Your 1998 Oldsmobile Achievaproblems, repair costs and recalls
What we've documented about the 1998 Oldsmobile Achieva: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1998 Oldsmobile Achieva
9 documented issues apply to 1998, most serious first.
Intake manifold gasket coolant leak
- What you'll notice
- Coolant level keeps dropping, a sweet smell after driving, wet spots or crusty residue near the top-center of the engine, or the engine starts to run hot. In bad cases the oil turns milky.
- Why it happens
- The 3.1L V6 uses lower intake manifold gaskets that break down with age, heat and the factory long-life coolant. Coolant then seeps out of the engine or into the oil.
- What to do
- Keep the coolant topped up and watch the temperature gauge. If the gauge climbs, pull over and shut the engine off. Have a shop pressure-test the cooling system and check the oil for coolant; replace the gaskets before coolant damages the engine bearings.
Water pump leak, coolant loss and overheating
- What you'll notice
- Low-coolant warnings, coolant drips under the front of the engine, a sweet smell, or the temperature gauge rising.
- Why it happens
- The water pump seal wears and leaks. On the 2.4L Twin Cam the pump is known for failures and is hard to get to, so replacing it costs much more than on the V6.
- What to do
- Don't keep driving with the temperature gauge high; an overheat can ruin the head gasket. Have the leak source confirmed with a pressure test and replace the pump. On the 2.4L, ask about replacing the timing chain parts at the same time.
Timing chain rattle or failure
- What you'll notice
- A rattle or slapping noise from the passenger side of the engine, loudest at startup, sometimes with a check engine light. If the chain breaks, the engine stops and won't restart.
- Why it happens
- The 2.4L Twin Cam from these years is known for timing chain wear and failures. Its small oil passages also make it sensitive to skipped oil changes.
- What to do
- If you hear a new rattle, have it checked soon rather than waiting for the chain to break. Keep up with oil changes using the right oil.
Ignition switch can overheat during long cranking (recall)
- What you'll notice
- A hot or burning plastic smell from the steering column, smoke from under the dash, or the key and switch acting up after a long period of cranking.
- Why it happens
- Holding the key in Start for a long time can overheat parts inside the ignition switch. GM recalled these cars (recall 02V-070 for 1996-1997 and 04V-036 for 1998) because a damaged switch could start a fire in the steering column, even after the car is turned off.
- What to do
- If you smell burning from the column, turn the car off, take the key out and get out. Don't hold the key in Start for long. Ask a GM dealer with your VIN whether the recall repair was done.
Engine stalls or won't stay running
- What you'll notice
- The engine starts and dies after a few seconds, or it shuts off while driving, often at low speed or when pulling away. On some cars the security light blinks.
- Why it happens
- Owners trace it to several causes: the anti-theft system cutting fuel, a worn ignition switch, or fuel delivery and idle control problems. Many shops struggle to pin it down.
- What to do
- A stall can take away power steering and brake assist, so leave extra room and steer firmly to a safe spot. Note whether the security light is on and have the codes read while the problem is happening.
ABS light on, brakes grab or the pedal goes soft
- What you'll notice
- The ABS warning light comes on or flashes, the brakes lock or grab on wet roads or turns, the ABS kicks in when it shouldn't, or the pedal sinks and stopping takes longer.
- Why it happens
- Owners report recurring antilock brake faults and worn pads and rotors. Causes include wheel speed sensor faults and ABS unit problems, and dealers often could not reproduce them.
- What to do
- Brake problems are a safety issue. If the pedal feels soft or sinks, don't drive the car until a qualified shop inspects the brakes. If only the ABS light is on, normal brakes usually still work but ABS may not, so leave more stopping distance and get it checked soon.
Ignition switch fails, melts or won't start the car
- What you'll notice
- The car cranks but won't start or won't crank at all, the dash lights stay off when you turn the key, the key sticks, or smoke appears from the dash or column.
- Why it happens
- The ignition switch on these cars wears and can short. Several owners had switches fail or melt wiring before the recall repair reached them.
- What to do
- If you see smoke from the column or dash, turn the car off, remove the key and get out. Otherwise have the switch and its wiring tested and replaced, and confirm the recall repair was done.
Dashboard gauges stop working
- What you'll notice
- The speedometer, fuel gauge, temperature gauge or tachometer drop to zero, swing around, or die all at once. Warning lights may stay on.
- Why it happens
- The instrument cluster or its wiring on these GM compacts fails with age. This Skylark, Achieva and Pontiac Grand Am share the same platform and parts.
- What to do
- Without a working temperature or fuel gauge you can overheat or run dry, so check fluids and fuel by hand until it's fixed. Have a shop check fuses and connectors first, then test or rebuild the cluster.
Power window stops working
- What you'll notice
- A window moves slowly, stops partway, or won't move at all, sometimes after working for a while.
- Why it happens
- The power window motors can overheat and fail.
- What to do
- Avoid running a slow window up and down repeatedly. Have the motor tested and replaced; check the regulator at the same time.
Repair prices for your 1998 Oldsmobile Achieva
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets, change oil and refill coolant
- Replace water pump and refill coolant
- Replace ignition switch
- No-start and stalling diagnosis
- Replace one ABS wheel speed sensor
- Replace power window motor, one door
- Diagnose gauge and instrument cluster fault
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Ignition switch recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…