Your 2000 Saturn L-Seriesproblems, repair costs and recalls
What we've documented about the 2000 Saturn L-Series: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Saturn L-Series
12 documented issues apply to 2000, most serious first.
Timing chain rattle or breakage
- What you'll notice
- A rattle from the engine, especially on cold starts, misfires or rough idle. If the chain breaks, the engine dies suddenly while driving and won't restart.
- Why it happens
- On early 2.2L engines the timing chain tensioner gets too little oil at idle and wears out, letting the chain slap and stretch. A broken chain can bend valves.
- What to do
- Keep the oil full and changed on time. If you hear a rattle, have the chain, guides and tensioner replaced before the chain breaks and ruins the engine.
Ignition module failure causes rough idle and power loss (recall)
- What you'll notice
- Rough idle, loss of power, hard starting and a flashing Service Engine Soon light. Later, a louder exhaust.
- Why it happens
- The ignition control module on early 2.2L cars can fail. Driving on with misfires can damage the catalytic converter, oxygen sensor and exhaust resonator, and a failed resonator can lead to a fire. GM recalled about 240,000 cars (NHTSA 03V231).
- What to do
- Stop driving with a flashing engine light. Have a dealer check your VIN; the recall replaces the module and may include new plugs and a computer update.
Timing belt failure can wreck the engine
- What you'll notice
- Usually no warning. The engine suddenly stops and won't start, or it slips a tooth and runs badly with a check engine light.
- Why it happens
- The 3.0L V6 uses a rubber timing belt that must be replaced on schedule. Owners report belts slipping or breaking and destroying the engine when it was skipped.
- What to do
- If you don't have proof it was done, replace the timing belt, tensioner and idler pulleys now. Doing the water pump at the same time saves labor.
Harsh or erratic automatic shifting
- What you'll notice
- Hard shifts, especially from first to second, a check engine or wrench light, or a transmission stuck in one gear until the car is restarted.
- Why it happens
- Owners trace many cases to a failed pressure control solenoid or other valve body solenoids. Some transmissions need a full rebuild or replacement.
- What to do
- Have the codes read and the fluid checked. Ask the shop about GM service bulletins for the solenoids before agreeing to a replacement transmission.
Fuel tank valve could spill fuel in a rollover (recall)
- What you'll notice
- No symptom in normal driving.
- Why it happens
- A fuel tank valve could be inoperative or stick open in a crash, letting fuel spill in a rollover. GM issued two recalls (NHTSA 99V197 and 99V345).
- What to do
- Have a dealer check your VIN for both campaigns.
A/C stops blowing cold from a failed compressor
- What you'll notice
- The A/C blows warm air, the compressor clutch doesn't engage, or there is a burning belt smell when the A/C runs.
- Why it happens
- Owners report A/C compressor and clutch failures on both engines, often between 60,000 and 120,000 miles. Leaking hoses, condensers and evaporators also show up.
- What to do
- Have the system checked for leaks and the compressor clutch tested before recharging. Replace the receiver-drier along with the compressor.
No-start or stalling from a failed crankshaft sensor
- What you'll notice
- The engine cranks but won't start, or stalls and won't restart until it cools down.
- Why it happens
- The crankshaft position sensor tells the computer when to fire the plugs. When it fails, the engine gets no spark.
- What to do
- Have the codes read; a scan tool can show whether the sensor is sending a signal while cranking.
Check engine light with rough running
- What you'll notice
- Check engine light, rough idle, misfires, backfiring, stalling or weak acceleration.
- Why it happens
- Owners trace these to failed oxygen sensors, the EGR valve, the MAP sensor, ignition coils or vacuum leaks.
- What to do
- Have the codes read and fix the specific fault. Don't ignore a flashing light; misfires can ruin the catalytic converters.
Turn signals can stop working from the hazard switch (recall)
- What you'll notice
- The turn signals stop working.
- Why it happens
- A faulty hazard warning switch can disable the turn signals. GM recalled these cars (NHTSA 99V199) to replace the switch.
- What to do
- Have a dealer check your VIN for open recall work.
Rear seat belt buckles may not hold (recall)
- What you'll notice
- No symptom in normal use.
- Why it happens
- Some TRW buckle bases were not heat treated correctly and may not hold in a crash. GM recalled affected cars (NHTSA 00V228).
- What to do
- Have a dealer check your VIN; affected rear buckles are replaced free.
Wheel bearing hum or grinding
- What you'll notice
- A hum or growl that gets louder with speed, sometimes changing in turns.
- Why it happens
- Front and rear wheel bearings wear out on higher-mileage cars.
- What to do
- Have the hubs checked for play and noise and replace the worn one.
Power steering pump, hose or rack leaks
- What you'll notice
- Power steering fluid leaks, a whining pump, rough or heavy steering in turns.
- Why it happens
- Owners report leaking pumps, corroded return lines and worn steering racks.
- What to do
- Keep the fluid topped off and find the leak; running the pump dry destroys it.
Repair prices for your 2000 Saturn L-Series
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace timing chain, guides and tensioner (2.2L)
- Replace timing belt, tensioner and idlers (3.0L V6)
- Replace A/C compressor, receiver-drier and recharge
- Replace pressure control solenoid / valve body solenoids
- Replace crankshaft position sensor (3.0L V6)
- Diagnose and replace oxygen sensor, EGR valve or coil
- Replace wheel hub and bearing assembly, one wheel
- Replace power steering pump or hose (rack in worse cases)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ignition control moduleNo charge if your vehicle is included
- Replace hazard switchNo charge if your vehicle is included
- Seal or replace fuel tank valveNo charge if your vehicle is included
- Replace rear seat belt bucklesNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…