Nissan Maximaproblems, repair costs and recalls
Problems reported across 1996–2023. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
24 documented issues across all years, most serious first.
Alternator can short internally and overheat (recall)
- What you'll notice
- The battery light may come on, the lights may dim, or you may notice a hot electrical smell from under the hood.
- Why it happens
- A diode inside the alternator can be damaged and short out, which can melt the alternator housing and start a fire.
- What to do
- Check the VIN for the open recall and have the alternator replaced before driving further if you notice a burning smell or a charging light.
Front lower control arm pin can break at the frame (recall)
- What you'll notice
- A clunk from the front end, a wheel that looks out of position, or sudden trouble steering.
- Why it happens
- The pin that attaches the front transverse link to the frame can crack and snap, letting the front wheel shift.
- What to do
- Check the VIN for the recall. If you hear a sudden front-end clunk or the steering changes, stop driving and have it towed.
Crank or cam position sensor can cut out and stall the engine (recall)
- What you'll notice
- The engine stalls without warning, cranks a long time before starting, or the check engine light comes on.
- Why it happens
- A weak solder joint on the circuit board inside the crankshaft or camshaft position sensor can open up, and the engine computer loses its timing signal.
- What to do
- Check the VIN for the recall and have the sensors replaced promptly, because a stall in traffic is a safety risk.
Driver seat wiring can short and start a fire (recall)
- What you'll notice
- A burning smell or smoke from under the driver seat, or the power lumbar support stops working.
- Why it happens
- The lumbar switch wiring under the driver seat can get pinched by the seat frame, rub through, and short out.
- What to do
- Check the VIN for the recall. If you smell burning from the seat, stop using the car and have it repaired right away.
Rear subframe bracket can crack (recall)
- What you'll notice
- Clunking from the rear, the back of the car feeling loose or wandering, or uneven rear tire wear.
- Why it happens
- Some rear subframes were made with a defect that lets a bracket holding the rear suspension crack.
- What to do
- Check the VIN for the recall. If the rear end feels loose or clunks, stop driving and have the subframe inspected.
Steering column can lock while the car is moving (recall)
- What you'll notice
- On cars with the Intelligent Key, the steering wheel can lock when turned to the right while the shifter is out of Park.
- Why it happens
- The electronic steering lock assembly can engage when it should not.
- What to do
- Check the VIN for the recall and have the steering lock assembly replaced before relying on the car.
Front strut mounts can crack (recall)
- What you'll notice
- A knocking or popping noise from the front over bumps, or steering that suddenly feels off.
- Why it happens
- The rubber and metal insulators at the top of the front struts can crack, letting the strut rod move out of position.
- What to do
- Check the VIN for the recall. If you hear front-end knocking, have it inspected right away and avoid driving until it is checked.
Front brake caliper bolts may be loose (recall)
- What you'll notice
- A clunk or rattle from a front wheel when braking, or a brake that suddenly feels wrong.
- Why it happens
- Some front brake caliper mounting bolts were not tightened fully at the factory.
- What to do
- Check the VIN for the recall and have the bolts checked before driving further if you hear a front brake clunk.
ABS unit seal can fail and reduce brake pressure (recall)
- What you'll notice
- A brake warning light, a low or soft brake pedal, or longer stopping distances.
- Why it happens
- An O-ring inside the ABS actuator may have been damaged during assembly, which can let brake pressure drop.
- What to do
- Check the VIN for the recall. If the pedal feels soft or a brake warning is on, stop driving and have it towed in.
ABS unit can leak brake fluid inside and catch fire (recall)
- What you'll notice
- The ABS warning light stays on after start-up. In rare cases there is a burning smell or smoke from under the hood, even when parked.
- Why it happens
- A seal in the ABS actuator can let brake fluid seep onto its circuit board, causing an electrical short.
- What to do
- If the ABS light stays on, park outside away from buildings, do not drive, and have the dealer replace the actuator under the recall.
Ignition coils fail and cause misfires
- What you'll notice
- The engine shakes at idle, hesitates when you accelerate, and the check engine light comes on or flashes.
- Why it happens
- Each cylinder has its own ignition coil, and on these years the coils tend to break down with heat and age, often several around the same time.
- What to do
- Have the misfire codes read soon. Driving for long with a flashing check engine light can damage the catalytic converters.
Gas pedal can travel too far and limit engine speed (recall)
- What you'll notice
- After pressing the pedal hard to the floor, the engine may suddenly refuse to rev and the car barely accelerates.
- Why it happens
- The pedal stopper lets the pedal move past its intended range, and the electronic throttle system reacts by cutting engine speed.
- What to do
- Check the VIN for the recall and have the updated pedal stopper fitted. Avoid flooring the pedal until it is done.
Glass roof panel can shatter (recall)
- What you'll notice
- A loud bang followed by broken glass from the fixed glass roof panel, sometimes with no impact.
- Why it happens
- Some Skyview roof glass panels were not tempered correctly at the factory and can break on their own.
- What to do
- Check the VIN for the recall and have the roof glass inspected. If it has cracked, cover it and get it replaced soon.
Automatic transmission shifts harshly or slips
- What you'll notice
- Hard, jerky shifts, a bang when it downshifts as you slow, or the engine revving without the car picking up speed.
