Your 2004 Nissan Questproblems, repair costs and recalls
What we've documented about the 2004 Nissan Quest: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2004 Nissan Quest
18 documented issues apply to 2004, most serious first.
Automatic transmission slips, jerks or fails
- What you'll notice
- Slipping when accelerating, engine revs flaring between gears, jerky or delayed shifts, or the van losing forward drive.
- Why it happens
- The automatic transmissions in this generation wear their internal clutches, often linked to overheating, and the wrong fluid makes it worse. Transmission complaints are the costliest Quest problems for these years.
- What to do
- Check the fluid level and condition. If it slips or jerks, have it diagnosed before it fails completely. Use only the fluid Nissan specifies.
Timing chain rattle or whine from worn guides
- What you'll notice
- A rattle for a few seconds after a cold start, a rattle or whine from the front of the engine at certain speeds, and sometimes a check engine light with cam timing codes.
- Why it happens
- The timing chain guides and tensioners on the 3.5L V6 wear, and sludge from skipped oil changes can make the tensioners stick.
- What to do
- Have a mechanic listen to it and read any codes. Fix it before the chain jumps; the job usually includes the water pump and front seal.
Front subframe rusts through
- What you'll notice
- Clunks from the front end, visible rust holes in the frame under the engine, or a failed safety inspection.
- Why it happens
- The front subframe that carries the engine and suspension can rot from road salt, usually near 100,000 miles.
- What to do
- Have the subframe inspected on a lift. Severe rust is a safety risk and the subframe must be replaced.
Power sliding door may not latch in cold weather (recall)
- What you'll notice
- The sliding door does not fully latch, especially when it is cold.
- Why it happens
- The door actuator can bind in the cold, so the door may not latch and could open.
- What to do
- Have the free repair done.
Free at a Nissan dealer. Check your VIN for open recalls.
Passenger airbag sensor may not switch the airbag correctly (recall)
- What you'll notice
- The passenger airbag status light acts strangely or stays on with a child seated.
- Why it happens
- The front passenger seat occupant sensor did not meet the advanced airbag rule.
- What to do
- Have the dealer inspect and recalibrate or replace the sensor.
Free at a Nissan dealer. Check your VIN for open recalls.
Third-row seat latch bracket can break (recall)
- What you'll notice
- The third-row seat does not stay latched.
- Why it happens
- A weld on the third-row seat striker bracket can break.
- What to do
- Have the free repair done.
Free at a Nissan dealer. Check your VIN for open recalls.
Power sliding door stops working or will not close
- What you'll notice
- A sliding door that stops partway, grinds, will not latch shut, or does not move at all with the button.
- Why it happens
- The door motor wears out, the drive cables break, or the latch fails.
- What to do
- If a door will not latch, turn off the power door switch and close it by hand until it is repaired. Do not drive with a door that may open.
Center dash display and gauges go blank
- What you'll notice
- The center-mounted display shows dashes or goes blank, gauges cut in and out, or segments look dim or broken.
- Why it happens
- Connections on the gauge cluster circuit board and display ribbon fail with age.
- What to do
- Have the cluster repaired or replaced by a cluster repair specialist or dealer.
Water leaks from clogged SkyView or sunroof drains
- What you'll notice
- Wet headliner, damp carpets, or water dripping inside after rain.
- Why it happens
- The glass roof panels have drain tubes that clog or kink, so water backs up into the cabin.
- What to do
- Have the drains cleared with air or a flexible line and dry the interior quickly to prevent mold and electrical damage.
Front wheel bearings hum or growl
- What you'll notice
- A hum or growl that gets louder with speed and may change when you turn.
- Why it happens
- Owners of many Quests report front wheel bearings and hubs wearing out, sometimes on both sides.
- What to do
- Have a shop check for play and noise. A failing bearing should be replaced before it seizes.
Front control arms, ball joints and tie rods wear early
- What you'll notice
- Clunks over bumps, loose steering, wandering, or uneven tire wear.
- Why it happens
- The front control arm bushings, ball joints and tie rod ends on these heavy vans wear out, and owners report replacing them more than once.
- What to do
- Have the front end checked for play and get an alignment after any parts are replaced.
Alternator stops charging
- What you'll notice
- A battery or charging light, dim lights, or a dead battery.
- Why it happens
- Owners report alternator failures, sometimes more than once, on both the 2004-2009 and 2011-2013 Quests.
- What to do
- Have the charging system tested before replacing the battery.
Cam or crank position sensor failure
- What you'll notice
- Check engine light, rough running, stalling, or the engine cranking without starting.
- Why it happens
- Camshaft and crankshaft position sensors on the 3.5L V6 fail, and owners often replace more than one.
- What to do
- Have the codes read. These sensors are cheap and usually quick to replace.
Worn engine mounts cause thumping
- What you'll notice
- A thump or clunk felt in the floor when you shift into gear, accelerate, or brake, and extra vibration at idle.
- Why it happens
- Engine mounts wear or crack and let the engine move too much.
- What to do
- Have the mounts inspected. Replacing a broken mount stops the thumping and protects other parts.
Power steering hose wears through and leaks
- What you'll notice
- Power steering fluid leaking, a whining pump, or steering that gets heavy.
- Why it happens
- Owners report the power steering pressure hose rubbing through or leaking, along with other power steering line leaks.
- What to do
- Top up the fluid and have the leaking hose replaced quickly so the pump is not damaged.
Torn CV axle boots and clicking axles
- What you'll notice
- Clicking when turning, grease thrown inside the wheel, or vibration when accelerating.
- Why it happens
- The rubber boots on the front drive axles split, the grease escapes, and the joints wear out.
- What to do
- Replace a torn boot or the axle soon, before the joint fails and leaves you stranded.
Oil leaks from valve cover and oil pan gaskets
- What you'll notice
- Oil spots under the van, a burning oil smell, or oil on the engine.
- Why it happens
- Owners report the valve cover, oil pan and other gaskets leaking as the engine ages.
- What to do
- Have the source found and the gasket replaced before oil drips onto the exhaust.
Second-row seat can pinch fingers (recall)
- What you'll notice
- Fingers can get caught when adjusting the second-row seat.
- Why it happens
- Moving parts in the seat adjuster are exposed.
- What to do
- Have the free covers and parts installed.
Free at a Nissan dealer. Check your VIN for open recalls.
Repair prices for your 2004 Nissan Quest
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission (rebuilt or remanufactured)
- Replace timing chains, guides and tensioners
- Replace the sliding door lock actuator (motor or cable repair may be needed instead)
- Replace front subframe
- Replace front wheel hub and bearing assembly (one side)
- Replace front lower control arms and align
- Replace alternator
- Replace camshaft or crankshaft position sensor
- Replace engine mount
- Replace valve cover gaskets
- Replace power steering pressure hose
- Replace front CV axle (one side)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…