Your 2012 Nissan Muranoproblems, repair costs and recalls
What we've documented about the 2012 Nissan Murano: problems owners and shops report, typical repair and upkeep costs, and safety recalls. No 2008 model year in the US.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2012 Nissan Murano
8 documented issues apply to 2012, most serious first.
Tire pressure monitor not switched on at the factory (recall)
- What you'll notice
- The tire pressure system never warns you even when a tire is low.
- Why it happens
- On some SUVs the tire pressure monitoring system was not activated during assembly. Nissan recalled them.
- What to do
- Check the VIN for open recalls and check tire pressures by hand until the system is activated.
Oil leak where the transfer case meets the transmission
- What you'll notice
- A dark drip or wet film under the middle of the car on all-wheel-drive models, sometimes with a burnt oil smell after a drive.
- Why it happens
- The seal between the CVT and the transfer case hardens with heat and age and lets fluid past. Low fluid can damage the transfer case.
- What to do
- Get the leak traced and the seal replaced before the fluid level drops; keep an eye on the level in the meantime.
Engine oil cooler gasket leaks
- What you'll notice
- Oil weeping around the oil filter area and drips on the driveway, with the oil level falling between changes.
- Why it happens
- The gasket between the oil cooler and the engine block loses its seal, so oil escapes where the two meet.
- What to do
- Have the gasket replaced and the level topped up. It is a slow leak, but check the oil often until it is fixed.
Rusted exhaust flex pipe gets loud
- What you'll notice
- A sudden roar or raspy drone under the car that is worst when pulling away, sometimes with exhaust fumes reaching the cabin.
- Why it happens
- The braided flexible section in the exhaust rusts from the inside out in salt-belt use and splits.
- What to do
- Have the flex section replaced. Exhaust gas finding its way inside the car makes this worth sorting out promptly.
Alternator stops charging the battery
- What you'll notice
- The battery light comes on, the headlights dim, the engine cranks slowly, and eventually the car will not start at all.
- Why it happens
- The alternator wears out earlier than many owners expect on these, so the battery is never fully recharged.
- What to do
- Have the charging system tested. Replace the alternator before it leaves you stranded, and have the battery checked at the same time.
Front wheel bearing hum that rises with speed
- What you'll notice
- A humming or growling that gets louder the faster you go and may change when you turn or change lanes.
- Why it happens
- The sealed front wheel bearing and hub unit wears out and develops play.
- What to do
- Have the bearing checked and replaced. A badly worn bearing can get hot and should not be left for long.
Front control arms and tie rod ends wear early
- What you'll notice
- Clunks or rattles over bumps, loose or wandering steering, and front tires wearing unevenly on the inside edges.
- Why it happens
- The rubber bushings in the lower control arms and the ball joints in the tie rod ends are a known weak point and develop play.
- What to do
- Have the front end inspected and the worn parts replaced, then get an alignment so the tires last.
Catalytic converter failure sets the check engine light
- What you'll notice
- A steady check engine light, often with a sulphur smell, sluggish pulling away, or a rattle from under the car.
- Why it happens
- The honeycomb inside the converter breaks down or clogs, so the exhaust can no longer be cleaned properly and the computer notices.
- What to do
- Have the codes read before buying parts; a failing sensor or an engine misfire can cause the same light and will ruin a new converter.
Repair prices for your 2012 Nissan Murano
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Activate tire pressure monitoring system
- Replace transfer case seal and gasket
- Replace engine oil cooler gasket
- Replace exhaust flex pipe section
- Replace alternator
- Replace front wheel hub and bearing, one side
- Replace lower control arm and outer tie rod end, one side
- Replace front catalytic converter
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…