Your 1997 Subaru Outbackproblems, repair costs and recalls
What we've documented about the 1997 Subaru Outback: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1997 Subaru Outback
6 documented issues apply to 1997, most serious first.
Head gasket leaks
- What you'll notice
- Coolant level keeps dropping, a sweet coolant smell, oil or coolant seeping from the sides of the engine, or the temperature gauge creeping up.
- Why it happens
- The non-turbo 2.5L boxer engine is known for head gasket failures, usually at higher mileage. The earliest engines tended to leak coolant internally, while 2000-2009 engines more often seep oil and coolant on the outside.
- What to do
- Have a shop pressure-test the cooling system and inspect the gasket area. If the engine overheats, pull over and shut it off rather than driving on, since overheating can ruin the engine.
Front coil spring can rust through and break (recall)
- What you'll notice
- A bang or clunk from a front corner, the car sitting lower on one side, or a rubbing noise from a front tire.
- Why it happens
- Thin paint lets the front coil springs corrode. A broken spring can slip past its seat and press against the tire, which can cut it.
- What to do
- Have the front springs inspected now. The dealer fits spring guards and replaces broken springs free under the recall.
Front suspension bracket welds can crack (recall)
- What you'll notice
- Vague or wandering steering, clunks over bumps, or the car pulling to one side.
- Why it happens
- The bracket that holds the front of the lower suspension arm was not welded properly on some cars and can crack or come away.
- What to do
- Have the brackets inspected before driving further. They are replaced free under the recall if they are affected.
Shift lever can break or let the car move unexpectedly (recall)
- What you'll notice
- The ignition key sticks, the shifter feels loose or sloppy, or the lever moves out of Park without the brake pedal.
- Why it happens
- Poor welds in the automatic shift lever and its linkage let parts break, so the lever can move or no longer match the gear the car is in.
- What to do
- Set the parking brake and have it inspected right away. The dealer replaces the shift lever assembly free under the recall.
Throttle may not return fully (recall)
- What you'll notice
- Idle that creeps up and stays high, or the engine not settling back down when you lift off the pedal.
- Why it happens
- A ball bearing was left out of the throttle shaft on some throttle bodies, so over time the shaft binds and the throttle does not close all the way.
- What to do
- Have the throttle body inspected before driving much further. The dealer replaces it free under the recall if the bearing is missing.
AWD binding in tight turns (automatic)
- What you'll notice
- In slow, tight turns such as parking lots, the car feels like it is braking itself, hops, or shudders. It drives normally in a straight line.
- Why it happens
- On automatic models the all-wheel-drive transfer clutch, or the solenoid that controls it, can stick so the front and rear wheels are locked together when they should be able to turn at different speeds.
- What to do
- Make sure all four tires are the same size and evenly worn, then have a Subaru-savvy shop check the transfer clutch and its solenoid. Ongoing binding wears the drivetrain.
Repair prices for your 1997 Subaru Outback
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace both head gaskets
- Replace AWD transfer clutch (duty C) solenoid
- Replace front coil spring and fit spring guards
- Inspect and replace front suspension support brackets
- Replace automatic transmission shift lever assembly
- Inspect and replace throttle body assembly
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…