Your 2008 Pontiac G8problems, repair costs and recalls
What we've documented about the 2008 Pontiac G8: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2008 Pontiac G8
28 documented issues apply to 2008, most serious first.
Collapsed lifter and worn camshaft on the 6.0L V8
- What you'll notice
- A tapping or ticking from the engine that is louder when cold and does not go away, a rough idle or misfire, and sometimes a check engine light.
- Why it happens
- The 6.0L V8 shuts off four cylinders to save fuel. The special lifters that do this can stick or collapse, and a failed lifter then chews up the camshaft lobe. GM issued service bulletins on lifter noise.
- What to do
- Do not ignore a new ticking noise. Have it diagnosed soon; catching it early can mean replacing lifters before the camshaft or more of the engine is damaged.
Timing chain stretch on the 3.6L V6
- What you'll notice
- Check engine light with cam and crank timing codes such as P0011, P0014, P0021, P0024, P0016 or P0008, sometimes with a rattle on start-up or rough running.
- Why it happens
- The timing chains on this V6 can stretch early, especially with long oil-change intervals, so the cam timing drifts out of range.
- What to do
- Have the codes read. Change the oil on time with the right oil. A stretched chain should be replaced before it skips or breaks, which can wreck the engine.
Engine computer failure (P0601) and reduced power
- What you'll notice
- Check engine light with code P0601, sudden reduced-power mode, or the engine shutting down.
- Why it happens
- Several owners report the engine control module (ECM) failing internally or needing reprogramming.
- What to do
- If the car drops into reduced power, get off the road safely. Have a shop confirm the ECM fault and try a software update before replacing it.
Fuel pump or fuel level sender failure
- What you'll notice
- Cranks but will not start, stalls, a gas gauge that reads wrong, or a fuel smell.
- Why it happens
- The G8 has a two-sided fuel tank with a pump and level senders that can fail.
- What to do
- If you smell fuel, do not drive it. For a no-start, have fuel pressure checked.
Front seat belt cable can break (recall)
- What you'll notice
- No warning; the belt may not hold you in a crash.
- Why it happens
- The cable for the front outboard seat belt tensioner can bend and break when people sit on it getting in. Recall 15V-399 fits a revised part.
- What to do
- Ask the dealer to confirm the recall applies to your VIN and have the free repair done.
Knee can knock the key out of Run (recall)
- What you'll notice
- The engine can shut off if your knee hits the key fob while driving, which cuts power steering and power brakes and can stop the airbags from deploying.
- Why it happens
- The flip key hangs where a driver's knee can bump it. Recall 14V-540 fits a revised key blade and housing.
- What to do
- Until it is fixed, set the seat and steering wheel so your knee clears the key. Check your VIN and get the free repair.
Brake lights may stay off and tire warning may be late (recall)
- What you'll notice
- Brake lights may not light when you brake, and the low tire pressure warning may not come on until pressure is very low.
- Why it happens
- The brake pedal position sensor and the tire pressure settings were programmed wrong. Recall 09V-172 reprograms both.
- What to do
- Have someone check your brake lights, and check your VIN for this recall.
Front lower control arm clunk and worn ball joints
- What you'll notice
- Clunking or rattling from the front over bumps, creaking when turning, a loose feel or shake under braking.
- Why it happens
- The front lower control arms (also called tension struts) have bushings and ball joints that wear out early. This is the most reported G8 repair, and GM issued a service bulletin for it.
- What to do
- Have the front suspension inspected. Badly worn ball joints are a safety risk, so do not wait long if a shop finds play.
Oil pan gasket and rear main seal leaks
- What you'll notice
- Oil spots under the car, oil on the bottom of the engine or transmission bell housing, or a burning oil smell.
- Why it happens
- The V8 oil pan gasket and rear main seal are frequent leak points; some pans were even porous.
- What to do
- Check the oil level often and watch for drips. Have the source traced before replacing parts.
Vibration in four-cylinder mode from worn engine mounts
- What you'll notice
- A buzz or shake through the car while cruising when the V8 switches to four-cylinder mode.
- Why it happens
- The 6.0L runs on four cylinders at light load, and worn or soft engine mounts let that vibration into the cabin.
- What to do
- Have the engine and transmission mounts checked.
Oil pressure sensor code P0521
- What you'll notice
- Check engine light with P0521, or the oil pressure gauge jumps around.
- Why it happens
- The oil pressure sender or its screen can fail or clog. GM issued bulletins for it. In rare cases a real low-pressure problem is behind the code.
- What to do
- Check the oil level first. If the gauge drops to zero or you hear knocking, stop the engine right away. Otherwise have the sender and screen replaced.
Electronic throttle body failure
- What you'll notice
- Check engine light and reduced power, or poor throttle response.
- Why it happens
- The electronic throttle body can fail, and the computer limits power to protect the engine.
- What to do
- Have the codes read. Cleaning sometimes helps, but a failed unit must be replaced.
Alternator failure
- What you'll notice
- Battery or charging light, dim lights, a whining noise, or a dead battery.
- Why it happens
- The alternator is one of the most common G8 electrical repairs; bearings and charging output fail.
- What to do
- Have the charging system tested. If the battery light is on, drive straight to a shop; the car may stall when the battery runs down.
