Your 1996 Plymouth Voyager / Grand Voyagerproblems, repair costs and recalls
What we've documented about the 1996 Plymouth Voyager / Grand Voyager: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1996 Plymouth Voyager / Grand Voyager
17 documented issues apply to 1996, most serious first.
Four-speed automatic slipping or failing
- What you'll notice
- The van slips between gears, revs without speeding up, shifts late or harshly, or stops moving in Drive or Reverse.
- Why it happens
- The 41TE four-speed automatic in these vans is the most-reported failure, usually between about 85,000 and 130,000 miles. Old or wrong fluid makes it worse; it needs Chrysler ATF+3/ATF+4 type fluid.
- What to do
- Check the fluid level and make sure only the correct Chrysler fluid is used. If it slips or will not move, get a transmission shop diagnosis before driving it further.
Rusted front strut towers
- What you'll notice
- Clunks or creaks from the front over bumps, rust visible around the tops of the front struts under the hood, or alignment that will not stay set.
- Why it happens
- The front strut towers on 1996-2000 Chrysler minivans are known to rust through. Chrysler made repair kits to reinforce them.
- What to do
- Have the strut towers inspected for rust, especially in salt-belt states. Badly rusted towers are a safety issue and need repair before the strut tears loose.
Clock spring can disable the driver airbag (recall)
- What you'll notice
- The airbag light comes on, and the horn or steering wheel buttons may stop working.
- Why it happens
- The clock spring, a coiled ribbon wire behind the steering wheel, can be wound wrong or wear through, cutting the driver airbag circuit. Recalls 02V-293 and 04V-480 replace it.
- What to do
- Do not ignore an airbag light. Have a dealer check both recalls by VIN.
Plymouth is gone, but Chrysler, Dodge, Jeep and Ram dealers still do open recalls for free. Check your VIN.
Fuel rail O-rings can leak (recall)
- What you'll notice
- A raw fuel smell under the hood or fuel wetness around the injectors.
- Why it happens
- The O-ring seals on the fuel rail break down and can leak fuel near hot engine parts. Recall 00V-268 covers vans with the 3.3L and 3.8L V6.
- What to do
- If you smell fuel, do not drive the van. Have a dealer check the recall.
Plymouth is gone, but Chrysler, Dodge, Jeep and Ram dealers still do open recalls for free. Check your VIN.
Cylinder head oil plug can leak and start a fire (recall)
- What you'll notice
- Oil smell or smoke from the engine bay.
- Why it happens
- A plug in the oil passage of the 2.4L engine's cylinder head can push out and spray oil on hot parts. Recall 96V-006 adds a retaining bracket.
- What to do
- Have a dealer confirm the bracket was installed. Any smoke from under the hood needs immediate attention.
Plymouth is gone, but Chrysler, Dodge, Jeep and Ram dealers still do open recalls for free. Check your VIN.
Fuel system leak and vapor recalls
- What you'll notice
- A fuel smell near the tank or filler, or fuel seeping near the fuel pump.
- Why it happens
- Three 1996 recalls cover fuel leaks at the fuel pump mounting (99V-216), static buildup in the ungrounded filler tube (96V-002) and a rollover valve that could let fuel reach the vapor canister (95V-236).
- What to do
- Have a dealer check all three recalls by VIN. Do not ignore a fuel smell.
Plymouth is gone, but Chrysler, Dodge, Jeep and Ram dealers still do open recalls for free. Check your VIN.
Rear bench seat bolts can break (recall)
- What you'll notice
- Usually no warning sign. A rattle or loose rear bench seat can be a clue.
- Why it happens
- Some rear bench seat bolts were brittle and could break, letting the seat come loose in a crash. Recall 95V-225 replaces them.
- What to do
- Have the recall checked by VIN and do not carry passengers on a loose rear seat.
Plymouth is gone, but Chrysler, Dodge, Jeep and Ram dealers still do open recalls for free. Check your VIN.
Stuck in second gear (limp mode)
- What you'll notice
- The van suddenly holds one gear, feels sluggish, and revs high on the highway. Restarting may clear it for a while.
