Your 2006 Scion xAproblems, repair costs and recalls
What we've documented about the 2006 Scion xA: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2006 Scion xA
20 documented issues apply to 2006, most serious first.
Airbag control module can short out (recall)
- What you'll notice
- The airbag warning light may come on. In rare cases an airbag or seat belt pretensioner could fire without a crash, or the airbags might not work in one.
- Why it happens
- The airbag control module (SRS ECU) can develop an internal short circuit. Toyota recalled 2004-2006 xA models in 2018.
- What to do
- Check your VIN for open recalls. A Toyota dealer will inspect the module and replace it free if needed.
A/C compressor failure
- What you'll notice
- The A/C cuts in and out, blows warm, or the compressor makes noise. Some owners report the compressor clutch staying engaged or the shaft breaking.
- Why it happens
- Owners of 2005-2006 xAs in particular report a pattern of failed compressors, sometimes just after the warranty ended. Failed internal electronics and the magnetic clutch have been blamed.
- What to do
- Have the system diagnosed before just recharging it. If the compressor has failed, ask a shop to check for debris in the system, and ask Toyota about goodwill help on low-mileage cars.
Manual transmission mainshaft bearing failure
- What you'll notice
- A whine or growl from the gearbox that changes with speed, getting louder over time.
- Why it happens
- A mainshaft bearing inside the manual transmission wears out, reported around 120,000 miles.
- What to do
- Have the transmission checked early. A bearing failure left too long can damage gears, turning a rebuild into a replacement.
Accessory cruise control may not return to idle (recall)
- What you'll notice
- After switching cruise control off, the engine doesn't drop back to idle.
- Why it happens
- Certain Rostra cruise control units installed by distributors or sold as accessories can fail to release the throttle.
- What to do
- Most xAs never had cruise control from the factory. If yours has an add-on unit, check the recall status with a Toyota dealer or Rostra, and press the brake to cancel cruise until it is fixed.
Check engine light from VVT-i oil control valve or cam gear
- What you'll notice
- The check engine light comes on, sometimes with stuttering acceleration or a rough idle.
- Why it happens
- The variable valve timing (VVT-i) system fails: the oil control valve or the camshaft timing gear wears or sticks. This is the most-reported xA problem on RepairPal, at about 115,000 miles on average.
- What to do
- Have the codes read. Fresh oil at the right level matters for this system. A shop can test the oil control valve before replacing the cam gear.
Leaking water pump
- What you'll notice
- Coolant drips at the front of the engine, a sweet smell, or the coolant level dropping.
- Why it happens
- The water pump seal wears and starts leaking, often between 50,000 and 140,000 miles.
- What to do
- Have the leak confirmed and the pump replaced before the engine overheats. Replacing the drive belts at the same time saves labor.
Check engine light for lean codes P0171 or P2195
- What you'll notice
- The check engine light comes on with a lean code or an oxygen sensor code. You may notice hesitation.
- Why it happens
- Toyota issued a bulletin for these codes on the xA. Causes include sensor issues and air or fuel delivery problems.
- What to do
- Ask a Toyota dealer to check the bulletin. Have intake leaks and the airflow sensor checked as well.
Clogged fuel injectors causing rough running
- What you'll notice
- Rough idle, hesitation or misfires, and lower fuel economy.
- Why it happens
- Deposits clog the fuel injectors. Toyota issued a bulletin with a cleaning procedure.
- What to do
- An injector cleaning service is usually the first step; replace an injector only if it still fails tests.
Ignition coil failure causing misfire
- What you'll notice
- Stuttering, shaking at idle, and a flashing check engine light.
- Why it happens
- An individual ignition coil fails.
- What to do
- Have the misfire codes read to find the cylinder. Replace the coil and check the spark plugs.
Humming wheel bearing
- What you'll notice
- A loud hum or growl that rises with speed and may change when turning.
- Why it happens
- A wheel bearing wears out, typically past 90,000 miles.
- What to do
- Have the bearing replaced. A badly worn bearing can overheat or let the wheel wobble.