Harmonic balancer wobbles or fails
- What you'll notice
- A wobbling crank pulley, belt squeal or chirp, or a vibration at idle.
- Why it happens
- The rubber in the crank damper (harmonic balancer) can separate so the outer ring wobbles.
- What to do
- Have it replaced soon; a failing balancer can throw the drive belt and damage the crank.
Automatic transmission flares, slips or shifts harshly
- What you'll notice
- Engine revs flare between gears, harsh or late shifts, a slip, or limp mode.
- Why it happens
- Owners report shift problems fixed by software updates, and some needed internal parts such as the front pump or a clutch pack.
- What to do
- Ask a dealer about transmission software updates first, and have the fluid checked.
Driveline vibration at highway speed
- What you'll notice
- A vibration through the floor or steering wheel at highway speeds.
- Why it happens
- Some cars needed the driveshaft re-indexed or replaced, or the driveshaft center bearing replaced.
- What to do
- Have the wheels balanced first, then ask a shop to check the driveshaft.
Front strut mounts knock or struts wear
- What you'll notice
- Knocking or creaking from the front when turning or over bumps, or a bouncy ride.
- Why it happens
- Upper strut mounts and bearings wear out early, and struts lose damping.
- What to do
- Have the strut mounts and struts inspected along with the control arms.
ABS light from a broken rear wheel speed sensor wire
- What you'll notice
- ABS and traction control lights come on.
- Why it happens
- The wiring to the rear wheel speed sensors can break at the connector, or a sensor fails.
- What to do
- Normal brakes still work, but ABS may not. Have the codes read and the sensor or harness repaired.
Airbag light from the passenger seat sensor
- What you'll notice
- The airbag light comes on, or the passenger airbag-off light behaves wrongly.
- Why it happens
- The passenger seat occupant sensor or the airbag module can fail.
- What to do
- Treat the passenger airbag as not working until it is fixed. Have the airbag codes read.
Third brake light segments burn out
- What you'll notice
- Part or all of the high-mounted center brake light stays dark.
- Why it happens
- The LED segments in the center high-mounted stop lamp fail.
- What to do
- Have it replaced; brake lights warn drivers behind you.
A/C belt slips or comes off
- What you'll notice
- Squeal, or the A/C stops cooling because the belt has come off.
- Why it happens
- A separate A/C drive belt and its bracket or pulley can let the belt walk off. GM issued a bulletin for the bracket.
- What to do
- Have the belt, tensioner and bracket checked.
Door lock actuators fail
- What you'll notice
- A door will not lock or unlock with the remote or switch, locks slowly, or the door will not latch.
- Why it happens
- Door lock actuators and latch assemblies wear out or freeze.
- What to do
- Have the affected door actuator replaced. A door that will not latch shut needs fixing right away.
Sway bar end links clunk
- What you'll notice
- A knock or clunk over small bumps at low speed.
- Why it happens
- The sway bar end links and bushings wear and come loose.
- What to do
- Have the links checked; they are an inexpensive repair.
Check engine light from the gas cap or EVAP system
- What you'll notice
- A steady check engine light, often with codes P0455, P0442 or P0449.
- Why it happens
- A gas cap that does not seal or a failed EVAP purge or vent solenoid lets fuel vapor escape. GM replaced caps under a bulletin.
- What to do
- Tighten the gas cap until it clicks. If the light returns, have the EVAP system tested.
Tire pressure warning faults
- What you'll notice
- The tire pressure light stays on or the display shows dashes even when tires are full.
- Why it happens
- Tire pressure sensor batteries die with age, and the receiver can fail.
- What to do
- Check all tire pressures by hand first. Then have the sensors scanned and replaced as needed.
Power window stops working
- What you'll notice
- A window will not go up or down, works only sometimes, or streaks on the glass.
- Why it happens
- Window motors, window control boards and wiring fail; some owners needed several repairs.
- What to do
- If a window is stuck open, cover it and have the motor or switch diagnosed.
Hood release cable breaks
- What you'll notice
- The hood will not open when you pull the release.
- Why it happens
- The hood release cable or latch can break.
- What to do
- A shop can open the latch from underneath and replace the cable.
Water leaks into the trunk
- What you'll notice
- Damp carpet or water in the trunk.
- Why it happens
- A failed wiring grommet or a door or window seal can let water in.
- What to do
- Have the car water-tested to find the entry point, and dry it out to prevent mold and electrical damage.
Repair prices for your 2008 Pontiac G8
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace camshaft, all 16 lifters and gaskets
- Replace timing chains, tensioners and guides
- Replace front lower control arms (pair)
- Replace oil pan gasket
- Replace engine mounts (pair)
- Replace oil pressure sender and screen
- Replace and program engine control module
- Replace throttle body
- Replace alternator
- Replace harmonic balancer
- Replace A/C belt and tensioner
- Replace fuel pump module
- Replace door lock actuator
- Replace front struts and mounts (pair)
- Replace sway bar end links (pair)
- Replace rear wheel speed sensor or repair harness
- Replace gas cap or EVAP purge solenoid
- Replace tire pressure sensors
- Replace passenger occupant sensor
- Replace window motor or regulator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall 15V-399 seat belt tensioner replacementNo charge if your vehicle is included
- Recall 14V-540 key blade and housingNo charge if your vehicle is included
- Recall 09V-172 reprogrammingNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…