Your 2008 Mitsubishi Raiderproblems, repair costs and recalls
What we've documented about the 2008 Mitsubishi Raider: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2008 Mitsubishi Raider
14 documented issues apply to 2008, most serious first.
Transmission slips or gets stuck in second gear
- What you'll notice
- The truck won't shift past second gear, feels sluggish, revs high at highway speed, or slips between gears, sometimes with a check engine light.
- Why it happens
- The automatic can drop into a protective 'limp' mode that holds second gear. RepairPal has dozens of Raider reports, and updated engine/transmission computer software often helps. Mitsubishi also issued a 2007 bulletin for drivability problems fixed by reprogramming.
- What to do
- Check the transmission fluid level and condition, then have codes read. Ask a dealer about the computer software update before agreeing to a rebuild. Avoid long or heavy towing until it is fixed.
Misfire and lost power from a dropped valve seat
- What you'll notice
- A sudden misfire on one cylinder, rough running, a flashing check engine light, and noticeably less power.
- Why it happens
- On the 3.7L V6 and 4.7L V8, a valve seat pressed into the cylinder head can loosen and fall out, usually after the engine has run hot. The valve can then no longer seal, and the cylinder loses compression.
- What to do
- If the check engine light flashes, slow down and get off the road; a loose seat can wreck the engine if you keep driving. Ask for a compression or leak-down test. The fix is a rebuilt or replacement cylinder head.
Head gasket failure after overheating
- What you'll notice
- White exhaust smoke with a sweet smell, milky oil, coolant disappearing with no visible leak, or overheating.
- Why it happens
- The 4.7L V8 does not tolerate overheating well, and a head gasket is a common casualty of a cooling system failure.
- What to do
- Stop driving if the engine overheats. Have a cooling system pressure test and a combustion leak test done. Fixing the cooling problem that caused it is part of the repair.
Coolant leaks and overheating
- What you'll notice
- Coolant puddles or crust under the front of the truck, a low coolant tank, steam from under the hood, or a rising temperature gauge.
- Why it happens
- The water pump, thermostat, radiator, fan and hoses on these V6 and V8 engines wear with age. Because both engines are hurt badly by overheating, small leaks matter.
- What to do
- Check the coolant level when the engine is cold and watch the gauge. Pull over and shut off the engine if it runs hot. Have leaks fixed quickly to protect the cylinder heads.
Takata driver airbag inflator can rupture (recall)
- What you'll notice
- Usually no warning signs before a crash.
- Why it happens
- The driver's frontal airbag inflator can absorb moisture over time and rupture when it deploys, throwing metal fragments. Mitsubishi replaces it free, including bags already replaced once under an earlier recall.
- What to do
- Ask a Mitsubishi dealer to confirm the recall applies to your VIN and get it fixed as soon as possible. Owners report parts delays, so book early.
Takata passenger airbag inflator can rupture (recall)
- What you'll notice
- Usually no warning signs before a crash.
- Why it happens
- The passenger frontal airbag inflator can degrade and rupture when it deploys. The recall was expanded to cover 2006–2009 Raiders, and dealers replace the inflator free.
- What to do
- Ask the dealer to check your VIN for open recalls. Until it is fixed, avoid having anyone ride in the front passenger seat if possible.
Ticking noise and misfire from stuck lash adjusters
- What you'll notice
- A ticking or tapping noise from the top of the engine, rough idle or misfire.
- Why it happens
- The 3.7L V6 uses hydraulic lash adjusters that can stick when oil is old, sludgy or the wrong thickness.
- What to do
- Use the correct oil and change it on time. If ticking comes with a misfire, have a shop pinpoint the cylinder; replacing the stuck adjuster is the fix.
Rough idle and oil leaks from a clogged PCV valve
- What you'll notice
- Rough idle, hesitation, worse fuel economy, and new oil leaks from seals or gaskets.
- Why it happens
- The crankcase ventilation (PCV) valve on the 3.7L can gum up, which builds pressure inside the engine and helps form sludge.
- What to do
- Replace the PCV valve; the part is cheap, though it can be hard to reach. Change the oil afterward.
PCV system can freeze in extreme cold
- What you'll notice
- In very cold weather, oil leaks, rough running, or oil pushed out of seals after cold starts.
- Why it happens
- Mitsubishi issued a 2008 bulletin for the crankcase ventilation system freezing in extreme cold, which traps pressure in the engine.
- What to do
- If you live in a very cold area, ask a dealer about the PCV bulletin and any updated parts.
Shudder or harsh 1-2 and 2-3 shifts
- What you'll notice
- A shudder like driving over rumble strips at light throttle, or hard shifts from first to second or second to third.
- Why it happens
- Mitsubishi issued 2007 and 2008 bulletins for torque converter clutch shudder and harsh upshifts on these trucks.
- What to do
- Ask a dealer about the transmission bulletins. A fluid service or software update may fix it before the converter is damaged.
Water leak onto the passenger floor
- What you'll notice
- Wet carpet on the passenger side after rain or a car wash, especially if parked nose-up on a slope.
- Why it happens
- Mitsubishi issued a 2010 bulletin for water getting past the cowl trim at the base of the windshield.
- What to do
- Dry the carpet to prevent mold and electrical problems, then have the cowl area resealed.
Valve cover gasket oil leak
- What you'll notice
- Oil seeping from the top of the engine, a burning-oil smell, or light smoke from the engine bay after driving.
- Why it happens
- The rubber valve cover gaskets harden and crack with age, especially past 100,000 miles.
- What to do
- Check the oil level regularly. Have both sides replaced at once; it is a moderate-cost repair and stops oil from dripping on hot exhaust parts.
Clunk or pop from the steering shaft
- What you'll notice
- A clunk or popping felt through the steering wheel when turning, especially at low speed or parking.
- Why it happens
- The intermediate steering shaft between the column and steering gear wears and binds. RepairPal has reports across all Raider years, often around 75,000 miles.
- What to do
- Have the steering shaft and front steering parts inspected. Lubricating or replacing the shaft usually fixes it.
Water inside headlights or lamps
- What you'll notice
- Fog or droplets inside a headlight or lamp that don't clear.
- Why it happens
- A bulletin explains how to tell normal condensation from water getting in through a bad seal or damaged lamp.
- What to do
- Light fog that clears when the lights are on is normal. Standing water needs a resealed or new lamp.
Repair prices for your 2008 Mitsubishi Raider
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose and update engine/transmission computer software
- Rebuild or replace cylinder head
- Replace head gasket(s)
- Replace water pump, thermostat, hose or radiator
- Replace both valve cover gaskets
- Replace sticking lash adjuster(s)
- Replace PCV valve and change oil
- Install updated PCV parts
- Transmission fluid service and software update
- Lubricate or replace intermediate steering shaft
- Reseal cowl and dry carpet
- Replace leaking headlamp
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free recall repair at a Mitsubishi dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…