Your 2003 Saturn Ionproblems, repair costs and recalls
What we've documented about the 2003 Saturn Ion: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Saturn Ion
12 documented issues apply to 2003, most serious first.
Ignition switch can slip out of Run (recall)
- What you'll notice
- The engine shuts off without warning while driving, often after a bump or when your knee brushes a heavy key ring. Steering and brakes suddenly take much more effort.
- Why it happens
- The ignition switch was built with too little turning resistance, so the key can be knocked from Run to Accessory. That stops the engine and can keep the airbags from deploying in a crash. GM recall 14V-047 replaces the switch.
- What to do
- Check your VIN for open recall 14V-047 right away. Until it is done, carry only the ignition key on the ring with nothing hanging from it.
VTi CVT transmission slips or fails
- What you'll notice
- The car revs but does not pick up speed, jerks, makes loud whining or grinding noises, or will not move in Drive or Reverse.
- Why it happens
- Automatic 2003-2004 Ions used GM's VTi continuously variable transmission (CVT), which had a high failure rate. GM extended its warranty and later settled a class action lawsuit over it.
- What to do
- Stop driving hard if it slips. Get a transmission diagnosis; most failed units are replaced rather than repaired. Keep your repair receipts.
Key can come out when not in Off (recall)
- What you'll notice
- You can pull the key out even though the ignition is not fully turned to Off.
- Why it happens
- Wear in the ignition lock cylinder lets the key come out too early. On an automatic the car may not be locked in Park and could roll away. GM recall 14V-171 fixes the lock cylinder.
- What to do
- Always set the parking brake when you park. Check your VIN for open recall 14V-171.
Timing chain rattle and tensioner failure
- What you'll notice
- A rattle from the engine at cold start or idle, a check engine light for cam timing codes such as P0016, rough running, or in the worst case a no-start.
- Why it happens
- The timing chain tensioner and guides wear out, and on early 2.2L engines the tensioner did not get enough oil at idle. Low or old oil speeds it up and lets the chain stretch.
- What to do
- Keep the oil full and changed on time. If you hear the rattle or get timing codes, have the chain, guides and tensioner replaced before the chain jumps a tooth and damages the engine.
Fuel filter can corrode and leak (recall)
- What you'll notice
- A gasoline smell or drips of fuel under the car near the fuel filter.
- Why it happens
- The outer shell of the fuel filter can rust through and leak gas, which could catch fire. GM recall 04V-003 replaces the filter.
- What to do
- If you smell fuel, park it outside and check your VIN for open recall 04V-003.
Aftermarket replacement ignition switch can slip (recall)
- What you'll notice
- The engine shuts off while driving on a car that has had its ignition switch replaced with an aftermarket part.
- Why it happens
- Some aftermarket replacement ignition switches had the same weak design and could slip from Run to Accessory. Recall 14E-021 covers those parts.
- What to do
- If your ignition switch was ever replaced outside the dealer, ask a dealer to check which switch is installed.
Intermittent no-crank or no-start
- What you'll notice
- Some days you turn the key and nothing happens, or the engine cranks but does not start. Then it starts fine later.
- Why it happens
- Owners trace this to a worn ignition switch or its wiring. A weak battery connection or a fault in the anti-theft system can cause the same symptom.
- What to do
- Note whether the dash lights come on and whether the engine cranks; that helps a shop find it. Ask them to check the ignition switch and its connector first.
Intake manifold gasket leak
- What you'll notice
- Rough idle, misfires, weak acceleration, a check engine light, and sometimes a milky residue under the oil cap.
- Why it happens
- The intake manifold gasket on the early Ecotec 2.2L is a known weak spot and can leak air or coolant as it ages.
- What to do
- Have a shop smoke-test for vacuum leaks and check for coolant loss. Replacing the gasket is a modest job if done before other damage.
Front turn signal may not work (recall)
- What you'll notice
- A front turn signal does not flash, or the dash signal flashes fast.
- Why it happens
- The bulb design shared by the front turn signal and daytime running light could stop the turn signal from working. GM recall 04V-547 fixes it.
- What to do
- Check your turn signals by walking around the car. Check your VIN for open recall 04V-547.
Misfire from ignition coil or module failure
- What you'll notice
- The engine shakes or stumbles, loses power, and the check engine light may flash.
- Why it happens
- The ignition coil pack (ignition module) that fires the spark plugs can fail with age and heat.
- What to do
- Have the misfire codes read. A flashing check engine light means you should ease off and get it in soon to protect the catalytic converter.
Anti-theft system blocks starting
- What you'll notice
- The engine cranks but won't start, or won't crank, and the security light stays on or flashes.
- Why it happens
- The Passlock anti-theft system misreads the ignition and shuts off fuel to the engine. A fault in the ignition switch sensor or the theft-deterrent module is usually behind it.
- What to do
- Leave the key in On for about 10 minutes until the security light stops flashing, then try again. If it keeps happening, a shop can test the ignition switch and theft module.
Power window and sunroof switches miss child-safety rule (recall)
- What you'll notice
- No symptom; the windows and sunroof work normally.
- Why it happens
- The power window and sunroof switches did not meet the federal rule meant to stop a child from closing a window on themselves by accident. GM recall 04V-004 changed the switches.
- What to do
- Never leave children alone in the car with the key in it. Check your VIN for open recall 04V-004.
Repair prices for your 2003 Saturn Ion
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace CVT with a remanufactured or used unit
- Replace ignition switch
- Replace timing chain, guides and tensioner
- Replace intake manifold gasket
- Replace ignition coil pack
- Diagnose Passlock system; replace ignition switch sensor or theft module
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ignition switch (recall 14V-047)No charge if your vehicle is included
- Replace ignition lock cylinder and keys (recall 14V-171)No charge if your vehicle is included
- Replace fuel filter (recall 04V-003)No charge if your vehicle is included
- Front turn signal fix (recall 04V-547)No charge if your vehicle is included
- Replace window and sunroof switches (recall 04V-004)No charge if your vehicle is included
- Replace aftermarket ignition switch (recall 14E-021)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…