Your 2004 Pontiac Bonnevilleproblems, repair costs and recalls
What we've documented about the 2004 Pontiac Bonneville: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2004 Pontiac Bonneville
19 documented issues apply to 2004, most serious first.
Lower intake manifold gasket leaks coolant
- What you'll notice
- Coolant level keeps dropping with no puddle you can find, a sweet smell, the engine running hot, or milky, light-brown sludge on the oil cap or dipstick.
- Why it happens
- The plastic-framed lower intake gaskets on the 3.8L V6 break down and leak coolant, either outside the engine or into the oil. GM issued several bulletins on these leaks and on coolant getting into the oil.
- What to do
- Check the coolant level often and look at the oil for a milky color. If coolant is in the oil, stop driving it until the gaskets are replaced and the oil is changed, because coolant ruins the engine bearings.
Cracked plastic upper intake manifold
- What you'll notice
- Coolant leaking from the top of the engine near the throttle body, a sweet smell, overheating, or a sudden loss of coolant.
- Why it happens
- The upper intake on the non-supercharged 3.8L is plastic and carries coolant. It cracks with heat and age, and on some cars the leak led to overheating and engine damage. GM released new upper intake and gasket kits.
- What to do
- Stop and let the engine cool if the temperature gauge rises. Have the upper intake checked; the improved replacement part with new gaskets is the fix.
Automatic transmission fails or won't go into gear
- What you'll notice
- Slipping, flaring revs between shifts, no drive or no reverse, or the car not moving at all when put in gear.
- Why it happens
- The 4-speed automatic wears internally with age and mileage. Transmission failure is one of the most-reported Bonneville problems, often around 90,000–130,000 miles.
- What to do
- Check the fluid level and condition. If it slips or won't engage, avoid driving it and get a transmission diagnosis; a rebuild or replacement is usually needed.
Engine stalls or surges while driving
- What you'll notice
- The engine surges, loses power, or shuts off while driving or at idle, then may restart after a few minutes.
- Why it happens
- A failing crankshaft position sensor or mass airflow sensor is the most common cause reported on these cars.
- What to do
- Stalling in traffic is dangerous, so get it checked soon. A shop can test the sensors; replacing the failed sensor is usually an affordable fix.
Harsh or erratic shifting
- What you'll notice
- Hard, banging shifts, flaring between gears, erratic shift timing, and sometimes a check engine light.
- Why it happens
- GM bulletins tie these symptoms to the transmission's pressure control solenoid, which controls how firmly the gears apply.
- What to do
- Have the transmission codes read and the fluid checked. Replacing the solenoid can fix it before more damage is done.
Power window drops into the door or stops working
- What you'll notice
- A window falls down into the door, goes up crooked, makes a grinding or popping noise, or the motor runs but the glass does not move.
- Why it happens
- The window regulator's cable and plastic parts break. This is the most-reported Bonneville complaint, especially for 2000 to 2002, and GM issued a bulletin for windows that are noisy, stop working or drop.
- What to do
- Tape or prop the glass up to keep rain out until it is repaired. Usually only the regulator needs replacing.
Water leaks into the car or trunk
- What you'll notice
- Wet carpet on the front or rear floor, water in the trunk, a musty smell, or fogged windows after rain.
- Why it happens
- Water gets past body seals and seams. GM issued bulletins for floor leaks, trunk leaks and leaks around the lamps.
- What to do
- Note where the water shows up after rain or a car wash and have a body shop water-test the car. Dry the carpet quickly to prevent mold and rust.
Car won't start or starts only sometimes
- What you'll notice
- The engine won't crank, or it cranks but doesn't start, on and off with no clear pattern.
- Why it happens
- GM issued bulletins for intermittent no-start and no-crank problems traced to the ignition/start switch and to low charging voltage. Owners also report costly no-start repairs on older models.
- What to do
- Note whether the engine cranks and whether the security light flashes when it fails. Have the battery, charging system, ignition switch and anti-theft system tested.
A/C blows warm air
- What you'll notice
- The air conditioning blows warm or only slightly cool air.
- Why it happens
- GM issued a bulletin for warm air from the A/C, and owners report A/C compressor failures.
- What to do
- Have the A/C system pressures checked and leak-tested. A failed compressor or a leak is the usual cause.
Airbag or seat belt warning light stays on
- What you'll notice
- The airbag or seat belt warning light stays on, or a seat belt buckle sticks.
