Subaru Bajaproblems, repair costs and recalls
Problems reported across 2003–2006. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
21 documented issues across all years, most serious first.
Head gasket leaks
- What you'll notice
- Oil or coolant seeping from where the cylinder heads meet the engine block, a sweet coolant or burning oil smell, the coolant tank running low, or the temperature gauge creeping up.
- Why it happens
- The non-turbo 2.5L boxer engine in the Baja shares the head gasket weakness of other Subarus from this era. The gaskets usually start with slow external leaks and can get worse if the engine overheats.
- What to do
- Have the leak found and watch the coolant level closely. Fix it before it overheats; many shops do the timing belt and water pump at the same time.
Passenger airbag inflator can rupture (recall)
- What you'll notice
- No warning sign. In a crash the passenger airbag inflator can burst and throw metal fragments.
- Why it happens
- The Baja uses a Takata passenger airbag inflator whose propellant breaks down with heat and humidity over the years. Subaru has recalled every Baja model year in several rounds.
- What to do
- Check your VIN with a Subaru dealer right away and get the free inflator replacement. Until then, avoid using the front passenger seat.
Engine knock or rod bearing failure
- What you'll notice
- A deep knock from the engine that gets louder with revs, low oil pressure light, or the engine seizing.
- Why it happens
- Owners report spun rod bearings and blown engines on both engines, often after running low on oil or overheating.
- What to do
- Check the oil level often and stop driving if a knock starts. A worn bearing usually means a replacement or rebuilt engine.
Turbo oil screen clogs, causing rough idle or turbo failure
- What you'll notice
- Rough idle, slow rev response, a check engine light for the cam timing, or the turbo whining, smoking or failing.
- Why it happens
- Small mesh filters in the oil banjo bolts feeding the variable cam timing and the turbo can clog with sludge. Subaru issued a bulletin for the damaged filter. Starving the turbo of oil wears it out.
- What to do
- Change the oil on time with the right grade. If the idle is rough, have the oil screens checked before the turbo is damaged.
Fuel pump hose connection can crack and leak (recall)
- What you'll notice
- A strong fuel smell, especially after filling up, or fuel dripping near the rear of the vehicle.
- Why it happens
- Cracks can form at the hose connection on the high-pressure side of the fuel pump, letting fuel leak. Subaru recalled 2005-2006 Bajas.
- What to do
- Don't drive with a fuel smell. Ask a Subaru dealer to check your VIN for the free fuel pump repair.
Overheating from radiator or hose leaks
- What you'll notice
- The temperature gauge climbs, coolant drips under the front, or steam comes from under the hood.
- Why it happens
- Radiators and coolant hoses crack with age. Owners report overheating severe enough to crack the engine block, and overheating also hastens head gasket failure.
- What to do
- Stop and shut the engine off if it overheats. Replace a leaking radiator or hose right away rather than topping up.
Water pump pulley can come off (recall)
- What you'll notice
- Sudden overheating, a squeal or clatter from the front of the engine, and possibly the engine seizing.
- Why it happens
- The center hole of the water pump pulley was machined wrong on some early vehicles, so the pulley could come loose and stop coolant from flowing.
- What to do
- Ask a Subaru dealer to check your VIN for this 2002 recall.
Automatic may not hold in Park (recall)
- What you'll notice
- The vehicle can roll after being put in Park.
- Why it happens
- A transmission parking rod was made incorrectly, so Park might not lock the transmission.
- What to do
- Always use the parking brake, and ask a Subaru dealer to check your VIN for the free parking rod repair.
Oil control valve cover bolts can loosen and leak (recall)
- What you'll notice
- Oil leaking from the front of the engine, a burning oil smell, or smoke from under the hood.
- Why it happens
- Bolts on the cover for the cam timing oil control valve may not have been tightened enough at the factory. Leaking oil can reach hot parts and in rare cases start a fire.
- What to do
- Check your VIN with a Subaru dealer for the free bolt fix, and have any oil leak near hot exhaust parts fixed promptly.
AWD binding in tight turns
- What you'll notice
- The truck hops, shudders or feels like it is braking in tight, slow turns such as parking lots, and tires scrub.
- Why it happens
- On automatics, the transfer clutch that splits power front to rear can bind; Subaru issued a bulletin on transfer clutch binding. On manuals, the center differential's viscous coupling can lock up. Mismatched tire sizes make both worse.
- What to do
- Make sure all four tires are the same size and evenly worn. Then have the AWD system diagnosed; the automatic's transfer solenoid or clutch is the usual repair.
