Your 1997 Oldsmobile Cutlassproblems, repair costs and recalls
What we've documented about the 1997 Oldsmobile Cutlass: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1997 Oldsmobile Cutlass
13 documented issues apply to 1997, most serious first.
Intake manifold gasket coolant leak
- What you'll notice
- Coolant disappears with no obvious puddle, a sweet smell after driving, the temperature gauge creeps up, or the oil looks milky. Later the check engine light may flash from a misfire.
- Why it happens
- The lower intake manifold gaskets on the 3.1L V6 break down with age and heat. Coolant leaks outside the engine or into the oil. It is the most reported problem on this car, and some owners needed the repair more than once.
- What to do
- Keep the coolant full and watch the temperature gauge. If it climbs, pull over and turn the engine off. Have a shop pressure-test the cooling system and check the oil for coolant, and fix it before coolant damages the engine bearings.
Steering gear bearing can fail (recall)
- What you'll notice
- Steering gets heavy, like power steering has failed, often worse when turning left. You may hear clunking or squeaking from the front.
- Why it happens
- Retainer parts for a bearing inside the steering rack can break, letting the pinion shaft move. Steering then takes much more effort (recall 03V-527, which covered about 750,000 GM cars).
- What to do
- If steering suddenly gets heavy, slow down and drive carefully to a safe place. Ask an Oldsmobile or Chevrolet dealer with your VIN whether the recall repair was done.
Gas pedal hard to press (accelerator cable off the cam)
- What you'll notice
- The accelerator pedal suddenly feels stiff or hard to push, and the engine doesn't respond normally.
- Why it happens
- On 1997 cars the accelerator cable can slip off the throttle cam on the engine.
- What to do
- If the pedal feels wrong, pull over safely and don't keep driving. Have a shop reseat or replace the throttle cable and check that the pedal returns freely.
Won't start with the security light on (Passlock)
- What you'll notice
- The engine cranks but won't catch, or it starts and dies, and the anti-theft or security light comes on or flashes. Often it will start again after waiting 10 to 20 minutes.
- Why it happens
- The anti-theft system in the ignition lock cylinder stops seeing the right signal and cuts fuel, thinking the car is being stolen. A worn lock cylinder or sensor is the usual cause.
- What to do
- Try leaving the key in On for about 10 minutes until the security light stops flashing, then turn it off and try again. Have a shop read the codes and test the lock cylinder and anti-theft sensor so it doesn't strand you again.
Front brake rotors warp, causing vibration
- What you'll notice
- The steering wheel or brake pedal shakes or pulses when you brake, especially from highway speed. Some owners say stops take longer. It often comes back soon after the rotors are resurfaced.
- Why it happens
- Many owners report front rotors warping again and again, with pads wearing quickly. Dealers often resurfaced the rotors rather than replacing them, and the problem returned.
- What to do
- Have the brakes inspected if they pulse or stopping feels weaker. Replacing the rotors with good-quality new ones and having the wheel lug nuts tightened to spec usually works better than repeated resurfacing.
ABS light comes on over bumps or in turns
- What you'll notice
- The ABS warning light comes on or flashes, often after hitting a bump or turning, and may go out after restarting. ABS may kick in when it shouldn't.
- Why it happens
- Front wheel speed sensors and their wiring are the usual suspects. Some owners had sensors replaced several times before the light stayed off.
- What to do
- Your regular brakes normally still work with the ABS light on, but ABS may not, so leave extra stopping room. If the red brake light comes on or the pedal feels soft, stop driving and have it checked. Have the ABS codes read to find which sensor is at fault.
Passenger wiper can stop working in snow (recall)
- What you'll notice
- In snow or ice, the wipers stop moving or the passenger-side wiper stops partway.
- Why it happens
- Snow or ice can hold back the passenger wiper arm until the pivot housing cracks, and then the wipers stop (recall 01V-068).
- What to do
- Clear snow and ice off the wipers before switching them on. Ask a dealer with your VIN whether the recall repair was done.
Clunking or popping from the front end
- What you'll notice
- A pop, clunk or rattle from the front when going over bumps or turning, sometimes with a ticking noise or vibration.
- Why it happens
- Worn lower control arms or a worn or cracked steering rack were the common causes. Consumer Guide notes GM sometimes replaced the lower control arms or the rack for these noises, and one dealer found a broken weld on a rack.
- What to do
- Have the front suspension and steering rack inspected soon, since a failing rack or control arm can affect steering. Also confirm the steering gear recall was done.
Key chime won't stop and power locks fail
- What you'll notice
- The key-in-ignition chime keeps sounding after the key is removed, and the power door locks may stop working.
- Why it happens
- A fault in the ignition lock cylinder keeps the system thinking the key is still in. Consumer Guide says the lock cylinder must be replaced.
- What to do
- It isn't dangerous, but it can drain the battery and leave doors unlocked. Have the ignition lock cylinder replaced.
Power door lock stops working
- What you'll notice
- One door won't lock or unlock with the switch or remote, while the others work.
- Why it happens
- A rubber part on the lock actuator arm inside the door can break.
- What to do
- Lock that door by hand until it's fixed. Have the door lock actuator or the broken link replaced.
Turn signals stop working
- What you'll notice
- The turn signals stop flashing, or work only some of the time.
- Why it happens
- The turn signal flasher relay fails. One owner needed two relays.
- What to do
- Use hand signals until it's fixed. Replacing the flasher relay is usually a quick, cheap repair.
Radio loses reception
- What you'll notice
- The radio suddenly gets only static or very weak stations.
- Why it happens
- The antenna cable runs where a front passenger's foot can unplug it.
- What to do
- Check the antenna cable connection behind the radio and on the passenger side. Plugging it back in and securing it usually fixes it.
Door handles turn yellow
- What you'll notice
- The outside door handles on white cars turn yellow.
- Why it happens
- Grease from the door lock cylinders stains the handles.
- What to do
- This is cosmetic. Ask a dealer if anything remains of GM's past fix; otherwise new handles can be fitted.
Repair prices for your 1997 Oldsmobile Cutlass
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets, change oil and refill coolant
- Replace ignition lock cylinder and relearn anti-theft system
- Front brake pads and rotors
- Replace one ABS wheel speed sensor
- Replace steering rack and pinion
- Reattach or replace accelerator cable
- Replace ignition lock cylinder
- Replace door lock actuator, one door
- Replace turn signal flasher relay
- Replace exterior door handle, one door
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Steering gear bearing recall repairNo charge if your vehicle is included
- Wiper pivot recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…