- Why it happens
- When the transmission computer sees a fault from a sensor, solenoid or worn clutch, it locks in a fail-safe gear to protect itself. Chrysler issued bulletins to make the computer less sensitive to brief glitches.
- What to do
- Have the transmission codes read before clearing anything. Sometimes a sensor, wiring or software fix is enough; sometimes it is the first sign of internal wear.
Instrument panel gauges go dead
- What you'll notice
- The speedometer, gauges and dash lights stop working off and on, sometimes coming back after a bump or a tap on the dash.
- Why it happens
- Cracked solder joints inside the instrument cluster and loose wiring connections are the usual causes as the cluster ages.
- What to do
- Have the cluster tested. A cluster repair or rebuilt unit usually fixes it. Do not drive without a working speedometer and fuel gauge.
Rusted power steering lines leak
- What you'll notice
- Power steering fluid drips under the front, the pump whines, or the steering gets heavy, especially at low speed.
- Why it happens
- The steel power steering lines rust over time and start leaking. A worn pump can also groan or lose assist when hot.
- What to do
- Check the power steering fluid level. Replace leaking lines before the pump runs dry and fails.
Radiator and coolant leaks
- What you'll notice
- Coolant level keeps dropping, puddles under the front, or the temperature gauge climbing.
- Why it happens
- Owners of these vans often report leaking radiators, water pumps and hoses as they age.
- What to do
- Keep the coolant topped up and have the leak found with a pressure test before the engine overheats.
Rear heater lines rust and leak
- What you'll notice
- Coolant leaking under the middle of the van, a sweet smell, or the coolant level dropping on vans with rear heat.
- Why it happens
- Vans with rear heat or A/C run long steel coolant pipes under the body that rust out over time.
- What to do
- Have the lines checked when the coolant level drops. Replacing just the rusted pipes is usually much cheaper than replacing the whole system.
Front-end clunks from ball joints and tie rods
- What you'll notice
- Clunks or pops over bumps or while turning, uneven tire wear, or loose-feeling steering.
- Why it happens
- Ball joints, tie rod ends and sway bar links wear on these heavy vans. Chrysler also issued bulletins for front-end popping and suspension groans.
- What to do
- Have the front suspension inspected. Worn ball joints and tie rods should be replaced and the van aligned.
Built-in child seat problems (recalls)
- What you'll notice
- The built-in child seat harness is hard to release, routed wrong, or the seat feels loose.
- Why it happens
- Recalls covered broken child seat mounting bolts (96V-136), a harness latch that sticks when dirty (98V-185) and harness webbing routed wrong (97V-231).
- What to do
- Have a dealer check all child seat recalls before using the built-in seats.
Plymouth is gone, but Chrysler, Dodge, Jeep and Ram dealers still do open recalls for free. Check your VIN.
Oil leaks from valve covers and front seal
- What you'll notice
- Oil spots under the van, a burning oil smell after driving, or oily residue on the engine.
- Why it happens
- Valve cover gaskets and the front crankshaft seal harden and leak with age and high mileage.
- What to do
- Watch the oil level. Fix leaks that drip onto the exhaust, since that can cause smoke or a fire risk.
Speedometer stops working
- What you'll notice
- The speedometer drops to zero or jumps around, and the transmission may shift oddly.
- Why it happens
- The vehicle speed sensor fails, which also confuses the transmission computer.
- What to do
- Have the speed sensor checked and replaced; it is a fairly cheap repair.
Power windows stop working
- What you'll notice
- A window will not go up or down, moves slowly, or makes grinding noises.
- Why it happens
- The window motors, regulators and switches wear out.
- What to do
- Test the switch first; if it is fine, the motor or regulator needs replacing.
Repair prices for your 1996 Plymouth Voyager / Grand Voyager
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace the automatic transaxle
- Diagnose and replace transmission sensor or solenoid pack
- Repair or replace instrument cluster
- Install strut tower repair kits
- Replace power steering pressure or return line
- Replace radiator or water pump
- Replace rusted rear heater pipes
- Replace valve cover gaskets or front crank seal
- Replace ball joint or tie rod end and align
- Replace vehicle speed sensor
- Replace power window motor and regulator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…