Your 2007 Saturn Relayproblems, repair costs and recalls
What we've documented about the 2007 Saturn Relay: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Saturn Relay
15 documented issues apply to 2007, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- The engine revs up but the van doesn't speed up to match, shifts come late or not at all, or the van struggles to move. The check engine light may come on.
- Why it happens
- The four-speed automatic in this van wears its internal clutches, especially with high mileage, heavy loads or old fluid. GM issued service bulletins for slipping, no-shift and overheating conditions on this transmission.
- What to do
- Check the transmission fluid level and smell (burnt fluid is a bad sign). If it is slipping, drive gently and get a transmission diagnosis soon; continuing to drive can turn a repair into a full replacement.
ABS and traction lights on, or brakes applying by themselves
- What you'll notice
- The ABS and traction control lights come on and may stay on. Some owners report the brakes grabbing or the van pulling to one side without pressing the pedal, or traction control kicking in at highway speed.
- Why it happens
- Faults in the electronic brake control module, a front wheel speed sensor or the front hub that carries the sensor confuse the anti-lock and traction systems. Owners often report repeated repairs before the cause was found.
- What to do
- Normal braking usually still works with the ABS light on, but if the brakes apply by themselves, stop driving and have it towed. Have the stored ABS codes read to find which sensor or module is failing.
Some aftermarket replacement steering knuckles can break (recall)
- What you'll notice
- No warning before failure. Applies only if a front steering knuckle was replaced with certain Dorman or NAPA aftermarket parts.
- Why it happens
- Some aftermarket replacement knuckles sold under the Dorman OE Solutions and NAPA brands could crack in the hub area, which could cause loss of steering control.
- What to do
- If your van has had front knuckle work, ask the shop which brand was used. Affected parts are replaced free under recall 09E005.
Dorman replaces the part and reimburses labor.
Shudder or harsh shift from first to second gear
- What you'll notice
- A shake or shudder as the van shifts from first to second under light or moderate throttle, or shifts that feel harsh or jerky.
- Why it happens
- GM bulletins for this four-speed automatic describe a worn second-gear clutch causing a 1-2 shudder, and valve body wear causing harsh shifts or slipping.
- What to do
- Have a transmission shop or dealer road-test it and check the fluid. Fixing a shudder early is far cheaper than waiting for the transmission to slip.
Brake pedal pulsation from uneven front rotors
- What you'll notice
- The brake pedal or steering wheel pulses or vibrates when you slow down, sometimes soon after new brakes.
- Why it happens
- The front rotors develop uneven thickness. GM issued a bulletin to correct rotor variation and fit new front brake shields on these vans.
- What to do
- Have the front rotors measured. Resurfacing or replacing them, with the hub surface cleaned and lug nuts torqued evenly, usually cures it.
Power sliding door won't close, reopens or stops working
- What you'll notice
- The power sliding door stops partway, reverses and reopens, won't latch, or won't respond to the button or key fob.
- Why it happens
- Worn rollers, out-of-adjustment tracks, a failing door motor or control module, or obstruction sensors cause trouble. GM published several bulletins on adjusting and repairing these doors.
- What to do
- Clean and lightly lubricate the door track. If it still misbehaves, have a shop check door adjustment and the door module. Don't drive with a door that won't latch fully.
Coolant leak from crossover pipe gaskets
- What you'll notice
- Coolant level keeps dropping, a sweet smell after driving, or dried coolant crust on top of the engine.
- Why it happens
- The gaskets on the coolant crossover pipe at the top of the V6 leak. GM issued a bulletin to replace them on both the 3.5L and 3.9L.
- What to do
- Keep the coolant topped up with the correct coolant and watch the temperature gauge. If it starts to overheat, pull over and shut it off. Get the gaskets replaced before the leak gets worse.
Groaning, clunk or knock when turning
- What you'll notice
- A groan, moan, clunk or knock when you turn the steering wheel, often worse in cold weather or at low speed.