Automatic transmission fluid leak near the oil filter
- What you'll notice
- Red fluid on the engine near the oil filter or drips under the middle of the vehicle.
- Why it happens
- The automatic can leak fluid at a transmission stud next to the engine's oil filter.
- What to do
- Check the transmission fluid level and have the leak sealed. Running the automatic low on fluid can damage it.
Torn CV boots and clicking axles
- What you'll notice
- Clicking or tapping when turning, or grease sprayed inside the wheel.
- Why it happens
- The rubber boots on the axles split, the grease escapes and the joints wear. Owners report tapping in turns even after axle replacement, sometimes from cheap aftermarket axles.
- What to do
- Replace a torn boot early. If the joint already clicks, replace the axle with a quality part.
Wheel bearing hum
- What you'll notice
- A hum or growl that gets louder with speed and may change in turns.
- Why it happens
- Front and rear wheel bearings wear out on these vehicles.
- What to do
- Have the bearings checked and replace the noisy one before it gets loose.
Rusty or sticking rear brakes
- What you'll notice
- Grinding, pulsing, a pull to one side, or a hot wheel after driving.
- Why it happens
- Owners report pitted, rusted rear rotors early on and sticking rear calipers, especially where roads are salted.
- What to do
- Have the rear brakes inspected and the caliper slides cleaned and greased when pads are changed.
Fuel smell in cold weather
- What you'll notice
- A strong gas smell at startup or when it is below about 30°F.
- Why it happens
- Owners report that rubber fuel hoses under the hood harden in the cold and seep fuel.
- What to do
- Have the fuel hoses and clamps checked, and check that the fuel pump recall was done.
Clutch release bearing noise
- What you'll notice
- A chirp, squeal or whir with a manual transmission that changes when you press the clutch.
- Why it happens
- Subaru changed the clutch release (throw-out) bearing to use a more heat-resistant grease after noise complaints.
- What to do
- If you're replacing the clutch, ask for the updated release bearing.
Valve cover and rear main seal oil leaks
- What you'll notice
- Oil spots under the vehicle, oil on the exhaust, or a burning oil smell.
- Why it happens
- The valve cover gaskets, oil pan seal and rear main seal harden with age and leak.
- What to do
- Clean the engine and find the source. Valve cover gaskets are a simple fix; a rear main seal is often done with a clutch job.
Rough idle and check engine light after battery disconnect
- What you'll notice
- After the battery is replaced or disconnected, the engine idles roughly and the check engine light may come on.
- Why it happens
- The engine computer loses its learned idle settings. Subaru issued a bulletin describing this and the relearn procedure.
- What to do
- Ask a shop to run the idle relearn procedure. It usually settles after normal driving.
Rattling exhaust heat shields
- What you'll notice
- A tinny rattle from under the vehicle at certain engine speeds.
- Why it happens
- Heat shield clamps rust and loosen.
- What to do
- Have the shields re-secured with new clamps.
A/C stops cooling from hose leaks
- What you'll notice
- The A/C blows warm, sometimes after a recharge that didn't last.
- Why it happens
- Owners report cracked A/C hoses and leaking service valves.
- What to do
- Have a leak test done before recharging.
Steering wheel shake at highway speed
- What you'll notice
- The steering wheel vibrates at highway speeds.
- Why it happens
- Subaru issued a bulletin tracing this to improper wheel balancing.
- What to do
- Ask a tire shop for a road-force balance before replacing parts.
Repair prices for your Subaru Baja
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace both head gaskets and resurface heads
- Replace engine with used or rebuilt long block
- Replace turbocharger and oil feed line
- Replace AWD transfer (duty C) solenoid
- Replace radiator and hoses
- Reseal transmission stud and top up fluid
- Replace CV axle
- Replace one wheel bearing
- Replace rear pads, rotors and a sticking caliper
- Replace clutch kit with updated release bearing
- Replace engine-bay fuel hoses and clamps
- Replace valve cover gaskets
- Idle relearn and code check
- Re-secure heat shields with new clamps
- Replace leaking A/C hose and recharge
- Road-force balance all four wheels
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace passenger airbag inflatorNo charge if your vehicle is included
- Repair fuel pump hose connectionNo charge if your vehicle is included
- Replace water pump pulleyNo charge if your vehicle is included
- Replace transmission parking rodNo charge if your vehicle is included
- Retighten oil control valve cover boltsNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.