- Why it happens
- Owners of the conventional automatic used in these years report early wear and valve body problems that upset shift quality.
- What to do
- Have the transmission fluid condition and any stored codes checked soon. Catching it early can sometimes avoid a full rebuild.
Timing chain guides and tensioner wear and whine
- What you'll notice
- A high-pitched whine or rattle from the front of the engine that rises with engine speed, sometimes with a check engine light.
- Why it happens
- The secondary timing chain guides and tensioners wear, letting the chains run loose and noisy.
- What to do
- Have the noise diagnosed soon. A badly worn chain system can jump timing and cause serious engine damage.
Electronic steering lock fails and the car will not start
- What you'll notice
- You press the start button and nothing happens, often with a key warning light, and the steering wheel stays locked.
- Why it happens
- The electronic steering column lock unit sticks and the car will not allow the engine to start until it releases.
- What to do
- It will not harm the car but can leave you stranded. Have a shop confirm the steering lock is the cause before replacing the starter or battery.
Fuel tank seal may leak in a crash (recall)
- What you'll notice
- Usually nothing day to day; some owners notice a fuel smell near the rear seat.
- Why it happens
- The O-ring on the fuel sending unit at the top of the tank may not be seated properly and could let fuel escape in a collision.
- What to do
- Check the VIN for the recall and have the retainer ring installed. Have any fuel smell checked soon.
Passenger airbag may be switched off by mistake (recall)
- What you'll notice
- The passenger airbag off light shows with an adult in the front seat, or the airbag warning light stays on.
- Why it happens
- The seat sensing system can misjudge who is sitting in the front passenger seat and disable that airbag.
- What to do
- Check the VIN for the recalls and have the software updated soon. Until then, seat adults in the rear if the off light is showing.
CVT shudders or vibrates
- What you'll notice
- A shake or judder when accelerating gently, sometimes with a check engine light.
- Why it happens
- Wear in the CVT valve body or the chain and pulley assembly; Nissan released a service bulletin covering the diagnosis and repair.
- What to do
- Have it checked soon and ask the dealer about the CVT judder bulletin. Continuing to drive with heavy judder can turn a smaller repair into a full replacement.
Rear window glass may not be bonded properly (recall)
- What you'll notice
- Wind noise or a water leak around the rear window, or glass that looks loose.
- Why it happens
- The rear glass may not have been secured to the body correctly and could come loose.
- What to do
- Check the VIN for the recall and have the rear glass replaced soon.
Forward emergency braking warning from the front radar sensor
- What you'll notice
- A warning that front radar or forward emergency braking is unavailable, even in clear weather.
- Why it happens
- The radar sensor behind the front bumper can be knocked out of alignment or blocked; Nissan issued a service bulletin on diagnosing it.
- What to do
- Keep the bumper area clean and have the sensor alignment and bracket checked at your next visit. Drive without relying on automatic braking until then.
Ticking or popping from behind the rear seat
- What you'll notice
- A ticking, tapping, or popping sound from the rear seatback area over bumps.
- Why it happens
- Two body panels behind the rear seat sit close enough to touch and rub; Nissan has a service bulletin with a fix.
- What to do
- It is an annoyance rather than a safety problem. Mention the bulletin at your next service visit.
Backup camera image can be hidden by a saved setting (recall)
- What you'll notice
- The rear view picture does not appear, or is too dark to see, when you shift into Reverse.
- Why it happens
- Display settings can be changed so the camera image is not visible, and the setting stays that way on the next start.
- What to do
- Check the VIN for the recall and have the camera software updated. Use mirrors and look behind you in the meantime.
Aftermarket corner lamps may be missing a side reflector (recall)
- What you'll notice
- Nothing changes in the way the car drives, but if the front corner or combination lamps have ever been replaced with aftermarket parts, the car may have no amber reflector on the side of the lamp.
- Why it happens
- Several lamp makers sold replacement corner, combination and head lamps for these Maximas without the amber side reflector that federal rules require, so the car is harder for other drivers to pick out from the side at night.
- What to do
- Monitor it. Have a shop confirm the lamps fitted to the car are compliant units; the lamp maker replaces the recalled ones at no charge.
Repair prices for your Nissan Maxima
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace alternator
- Replace ignition coils (set of 6) and spark plugs
- Replace both front transverse links (lower control arms)
- Install updated accelerator pedal stopper
- Replace crankshaft and camshaft position sensors
- Replace Skyview roof glass panel
- Replace and reroute driver seat lumbar harness
- Rebuild or replace automatic transmission
- Replace timing chains, guides and tensioners
- Replace rear subframe
- Replace steering wheel lock assembly
- Replace both front strut insulators (mounts)
- Replace electronic steering column lock unit
- Inspect and tighten front brake caliper mounting bolts
- Install fuel sending unit retainer ring
- Replace ABS actuator
- Diagnose and realign or replace front radar sensor
- Reprogram airbag and occupant classification control units
- Replace CVT valve body or CVT assembly
- Adjust rear body panel gap and add foam filler
- Update backup camera display software
- Remove and reinstall or replace rear window glass
- Replace one front corner or combination lamp assembly
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.