- Why it happens
- Causes include the power steering fluid and pump in cold weather, the intermediate steering shaft and worn steering linkage. GM issued bulletins for steering noise in cold temperatures and for clunk and knock noises.
- What to do
- Check the power steering fluid level. Have a shop find the noise source, and get it checked promptly if the steering also feels loose or stiff.
Power steering high-pressure hose leak
- What you'll notice
- Reddish fluid drips near the front of the engine, the power steering fluid runs low, or the steering whines and gets heavy.
- Why it happens
- The high-pressure power steering hose on this van commonly starts to leak, often around 80,000 miles.
- What to do
- Top up the fluid and get the hose replaced soon. Fluid dripping onto a hot exhaust can smoke, and running the pump dry can ruin it.
Front wheel bearing hum or wheel speed sensor fault
- What you'll notice
- A hum or growl from a front wheel that gets louder with speed, sometimes with the ABS light on.
- Why it happens
- The front hub and bearing assembly wears out, and the ABS wheel speed sensor is built into it, so a bad hub can also set ABS codes.
- What to do
- Get it checked soon. A badly worn bearing can overheat and in extreme cases let the wheel wobble. The fix is a new hub assembly.
Fuel gauge reads wrong or low fuel light stays on
- What you'll notice
- The gauge shows fuel when the tank is nearly empty, won't read full after filling, or the low fuel light comes on with plenty of fuel.
- Why it happens
- Sulfur in some gasoline corrodes the fuel level sender inside the tank, so it sends the wrong reading. GM issued a bulletin to replace the sensor.
- What to do
- Track your mileage between fill-ups so you don't run out. A shop can replace the level sender, which sits in the fuel pump module.
Oil leak at the oil pan or front crankshaft seal
- What you'll notice
- Oil spots under the front of the van, oily residue on the side of the oil pan, or a burning oil smell.
- Why it happens
- The oil pan seal and the front crankshaft (balancer) seal on these V6 engines are known to leak with age. GM issued bulletins on both.
- What to do
- Check the oil level regularly and top up. Have the leak source confirmed and repaired before it soaks the belts or drips on hot exhaust parts.
Rear shocks leak or wear out
- What you'll notice
- The rear of the van bounces or sags, or there is oily residue on the rear shocks.
- Why it happens
- Owners report the rear shocks leaking and needing replacement, sometimes at fairly low mileage.
- What to do
- Have the shocks inspected. Worn shocks make the van less stable when loaded, so replace them in pairs.
Rear wiper stops working
- What you'll notice
- The rear wiper won't move or stops partway.
- Why it happens
- The rear wiper motor in the liftgate fails.
- What to do
- Check the fuse first. If the fuse is fine, the motor usually needs replacing.
Check engine light from a loose or worn gas cap
- What you'll notice
- The check engine light comes on, often after filling up, with no change in how the van drives.
- Why it happens
- A gas cap that is loose or has a worn seal lets fuel vapor escape, which the evaporative emissions system reports as a leak.
- What to do
- Tighten the cap until it clicks. If the light stays on after a few days of driving, replace the cap and have the code read.
Repair prices for your 2007 Saturn Relay
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with remanufactured unit
- Diagnose; replace second clutch pack or recondition valve body
- Diagnose ABS; replace wheel speed sensor/hub or brake control module
- Replace front brake pads and rotors
- Adjust door; replace rollers, cable, motor or door module
- Replace fuel level sender or fuel pump module
- Replace coolant crossover pipe gaskets and refill coolant
- Replace oil pan gasket or front crankshaft seal
- Flush power steering fluid or replace intermediate shaft/tie rods
- Replace power steering high-pressure hose
- Replace front wheel hub and bearing assembly
- Replace rear shocks (pair)
- Replace rear wiper motor
- Replace gas cap
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace recalled aftermarket steering knuckle (Dorman recall)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…