Airbag light from failed clock spring
- What you'll notice
- The airbag warning light stays on; the horn or wheel buttons may also stop working.
- Why it happens
- The clock spring, a coiled ribbon cable behind the steering wheel, breaks.
- What to do
- Have the airbag codes read. The driver airbag may not work while the light is on.
A/C doesn't blow cold enough
- What you'll notice
- The A/C works but never gets really cold, even on the coldest setting.
- Why it happens
- The temperature control cable can be out of adjustment, so the blend door lets some heat through.
- What to do
- Ask a shop to check and adjust the temperature control cable before replacing any A/C parts.
Drive belts slipping or squealing
- What you'll notice
- A squeal on start-up or with the A/C on, or belts that crack or wear quickly.
- Why it happens
- The xA has no automatic belt tensioner, so the belts must be tensioned by hand and can loosen soon after being replaced.
- What to do
- Ask the shop to set the belt tension correctly and recheck it after a few weeks.
Check engine light from EVAP system leak
- What you'll notice
- The check engine light comes on with an evaporative emissions code. The car usually drives normally.
- Why it happens
- Leaks at the charcoal canister, filler neck or a vacuum switching valve, or water in the evaporative system, trigger the light. Toyota issued a bulletin about water in the system.
- What to do
- Make sure the gas cap clicks shut first. If the light returns, have a smoke test done to find the leak.
Engine won't crank because of a bad clutch switch
- What you'll notice
- On manual cars, the engine sometimes doesn't crank when you turn the key with the clutch pressed.
- Why it happens
- The clutch pedal safety switch fails, so the starter never gets the signal. One owner replaced a starter before finding this.
- What to do
- Ask the shop to test the clutch switch before replacing the starter or battery.
Exhaust pipe or muffler leak
- What you'll notice
- A louder exhaust, rattling underneath, or exhaust smell.
- Why it happens
- Exhaust pipes, hangers and the muffler rust out and leak.
- What to do
- Have the exhaust inspected. Leaks near the cabin can let fumes in.
Door lock actuator failure
- What you'll notice
- One door won't lock or unlock with the power locks.
- Why it happens
- The lock actuator motor inside the door fails.
- What to do
- Use the key in the meantime. The actuator inside the door is a fairly inexpensive part to replace.
Front brake noise or grinding
- What you'll notice
- Squealing or grinding when braking.
- Why it happens
- Worn front pads and rotors are the usual cause. Some cars squeal because of missing or worn anti-noise shims, which Toyota supplied free to at least one owner.
- What to do
- Have the brakes inspected soon. Grinding usually means the pads are worn to metal and are damaging the rotors.
Creak or tick at the top of the windshield
- What you'll notice
- A creak, tick or rattle near the top of the windshield over bumps.
- Why it happens
- Two small stoppers bonded to the windshield can rub against the body and make the noise. Toyota issued a bulletin with a fix.
- What to do
- It's harmless but annoying. Ask a Toyota dealer or glass shop to look at the bulletin repair.
Car pulls to one side
- What you'll notice
- The car drifts or pulls to one side on a straight road.
- Why it happens
- Uneven tire pressures, tire construction or wheel alignment are the usual causes. Toyota issued a bulletin on diagnosing pulling.
- What to do
- Check all tire pressures first, then try swapping the front tires side to side. If it still pulls, have the alignment checked.
Repair prices for your 2006 Scion xA
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace A/C compressor, receiver/drier and recharge
- Heating and A/C inspection (temperature cable check)
- Replace VVT-i oil control valve
- Replace water pump and coolant
- Replace and tension drive belts
- Smoke test and replace leaking EVAP part (canister, valve or filler)
- Fuel injector cleaning service
- Replace ignition coil
- Rebuild manual transmission (often with clutch)
- Replace clutch pedal safety switch
- Replace wheel hub/bearing assembly
- Replace exhaust pipe or muffler section
- Replace steering wheel clock spring
- Replace door lock actuator
- Front brake pads (and rotors if needed)
- Pulling inspection (tires and alignment check)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect and replace airbag control moduleNo charge if your vehicle is included
- Replace cruise control unitNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…