Your 2004 Oldsmobile Aleroproblems, repair costs and recalls
What we've documented about the 2004 Oldsmobile Alero: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2004 Oldsmobile Alero
12 documented issues apply to 2004, most serious first.
Intake manifold gasket coolant leak
- What you'll notice
- You keep adding coolant, see a puddle or sweet smell, the temperature gauge climbs, or the low coolant light comes on. In bad cases the oil turns milky.
- Why it happens
- The factory intake manifold gaskets on the 3.4L V6 break down over time and let coolant leak out, or into the oil. Many owners also blame the Dex-Cool coolant. Most failures show up around 90,000 miles.
- What to do
- Don't keep driving it low on coolant; overheating can ruin the engine, and coolant in the oil wipes out the bearings. Have a shop pressure-test the cooling system and replace the upper and lower gaskets with the updated design.
Ignition switch can slip out of Run (recall)
- What you'll notice
- The engine can shut off while driving if the key is bumped or the key ring is heavy, and you lose power steering and power brakes.
- Why it happens
- The ignition switch can move out of the Run position. If that happens, the airbags may not deploy in a crash. This is part of GM's large 2014 ignition switch recall (NHTSA 14V400).
- What to do
- Have a GM dealer check your VIN for open recall work. Until then, carry only the ignition key with nothing heavy hanging from it.
Engine stalls or dies while driving
- What you'll notice
- The engine shuts off while driving or at stops, or starts but won't stay running. It may restart after sitting.
- Why it happens
- Owners trace it to several causes, including a failing fuel pump, the Passlock system, sensors or the ignition module. There is no single fix.
- What to do
- Pull over safely and have the codes read right after it happens. Tell the shop whether the security light was on, since that points to Passlock rather than fuel or ignition.
Timing chain rattle or failure
- What you'll notice
- Rattling from the engine, misfires, rough idle, a check engine light, or a no-start. Metal flakes may show up in the oil.
- Why it happens
- On early 2.2L Ecotec engines the timing chain tensioner gets too little oil at idle and wears out. Low oil makes it worse.
- What to do
- Keep the oil full and changed on time. If you hear a rattle, have the chain and tensioner checked before the chain jumps or breaks.
Won't start with the security light flashing (Passlock)
- What you'll notice
- The engine cranks but never fires, or starts and dies right away. The security or anti-theft light on the dash stays on or flashes. It often comes and goes.
- Why it happens
- The Passlock anti-theft system uses a sensor in the ignition lock area. When that sensor, the lock cylinder or its wiring wears out, the system thinks the car is being stolen and cuts fuel to the engine. This is the most-reported Alero problem.
- What to do
- Try the owner workaround: turn the key to On (engine off) and leave it about 10 minutes until the security light stops flashing, switch off for 10 to 30 seconds, then start. If it keeps happening, have a shop test the Passlock sensor and lock cylinder rather than replacing parts at random.
Cranks but won't start or dies from a failing fuel pump
- What you'll notice
- The engine turns over but won't catch, starts only some of the time, sputters, or shuts off while driving, with no security light involved.
- Why it happens
- The electric fuel pump inside the tank wears out, often somewhere between 30,000 and 135,000 miles. A clogged fuel filter makes the pump work harder and can speed this up.
- What to do
- Have the fuel pressure tested before buying parts, since Passlock faults look similar. If pressure is low, replace the pump and the fuel filter together.
Turn signals work only sometimes or keep clicking
- What you'll notice
- The turn signals or hazards stop working, work only half the time, or the flasher keeps clicking after you shut the car off.
- Why it happens
- The turn signal (multifunction) switch on the steering column wears out and makes poor contact. Over 150 owners have reported it on RepairPal.
- What to do
- Get it fixed soon, since other drivers can't see your turns. A shop can confirm the switch is at fault and replace it.
Key won't turn or sticks in the ignition
- What you'll notice
- The key won't turn in the ignition, gets stuck and won't come out, or the lock binds, sometimes with the security light on.
- Why it happens
- The ignition lock cylinder wears out. Because the Passlock sensor is tied to the lock cylinder, a worn cylinder often brings security-light problems with it.
- What to do
- Don't force the key; a broken key makes the job harder. Have the lock cylinder replaced and the Passlock system relearned.
Horn blows by itself
- What you'll notice
- The horn goes off on its own, sometimes overnight or in cold weather, and keeps blaring until you pull the horn fuse or the fuse blows.
- Why it happens
- The horn contacts are built into the steering wheel airbag cover. As that cover ages and shrinks, it can press on the horn switch.
- What to do
- Pull the horn fuse to stop it in the meantime. A lasting fix means replacing the horn contacts or the airbag/horn pad; have this done by a shop since it involves the airbag.
Power window falls into the door or stops working
- What you'll notice
- A window won't go up or down, slides down on its own, or you hear grinding or a snap from inside the door.
- Why it happens
- The window regulator uses plastic pulleys and clips that crack and break with age.
- What to do
- Tape or wedge the glass up if it won't stay closed. Replace the regulator (often sold with the motor) for that door.
Gauges read wrong or stop working
- What you'll notice
- The fuel gauge jumps around, the temperature gauge stops moving, or the dash lights and gauges act up.
- Why it happens
- The instrument cluster or its circuit boards develop faults with age. Owners report erratic fuel gauges, dead coolant gauges and full cluster failures.
- What to do
- Don't trust a dead gauge: watch your mileage between fill-ups and keep an eye out for overheating. A cluster repair or rebuild shop can usually fix the unit.
Engine won't turn over at all
- What you'll notice
- Turning the key gives a click or nothing at all; the engine doesn't crank.
- Why it happens
- Owners trace these to the battery, starter, ignition switch or alternator, and sometimes to Passlock. It is one of the most common electrical complaints for 2003-2004.
- What to do
- Test the battery and charging system first, as that is the cheapest fix. If the battery is good, have the starter and ignition switch checked.
Repair prices for your 2004 Oldsmobile Alero
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Diagnose Passlock fault and replace ignition lock cylinder/sensor
- Replace in-tank fuel pump module and fuel filter
- Replace upper and lower intake manifold gaskets (3.4L V6)
- Replace turn signal (multifunction) switch
- Replace horn contacts or steering wheel horn/airbag pad
- Replace window regulator (with motor), one door
- Replace ignition lock cylinder and relearn Passlock
- Replace timing chain, guides and tensioner (2.2L)
- Test charging system and replace battery (starter if needed)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Ignition switch recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…