Your 2014 Nissan Cubeproblems, repair costs and recalls
What we've documented about the 2014 Nissan Cube: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2014 Nissan Cube
10 documented issues apply to 2014, most serious first.
CVT slipping, hesitating or failing
- What you'll notice
- The engine revs but the car is slow to pick up speed, it hesitates at stoplights, the transmission whines or rattles, or the car stops moving altogether.
- Why it happens
- The continuously variable transmission (CVT) is the Cube's most reported problem. Owners describe failures at around 80,000-100,000 miles, and some cars needed a new transmission much earlier. Wrong or old CVT fluid makes failure more likely.
- What to do
- Change the CVT fluid with genuine Nissan NS-2 fluid on schedule. If it slips or whines, get a diagnosis right away and ask Nissan whether any extended CVT coverage applies to your VIN.
Start/stop button can stick and shut off the engine (recall)
- What you'll notice
- The engine can shut off while driving after going over bumps, and the start button may feel stuck.
- Why it happens
- The engine start/stop button can catch in its housing. Road vibration can then press it and turn the engine off.
- What to do
- Confirm the free recall repair (NHTSA 15V-418) was done. If the engine shuts off while driving, steer to safety; you will lose power assist.
Exhaust flex joint or muffler rusts and breaks
- What you'll notice
- A loud exhaust, a rattle or drone from under the car, or exhaust fumes you can smell.
- Why it happens
- The exhaust flex joint, pipes and muffler connections rust and crack. They are among the most common repairs owners report.
- What to do
- Have the exhaust inspected on a lift. Fix leaks quickly so fumes cannot get into the cabin.
Humming from a worn wheel bearing
- What you'll notice
- A hum or growl that rises with speed and may change when you turn.
- Why it happens
- Wheel bearings and hubs wear out and are one of the more common repairs owners report.
- What to do
- Have the bearings checked on a lift. A badly worn bearing can overheat, so do not wait too long.
Rattle or vibration at idle from worn engine mounts
- What you'll notice
- A rattle or vibration when the car comes to a stop after warming up, or a clunk when pulling away.
- Why it happens
- Engine and torque rod mounts wear or crack, and some were not installed correctly from the factory.
- What to do
- Have the engine mounts and torque rod bushings inspected. Replacing a worn mount is usually a modest repair.
Check engine light with a mass airflow code
- What you'll notice
- The check engine light comes on with code P0101, sometimes with hesitation or poor fuel economy.
- Why it happens
- A dirty or failing mass airflow (MAF) sensor, or in some cases engine computer software, can trigger the code.
- What to do
- Try cleaning the MAF sensor with the proper spray first. If the code returns, ask a dealer about a software update before replacing the sensor.
Rear door won't open from the latch or remote
- What you'll notice
- The side-hinged rear door will not open with the button, key or remote.
- Why it happens
- The rear door latch actuator can fail, and dirt and corrosion in the latch can make it stick.
- What to do
- Use the emergency release from inside if needed. Lubricating the latch can help; a failed actuator needs replacement.
Water leaks into the cargo area
- What you'll notice
- Damp carpet, water stains or a musty smell in the cargo area behind the rear seat.
- Why it happens
- Dirt builds up on the rear door weather seals so they stop sealing flush, and damaged seal segments let water in.
- What to do
- Clean and inspect the rear door seals. Replace any cracked or flattened sections and dry the carpet to stop mold.
Fuel door latch breaks
- What you'll notice
- The fuel door will not open or close, or a piece of the latch snaps off.
- Why it happens
- Part of the fuel door latch mechanism is fragile and can break.
- What to do
- The repair means removing the wheel well liner to reach the latch. It is not a hard job for a shop or a handy owner.
Power window switch fails
- What you'll notice
- A window will not move from the driver's switch or works only some of the time.
- Why it happens
- The power window switch contacts wear or get dirty. Owners report replacing the master switch assembly.
- What to do
- Try the window from its own door switch to narrow it down. A shop can clean or replace the switch.
Repair prices for your 2014 Nissan Cube
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace CVT with a remanufactured unit
- Replace exhaust flex pipe or muffler section
- Replace engine or torque rod mount
- Clean or replace mass airflow sensor
- Replace rear door latch actuator
- Clean or replace rear door weather seal and dry interior
- Replace wheel bearing and hub assembly
- Replace fuel door latch (opener) assembly
- Replace driver power window master switch
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Repair engine start/stop switchNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…