Your 2005 Pontiac G6problems, repair costs and recalls
What we've documented about the 2005 Pontiac G6: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2005 Pontiac G6
19 documented issues apply to 2005, most serious first.
Electric power steering assist cuts out (recall)
- What you'll notice
- The steering suddenly gets very heavy, especially at parking-lot speeds, often with a 'Service Power Steering' message on the dash. It may come and go.
- Why it happens
- The electric power steering motor and its torque sensor in the steering column can fail or lose signal. GM recalled many G6s for this (recalls 14V-153 and 15V-064), and the problem is the most reported complaint for this car.
- What to do
- Ask a GM dealer to check your VIN for open recalls. If the recall is open, a dealer fixes it free. If it was already done and the fault returns, the steering column motor or sensor usually needs replacing.
If your car was not covered or the recall is closed, owners report a column or motor is a costly repair.
Replacement steering shaft can wear out early (recall)
- What you'll notice
- A clunk or looseness in the steering on a car that already had its intermediate steering shaft replaced. In the worst case steering control can be lost.
- Why it happens
- Some service-replacement intermediate steering shafts were made with a yoke that does not support the joint bearing well, so they can wear out early (equipment recall 14E-044).
- What to do
- If your steering shaft was ever replaced, ask a GM dealer to check whether the part is covered by this recall.
Brake lights and shifter faults from the body module connector (recall)
- What you'll notice
- Brake lights that stay on or don't come on, cruise control that won't engage, the shifter stuck in Park, or traction and stability control warning lights.
- Why it happens
- A connector at the body control module develops high resistance, which upsets the brake pedal switch signal. GM recalled 2005–2010 G6s (recall 14V-252).
- What to do
- Check that your recall was done. A dealer cleans the connector, adds grease and resets the brake pedal sensor at no charge.
Brake lights stay on or don't work from a corroded connector (recall)
- What you'll notice
- Brake lights stay lit when you are not braking, or don't light up when you press the pedal.
- Why it happens
- Corrosion in a wiring connector for the brake lamp circuit can upset the signal (recall 09V-036).
- What to do
- Make sure the recall was done. Until then, ask someone to watch the brake lights while you press the pedal.
Shift cable can break, car may not stay in Park (recall)
- What you'll notice
- The shifter shows Park but the car rolls, the gear shown doesn't match the gear you are in, or the key won't come out.
- Why it happens
- The transmission shift cable or the tabs on its end can break, or an adjuster clip may not be fully engaged. GM issued several recalls for this (14V-224, 12V-460 and 09V-073).
- What to do
- Always set the parking brake until the recall is checked. Have a dealer look up your VIN; the fix is free.
Automatic transmission shifts hard or fails
- What you'll notice
- Jolting or late shifts, especially between 20 and 40 mph, slipping, no pickup, or the transmission quitting altogether.
- Why it happens
- The 4-speed automatic used in most G6s wears internally. Owners report failures from about 45,000 to 100,000 miles.
- What to do
- Check the fluid level and condition. Get a scan for transmission codes before agreeing to a rebuild; a sensor or solenoid can sometimes be the cause.
Intake or head gasket coolant leak on the V6
- What you'll notice
- Coolant level keeps dropping, a sweet smell, oil leaks around the top of the engine, overheating, or milky oil in bad cases.
- Why it happens
- The intake manifold and head gaskets on the 3.5L and 3.9L pushrod V6 engines can leak coolant or oil as they age.
- What to do
- Watch the coolant level and temperature gauge. Get a pressure test early; a leaking gasket left alone can ruin the engine.
Clunk or pop from the steering when turning
- What you'll notice
- A clunk, pop or snapping feel in the steering wheel when turning at low speed, such as in parking lots. It can feel like the wheel catches for a moment.
- Why it happens
- The intermediate steering shaft that links the column to the steering rack wears and binds. Worn tie rod ends or a worn steering rack can cause a similar noise.
- What to do
- Have a shop check the intermediate shaft first, since it is the most common fix. Get it looked at soon if the steering ever feels loose or notchy.
Low-beam headlights keep burning out or melting the plug
- What you'll notice
- One or both low beams go dark, sometimes soon after a new bulb. The plug behind the headlight may be melted or brown.
- Why it happens
- The headlight connector and wires overheat, which burns the plug and makes bulbs fail early. Hundreds of owners report it.
