Your 2006 Nissan Armadaproblems, repair costs and recalls
What we've documented about the 2006 Nissan Armada: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2006 Nissan Armada
11 documented issues apply to 2006, most serious first.
Radiator leaks coolant into the transmission
- What you'll notice
- Shifts start to slip or flare, the engine revs without the truck speeding up, and the transmission fluid looks pink and milky. You may also find coolant going missing with no puddle under the truck.
- Why it happens
- The automatic transmission fluid is cooled by a small cooler built inside the radiator. With age, the wall between the coolant and the transmission fluid can crack, so the two fluids mix. Coolant in the transmission quickly ruins its clutches.
- What to do
- If you see milky fluid or slipping, stop driving and have it towed. Replacing the radiator early, or adding a separate transmission cooler, is far cheaper than the transmission damage that follows.
ABS, VDC and brake lights from failing brake booster sensor
- What you'll notice
- The ABS, VDC (stability control) and brake warning lights come on together, sometimes with a pulsing or grabbing brake pedal or a loss of pedal feel. Code C1179 is common.
- Why it happens
- A position sensor (the "delta stroke sensor") built into the brake booster fails. The sensor cannot be bought alone, so the whole booster has to be replaced.
- What to do
- Have the brake codes read right away. Do not ignore it: braking and stability control can act strangely until it is fixed.
Engine relay can stall the engine (recall)
- What you'll notice
- The engine stalls while driving or will not start, then may work again later.
- Why it happens
- Oxide builds up on the contacts of the engine control relay in the under-hood fuse box, so it loses contact. Recall 10V517.
- What to do
- Check your VIN for an open recall. The dealer replaces the power distribution relay free.
A/C condenser fan motor can overheat (recall)
- What you'll notice
- A burning smell from the front of the engine bay, or a cooling fan that stops working.
- Why it happens
- Water can get into the condenser fan motor and corrode it, which can make it overheat and start a fire. Recall 08V284.
- What to do
- Check your VIN for the recall. If you smell burning, park outside and have it inspected.
Front lower control link welds may break (recall)
- What you'll notice
- Clunking from the front suspension, wandering steering, or a sudden change in handling.
- Why it happens
- Welds on the lower control link collars may not meet strength specs and can separate. Recall 10V208 covers 2010 trucks built from November 2009 to March 2010, and 10E019 covers older trucks repaired with those replacement links.
- What to do
- Check your VIN for open recalls. Dealers replace the links free.
Cracked exhaust manifolds
- What you'll notice
- A ticking or tapping noise right after a cold start that fades as the engine warms, an exhaust smell, worse fuel mileage and sometimes a check engine light.
- Why it happens
- The cast exhaust manifolds on the 5.6L V8 crack from years of heating and cooling, usually around 100,000 miles. Nissan strengthened them for 2007, but cracks still happen.
- What to do
- Have both manifolds inspected, since the other side often cracks too. Fix it before the leak damages the oxygen sensors or lets fumes reach the cabin.
Catalytic converters break up and clog
- What you'll notice
- Check engine light with codes P0420 or P0430, a rattle under the truck, a rotten egg smell, and a big loss of power at higher speeds.
- Why it happens
- The ceramic inside the front catalytic converters can crack and break apart. The pieces can block the exhaust further down, and on these engines the debris has been linked to cylinder wear. Misfires or burning oil speed this up.
- What to do
- Get the codes read and the exhaust back-pressure checked. Fix any misfire or oil burning first, then replace the failed converter.
Rear A/C lines leak under the truck
- What you'll notice
- The rear air conditioning blows warm or only cool air, and the front A/C weakens as refrigerant leaks out.
- Why it happens
- The long metal refrigerant lines that run under the body to the rear A/C unit corrode from road salt and water and start to leak.
- What to do
- Have the system dye-tested to find the leak. Patches rarely last; replacing the corroded line section is the lasting fix.
Rear self-leveling suspension sags
- What you'll notice
- The rear end sits low, especially after sitting overnight or when towing, the compressor runs a lot, or a suspension warning appears.
- Why it happens
- On trims with rear self-leveling suspension, the air springs leak, the compressor wears out or a ride height sensor fails, so the system cannot hold the rear up.
- What to do
- Have the system checked for leaks before replacing the compressor. Many owners of older trucks convert to regular springs and shocks for a lower long-term cost.
Fuel gauge shows fuel when the tank is empty (recall)
- What you'll notice
- The gauge still shows about a quarter tank when the tank is actually empty, so the truck can run out of fuel. Some never read full or drop to empty early.
- Why it happens
- The fuel level sender in the tank reads wrong. Recall 10V074 reprogrammed and repaired affected trucks.
- What to do
- Check your VIN for the recall. Until it is fixed, track your mileage and refuel early.
Power liftgate stops working
- What you'll notice
- The liftgate motor whirs but the gate does not move, the gate stops part way and beeps, or it drifts shut.
- Why it happens
- The bolt that connects the liftgate motor to its arm works loose, and the gas struts that hold the gate up wear out.
- What to do
- Have the motor-arm bolt checked and tightened with thread locker, and replace both struts as a pair. A new motor is often not needed.
Repair prices for your 2006 Nissan Armada
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace radiator and flush transmission fluid
- Replace one exhaust manifold and gaskets
- Replace one front (manifold) catalytic converter and gaskets
- Replace brake booster (includes delta stroke sensor) and bleed brakes
- Replace rear A/C refrigerant line section and recharge
- Replace rear air shocks or convert to coil springs and shocks
- Tighten liftgate motor bolt and replace gas struts
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free recall repair at a Nissan dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…