either seal it against rust or replace it free. If you hear clunks from the front, get it inspected before driving far.
Free at a Mitsubishi dealer. Ask the dealer to check your VIN for open recalls.
Automatic transmission failure on early models
- What you'll notice
- Slipping, harsh or delayed shifts, flaring revs between gears, or no drive at all, usually past 100,000 miles.
- Why it happens
- The 4-speed automatic in the first-generation Outlander wears out internally. RepairPal has more than 100 owner reports, averaging about 116,000 miles.
- What to do
- Check the fluid level and condition. If it slips or won’t engage, stop driving it hard and get a transmission diagnosis; a rebuilt or used unit is the usual fix.
Balance shaft belt failure
- What you'll notice
- A rattle or slap from the front of the engine. If the belt breaks, the engine may run rough or suddenly die and refuse to restart.
- Why it happens
- The 2.4L engine has a small belt that drives the balance shafts. Old or poor-quality belts can break, and the pieces can get caught in the timing belt and knock the timing out, which can damage the valves.
- What to do
- Replace the balance shaft belt every time the timing belt is done, about every 60,000 miles, using a quality belt. If the engine dies suddenly, have it towed rather than cranking it repeatedly.
Rear suspension clunks and uneven tire wear
- What you'll notice
- Clunks or slapping noises from the rear over bumps, and choppy or uneven wear on the rear tires.
- Why it happens
- The rubber bushings in the rear lower control arms wear out, and the rear sway bar bushings and differential mounts can loosen. Often all three arms on a side need replacing, and rusted bolts may have to be cut out.
- What to do
- Have the rear suspension inspected and get an alignment after any arm replacement so the new tires don’t wear out early.
Valve cover gasket oil leak and misfire
- What you'll notice
- Oil seeping from the top of the engine, a burning oil smell, a check engine light or a rough-running misfire.
- Why it happens
- The valve cover gasket hardens with age and leaks oil, including into the spark plug tubes, where it can short out the ignition and cause misfires.
- What to do
- Replace the valve cover gasket and the spark plug tube seals, and clean any oil from the plug wells. Check the plugs and coils for oil damage.
Temperature control knob hard to turn
- What you'll notice
- The heater temperature knob gets stiff or sticks, making it hard to switch between hot and cold.
- Why it happens
- The knob and the heater door linkage it moves stiffen up over time. RepairPal lists well over 100 owner reports on these years, and Mitsubishi has issued a service communication on it.
- What to do
- Don’t force the knob or it may break. Have a shop check the knob and the linkage behind the dash and free up or replace the stuck part.
Repair prices for your 2003 Mitsubishi Outlander
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with rebuilt or used unit
- Replace timing belt and balance shaft belt
- Replace rear lower control arm(s) and align
- Replace valve cover gasket and spark plug tube seals
- Replace heater blend door kit per bulletin TSB-055-003 (instrument panel and heater case removed)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…