- What to do
- Look at the plug when you change a bulb. If it is discolored or melted, replace the connector (pigtail) too, or the new bulb will fail.
Water pump leak
- What you'll notice
- Coolant drips at the front of the engine, low coolant warnings, or a rising temperature gauge.
- Why it happens
- Water pump seals wear out, and several owners report replacing the pump between about 55,000 and 100,000 miles.
- What to do
- Top up with the right coolant and get it fixed before the engine overheats.
Clogged or failed catalytic converter
- What you'll notice
- Check engine light, loss of power, poor fuel economy, a rotten-egg smell or a failed emissions test.
- Why it happens
- Several owners report the catalytic converter clogging or failing, sometimes after misfires or a rich-running engine.
- What to do
- Fix any misfire first. Ask a dealer whether emissions warranty still applies, then have the converter tested.
Front rotors warp early, brake pedal pulses
- What you'll notice
- A shaking steering wheel or pulsing brake pedal when stopping, often well before the pads wear out.
- Why it happens
- Owners report the front rotors warping or wearing unevenly on these cars.
- What to do
- Have the rotors measured and replaced (not just resurfaced if they are thin). Tighten wheel lugs by hand with a torque wrench to help prevent repeat warping.
Worn tie rod ends
- What you'll notice
- Loose or wandering steering, uneven tire wear, or a clunk in the front.
- Why it happens
- Tie rod ends are the single most-reported steering and suspension part in TrueDelta's owner survey for the G6.
- What to do
- Have the steering linkage checked and get an alignment after any tie rod replacement.
Front wheel bearing humming
- What you'll notice
- A hum or growl that gets louder with speed and may change when you turn.
- Why it happens
- The front wheel hub bearings wear out on these cars.
- What to do
- Have the bearing checked; a badly worn bearing can get hot or loose.
Starter failure
- What you'll notice
- A click or nothing at all when you turn the key, even with a good battery.
- Why it happens
- Starter motor failures are a common electrical complaint on the G6.
- What to do
- Have the battery and cables tested first. If they are fine, the starter is likely bad.
Clunking from the front suspension over bumps
- What you'll notice
- Clunks or rattles from the front end over bumps or rough roads, sometimes with squeaks.
- Why it happens
- Worn stabilizer bar end links and bushings, struts or control arm bushings are the usual causes.
- What to do
- Have the front suspension inspected. End links are cheap and often the cause; worn control arms or struts need sooner attention.
Oil leaks from the oil pan or valve cover gaskets
- What you'll notice
- Oil spots under the car, a burning-oil smell, or oil on the engine.
- Why it happens
- Oil pan and valve cover gaskets harden with age and start to leak.
- What to do
- Keep the oil level up and fix leaks that drip on hot exhaust parts.
Heater fan only works on some speeds
- What you'll notice
- The blower works on high but not the lower settings, or stops and starts.
- Why it happens
- The blower motor resistor or control fails.
- What to do
- A blower resistor is a cheap part and usually the fix.
Rear center child seat anchors and manual mismatch (recall)
- What you'll notice
- No symptoms. The manual says lower child-seat anchors are only at the outboard seats.
- Why it happens
- The center rear lower anchors were placed differently from federal test rules, and the manual was wrong (recall 05V-098).
- What to do
- Use the outboard rear seats for car seats with lower anchors and check the recall status.
Repair prices for your 2005 Pontiac G6
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace intermediate steering shaft
- Rebuild or replace automatic transmission
- Replace headlight bulb and melted connector pigtail
- Replace lower intake manifold gaskets and refill coolant
- Replace water pump and refill coolant
- Replace catalytic converter
- Replace front brake pads and rotors
- Replace front stabilizer end links (and bushings)
- Replace outer tie rod ends and align
- Replace front wheel hub bearing
- Replace starter
- Replace oil pan or valve cover gasket
- Replace blower motor resistor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace power steering motor, sensor or columnNo charge if your vehicle is included
- Replace recalled intermediate steering shaftNo charge if your vehicle is included
- Clean and grease body module connector, relearn brake sensorNo charge if your vehicle is included
- Repair brake lamp wiring connectorNo charge if your vehicle is included
- Replace or secure transmission shift cableNo charge if your vehicle is included
- Owner's manual insertNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…