- Why it happens
- Owners report these lights staying on at higher mileage. GM issued a bulletin for sticking seat belt buckles that turn the warning light on.
- What to do
- Have the airbag system codes read. The airbags may not work properly while the light is on, so get it fixed.
Misfire or rough idle from fuel injector problems
- What you'll notice
- A check engine light, a rough idle, hesitation or chugging, or a hard start.
- Why it happens
- GM issued bulletins for misfires caused by corrosion at the fuel injector connections and by clogged injectors.
- What to do
- Have the misfire codes read. Cleaning or replacing injectors, or repairing the injector wiring, fixes most cases.
Rusted floor under the rear-seat battery
- What you'll notice
- Corrosion or holes in the floor pan around the battery under the rear seat, or a damp smell.
- Why it happens
- The battery sits under the rear seat on these cars. Acid fumes and moisture can corrode the floor around it, and GM issued bulletins about it.
- What to do
- When replacing the battery, look for rust and make sure the vent tube is attached. Repair rust early before it spreads.
Heat and A/C blow from the wrong vents or at the wrong temperature
- What you'll notice
- Air comes out of the wrong vents, the temperature won't change, or you hear clicking behind the dash.
- Why it happens
- Small electric motors called door actuators move the flaps that direct air and blend hot and cold. They wear out on these cars.
- What to do
- Listen for clicking behind the dash when you change settings. Replacing the failed actuator fixes it; some are easy to reach and others take more labor.
Clunk from the steering when turning
- What you'll notice
- A clunk you hear or feel in the steering wheel when turning, especially at low speed or when parking.
- Why it happens
- GM issued many bulletins for this clunk, traced to the intermediate steering shaft between the column and the steering gear.
- What to do
- Have the steering checked to rule out worn tie rods or mounts. A lubricated or replacement intermediate shaft usually fixes the noise.
Oil leak from the oil pan or rear main seal
- What you'll notice
- Oil spots under the engine, a burning oil smell, or the oil level dropping between changes.
- Why it happens
- GM issued bulletins for repeat oil pan gasket leaks and released a new rear main seal for the 3.8L.
- What to do
- Keep the oil topped up and have the leak traced. An oil pan gasket is a moderate job; a rear main seal takes much more labor.
Harsh clunk into drive or reverse when cold
- What you'll notice
- A hard clunk or jolt when shifting into drive or reverse on a cold morning.
- Why it happens
- GM issued bulletins for harsh garage shifts on cold starts in the 4-speed automatic.
- What to do
- Mention it to a shop at your next service so they can check the fluid and apply any bulletin fix.
Whine or hum from the alternator in the cabin
- What you'll notice
- A whine or hum you hear inside the car at idle and low speeds, sometimes through the speakers.
- Why it happens
- GM issued bulletins for alternator (generator) whine reaching the cabin.
- What to do
- Have the alternator and its output tested. If it is weak or noisy, replacing it usually stops the whine.
Paint bubbling on the aluminum hood
- What you'll notice
- Blisters, bubbles or corrosion under the paint on the hood.
- Why it happens
- GM issued a bulletin for early corrosion and blistering on the aluminum hood.
- What to do
- Have a body shop look at it. Small spots can be sanded and refinished; bad cases need a hood refinish or replacement.
Tilt steering column sticks in one position
- What you'll notice
- The tilt wheel won't release and stays stuck in the highest or another position.
- Why it happens
- GM issued bulletins for the tilt mechanism sticking in the steering column.
- What to do
- Don't force it. A shop can repair the tilt mechanism in the column.
Repair prices for your 2004 Pontiac Bonneville
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lower intake manifold gaskets, flush coolant and change oil
- Replace upper intake manifold and gaskets
- Replace automatic transmission with a remanufactured unit
- Replace transmission pressure control solenoid
- Replace power window regulator
- Water-test and reseal leaking seams or seals
- Replace crankshaft position sensor or mass airflow sensor
- Diagnose no-start and replace ignition switch or failed part
- Replace HVAC mode or blend door actuator
- Replace A/C compressor and recharge
- Diagnose airbag system and replace failed buckle or sensor
- Lubricate or replace intermediate steering shaft
- Clean or replace fuel injectors, or repair injector connectors
- Replace oil pan gasket or rear main seal
- Diagnose transmission and perform bulletin repair
- Treat or patch floor pan corrosion under the battery
- Replace alternator
- Strip and refinish hood
- Repair tilt mechanism in steering column
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…