Your 2000 Suzuki Esteemproblems, repair costs and recalls
What we've documented about the 2000 Suzuki Esteem: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2000 Suzuki Esteem
14 documented issues apply to 2000, most serious first.
Front subframe rusts through
- What you'll notice
- The car pulls to one side, the steering goes off-center, you hear grinding or clunking from the front, or a front wheel suddenly tilts inward.
- Why it happens
- The front subframe (the cradle that holds the engine and lower control arms) rusts from road salt. Once it rots, the suspension mounting points can tear loose. Suzuki later sent dealers a reminder to inspect suspension parts for salt damage.
- What to do
- If the car suddenly pulls hard, clunks or a wheel leans in, stop driving and have it towed. On any Esteem from a salt state, ask a shop to put it on a lift and check the subframe and control arm mounts for rust.
Front lower ball joint can separate
- What you'll notice
- Clunking over bumps, loose or wandering steering, uneven front tire wear. In the worst case a front wheel collapses inward.
- Why it happens
- The ball joints that connect the lower control arms to the steering knuckles wear out and, on rusty cars, can pull apart. Suzuki sent its US dealers a bulletin stressing regular inspection of the lower arm ball joints.
- What to do
- Have the front ball joints checked at every tire rotation or inspection. If one is loose, replace it before driving further.
Front strut or control arm comes loose
- What you'll notice
- A loud pop from the front, sudden pulling to the right, shaking, a wheel that leans, or steering that stops responding.
- Why it happens
- Owners report missing strut bolts, broken control arms and bent axles after potholes. Age and rust weaken these parts.
- What to do
- Pull over safely and do not keep driving. Have it towed and get the front suspension inspected.
Soft brake pedal or weak braking
- What you'll notice
- The pedal feels soft or sinks, and the car takes longer to stop than it should.
- Why it happens
- Owners report brakes that feel spongy or don't stop the car well. Air in the lines, a leak, a worn master cylinder or worn pads are common causes. Suzuki also issued a service manual correction for brake torque specs.
- What to do
- Don't drive with a soft pedal. Have the brake fluid level, lines, calipers and master cylinder checked right away.
Crankshaft pulley or timing belt failure
- What you'll notice
- A ticking or rattling noise at the front of the engine, then sudden loss of power or the engine stopping. Power steering can go heavy if the belts stop turning.
- Why it happens
- Owners report the crankshaft pulley breaking at speed and damaging the timing belt, and one report of timing slipping after a ticking noise started. The timing belt also wears out with age.
- What to do
- If a new noise starts at the front of the engine, get it checked soon. Replace the timing belt on schedule, and check the pulley and its bolt at the same time.
Automatic transmission stuck in a low gear
- What you'll notice
- The car won't shift up and stays in a lower gear, with a loud whine or roar at highway speed.
- Why it happens
- Owners report the automatic getting stuck in a lower gear, in one case after three transmission replacements. Electrical faults can force a fail-safe mode, and internal wear can do the same.
- What to do
- Avoid highway driving. Have a shop read transmission codes and check the fluid before replacing anything.
Engine stalls or loses power while driving
- What you'll notice
- The engine hesitates when you accelerate, or it dies in traffic and has to be restarted or towed.
- Why it happens
- Owners report stalling and loss of power. Reported fixes included a fuel gauge sending unit, and dealers checked fuel tank sensors and the gas cap. Fuel delivery, sensor or ignition faults can all cause it.
- What to do
- If it stalls, steer and brake firmly (power assist drops), get off the road and have it diagnosed. Note when it happens (hot, cold, low fuel) to help the shop.
Sudden loss of all electrical power
- What you'll notice
- Everything goes dead while driving: lights, dash and engine.
- Why it happens
- One owner traced repeated total power loss to a loose 80-amp main fuse under the hood. A loose main fuse or battery connection cuts power to the whole car.
- What to do
- Get safely off the road. Have the main fuse, fuse box terminals and battery cables checked and tightened.
Oil leak from front crankshaft seal
- What you'll notice
- Oil drips under the front of the engine, oil on the belts or lower engine, or a burning oil smell.
- Why it happens
- The rubber seal around the crankshaft hardens with age and starts to leak, usually at high mileage. On the 1.6L the seal sits behind the timing belt, so the repair costs much more.
- What to do
- Keep the oil topped up. On the 1.6L, have the seal done at the same time as the timing belt to save labor.
Steering wanders from worn inner tie rod
- What you'll notice
- The car wanders on the highway, pulls one way and then the other, or the steering feels loose.
- Why it happens
- A torn tie rod boot lets water and dirt into the inner tie rod joint, which then wears out. Owners also report wandering and pulling from other front-end wear.
- What to do
- Have the tie rods and boots checked. Replace a worn tie rod and get an alignment.
Key sticks in the ignition
- What you'll notice
- The key won't turn or won't come out, and on automatics the shifter may not come out of Park.
- Why it happens
- Owners report keys sticking in the ignition and shifters stuck in Park, often needing more than one repair. A worn lock cylinder or shift interlock is the usual cause.
- What to do
- Don't force the key. Have the ignition lock cylinder and the brake-shift interlock checked.
Check engine light comes and goes
- What you'll notice
- The check engine light turns on and off, sometimes with no stored code.
- Why it happens
- Owners report the light coming and going, and some code readers have trouble talking to these older cars. A loose gas cap, failing sensors or small vacuum leaks are common causes.
- What to do
- Tighten the gas cap and have the codes read by a shop with a scan tool that supports the Esteem.
Brake pedal pulsates when stopping
- What you'll notice
- The brake pedal pulses or the steering wheel shakes when you brake.
- Why it happens
- The front rotors run out of true after heavy braking or uneven wheel nut tightening.
- What to do
- Have the rotors checked. Resurfacing or replacing them, and tightening wheel nuts with a torque wrench, usually fixes it.
Horn stops working
- What you'll notice
- The horn doesn't sound, which can fail a state inspection.
- Why it happens
- An owner reported the horn quitting. A bad horn, relay, fuse or the contact in the steering wheel is the usual cause.
- What to do
- Check the horn fuse and relay first, then the horn itself.
Repair prices for your 2000 Suzuki Esteem
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front lower ball joint (one side)
- Replace front control arm or strut, then align
- Replace brake master cylinder and bleed brakes
- Replace timing belt and tensioner (check crank pulley and bolt)
- Replace fuel pump (if testing points to it)
- Clean or replace main fuse and battery cables
- Replace front crankshaft seal
- Replace inner tie rod
- Check engine light diagnosis
- Replace front brake pads and resurface or replace rotors
- Replace horn relay
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…