Your 2009 Pontiac Vibeproblems, repair costs and recalls
What we've documented about the 2009 Pontiac Vibe: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2009 Pontiac Vibe
21 documented issues apply to 2009, most serious first.
Passenger airbag inflator can rupture (Takata recall)
- What you'll notice
- Usually no warning signs. In a crash the passenger airbag inflator can burst and throw metal pieces into the cabin.
- Why it happens
- The Vibe uses a Takata passenger airbag inflator whose propellant breaks down over years of heat and humidity. Every model year is covered by recalls (including 15V-285, 15V-286, 16V-127, 16V-128, 16V-340, 17V-006, 18V-024, 18V-025 and 18V-883).
- What to do
- Ask the dealer to check your VIN for open recalls today. If the recall is open, don't let anyone ride in the front passenger seat until a dealer replaces the inflator for free.
Accelerator pedal can stick (recall)
- What you'll notice
- The gas pedal feels stiff, comes back up slowly, or stays partly down.
- Why it happens
- Condensation can add friction inside the pedal's sensor (recall 10V-018).
- What to do
- If it happens, brake firmly and shift to Neutral. Make sure the pedal recall was done.
Floor mat can trap the gas pedal (recall)
- What you'll notice
- The gas pedal sticks down, causing the car to speed up.
- Why it happens
- A loose or wrong floor mat can catch the pedal (recall 10V-024).
- What to do
- Use only the correct mat, held by its clips, and never stack mats. Check the recall.
Power window master switch can overheat (recall)
- What you'll notice
- The driver's window switch feels hot, works erratically, smells burnt or melts.
- Why it happens
- The switch may lack enough grease, letting it short and overheat (recalls 12V-491 and 15V-689).
- What to do
- Stop using the switch if it smells or feels hot, and get the recall done.
Driver airbag light from a damaged spiral cable (recall)
- What you'll notice
- The airbag warning light comes on, and the horn may stop working.
- Why it happens
- A flat cable in the steering column can get damaged so the driver airbag is disconnected (recall 14V-168).
- What to do
- Have the airbag light checked and the recall done right away.
Brake assist can freeze in extreme cold (recall)
- What you'll notice
- In very cold weather the brake pedal feels hard and the car takes longer to stop.
- Why it happens
- Moisture can freeze in the brake booster vacuum port (recall 09V-392).
- What to do
- Check that the recall was done, especially if you live somewhere very cold.
Excessive oil consumption
- What you'll notice
- Burning about a quart every 1,000 miles or more, low oil with no leak, and sometimes the dipstick reads empty.
- Why it happens
- The 2.4L engine's piston rings can wear early. Toyota covered the same engine on its own cars, but owners say GM did not extend coverage for the Vibe.
- What to do
- Check the oil at every fill-up and top it up. Running it low can ruin the engine. A shop can do an oil consumption test to confirm.
Rusted brake or fuel lines
- What you'll notice
- Brake fluid leak, soft pedal, or a gas smell, mainly in salt-belt states.
- Why it happens
- Steel brake and fuel lines under the car can corrode badly with age.
- What to do
- Have the lines inspected at every brake job. Replace rusty lines before they burst.
Wheel bearing hum
- What you'll notice
- A hum or growl that gets louder at highway speed.
- Why it happens
- Wheel bearings and hubs are the most-reported repair on the Vibe, especially at higher mileage.
- What to do
- Have the bearing checked and replaced before it gets loose.
Alternator failure, battery light on
- What you'll notice
- The battery warning light comes on, lights dim, or the car dies after the battery drains.
- Why it happens
- The alternator is one of the most-reported Vibe repairs.
- What to do
- Have the charging system tested. Rebuilt alternators are a cheaper option.
Starter clicks but won't crank
- What you'll notice
- A single click or nothing when you turn the key.
- Why it happens
- A weak battery or worn starter are the usual causes.
- What to do
- Test the battery first. If it is good, the starter likely needs replacing.
Water pump leak
- What you'll notice
- Low coolant, pink crusty residue or coolant spray near the drive belt, or a squeal before it fails.
- Why it happens
- The water pump seal and bearing wear out.
- What to do
- Top up with the right coolant and replace the pump before the engine overheats.
Intake manifold gasket vacuum leak
- What you'll notice
- Check engine light, rough idle or a hissing sound.
- Why it happens
- The intake manifold gasket can leak air.
- What to do
- The gasket is cheap. Have a shop smoke-test the intake to confirm.
Misfire from a failed ignition coil
- What you'll notice
- Shaking, rough running, a flashing check engine light, misfire codes.
- Why it happens
- Individual ignition coils fail.
- What to do
- Replace the bad coil, and change all spark plugs if they are old.
Sticking brake caliper
- What you'll notice
- The car pulls, a burning smell, or one wheel very hot after driving.
- Why it happens
- Brake calipers are among the most-reported Vibe repairs.
- What to do
- Have the brakes inspected; a stuck caliper wears pads and rotors fast.
Check engine light from the rear oxygen sensor
- What you'll notice
- Check engine light with code P0138.
- Why it happens
- The downstream oxygen sensor fails.
- What to do
- Replacing the sensor is a simple job.
Oil leak from the valve cover or timing chain tensioner
- What you'll notice
- Oil seeping at the top or back of the engine, or a burning-oil smell.
- Why it happens
- The valve cover gasket and the timing chain tensioner seal harden and leak.
- What to do
- Both fixes are fairly simple and cheap; don't let oil drip on the exhaust.
Brake pedal pulsates from worn front rotors
- What you'll notice
- The brake pedal or steering wheel shakes when braking.
- Why it happens
- The front rotors wear unevenly.
- What to do
- Replace or resurface the rotors with new pads.
Clicking from the dash or blower problems
- What you'll notice
- Clicking behind the dash when changing air settings, or a blower that works on only some speeds.
- Why it happens
- The fresh/recirculate air door motor, blower motor and blower resistor are common repairs.
- What to do
- A shop can find which part failed. These are fairly cheap repairs.
Exhaust leak or rattling heat shield
- What you'll notice
- A louder exhaust, ticking, or a tinny rattle from under the car.
- Why it happens
- Flex pipes rust through and heat shields come loose.
- What to do
- A muffler shop can often weld or clamp it cheaply.
Check engine light from the gas cap
- What you'll notice
- Check engine light with an evaporative leak code.
- Why it happens
- A worn or loose gas cap lets fuel vapor escape.
- What to do
- Tighten the cap until it clicks. If the light stays on after a few drives, replace the cap.
Repair prices for your 2009 Pontiac Vibe
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace pistons and rings (or engine)
- Replace wheel bearing / hub
- Replace alternator
- Replace starter
- Replace water pump and refill coolant
- Replace intake manifold gasket
- Replace downstream oxygen sensor
- Replace ignition coil
- Replace valve cover gasket or tensioner seal
- Replace front brake pads and rotors
- Replace brake caliper
- Replace air door actuator or blower resistor
- Replace exhaust flex pipe or secure heat shield
- Replace gas cap
- Replace corroded brake lines
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace passenger airbag inflatorNo charge if your vehicle is included
- Install pedal reinforcement or replace pedalNo charge if your vehicle is included
- Reshape pedal and floor, replace matsNo charge if your vehicle is included
- Grease or replace window master switchNo charge if your vehicle is included
- Replace steering column spiral cableNo charge if your vehicle is included
- Replace brake booster vacuum connectorNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…