Your 2002 Toyota Celicaproblems, repair costs and recalls
What we've documented about the 2002 Toyota Celica: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2002 Toyota Celica
12 documented issues apply to 2002, most serious first.
Rod knock and sudden engine failure
- What you'll notice
- A ticking that turns into a deep knock from the engine, often after months of using oil, then the engine locks up or a connecting rod breaks through the block. Reports cluster around 63,000-135,000 miles.
- Why it happens
- Engines that burn oil run low between changes. Starved of oil, the rod bearings wear and spin until the engine fails. Owners commonly end up replacing the engine.
- What to do
- If you hear knocking, check the oil right away and stop driving if it's low. A knock usually means the bearings are already damaged, so get quotes on a used or rebuilt engine rather than a quick fix.
Heavy oil consumption
- What you'll notice
- The oil level drops fast, as much as a quart every 500 miles, with blue-gray exhaust smoke, a low-oil light or misfire codes. Owners often find the dipstick dry.
- Why it happens
- The piston oil-control rings on this engine family can stick or clog with carbon, letting oil into the cylinders to burn. The same 1.8L engine has the same reputation in the Corolla of these years.
- What to do
- Check the oil at every fill-up and top it off. Ask a shop about a ring-cleaning treatment; if it is burning a lot, budget for rings or a replacement engine before it knocks.
Worn or broken valve lift bolts
- What you'll notice
- A ticking or clacking from the top of the engine, especially when the high-rpm cam ('lift') kicks in, or the lift no longer engaging.
- Why it happens
- Two small bolts hold the rocker arm shafts that run the GT-S's high-rpm cam lobes. The original bolts wear heavily and can snap. Toyota bulletin EG010-03 introduced a redesigned, tapered bolt.
- What to do
- Have the original-style bolts replaced with the newer part. It is a cheap, quick job that can prevent much bigger engine damage.
Manual transmission bearing whine and failure
- What you'll notice
- A low grinding hum like a bad wheel bearing plus a whine in first through third gear that gets louder over a few thousand miles. It may pop out of gear before the transmission fails.
- Why it happens
- The input shaft bearing in the GT's 5-speed manual wears out early. Owners report failures from about 36,000 to 105,000 miles.
- What to do
- Have it checked as soon as the noise starts. Replacing the bearing early costs far less than a whole transmission after it lets go.
Fuel can spill at the pump from a loose check valve (recall)
- What you'll notice
- Fuel spurts out of the filler when the pump nozzle clicks off, with a strong gas smell.
- Why it happens
- A check valve in the fuel filler pipe can separate and drop into the tank, so fuel can spill during refueling and create a fire risk. Toyota recall 03V-074 inspects and repairs the valve.
- What to do
- Check your VIN for this recall. If fuel spills while filling, stop, clean it up away from ignition sources and have the recall done.
Power loss or no lift above 6,000 rpm
- What you'll notice
- The engine feels flat or stumbles at high revs under hard acceleration, or the expected surge when the lift engages comes and goes.
- Why it happens
- Toyota bulletin 01003 covers intermittent power loss or uneven variable valve lift above 6,000 rpm under high load. Low oil or worn lift parts make it worse.
- What to do
- Check the oil level first. Ask a Toyota dealer or Celica specialist to check the lift system and apply the bulletin fix.
Power steering pump and hose leaks
- What you'll notice
- Reddish fluid under the front of the car, a whine when turning, or heavier steering when the fluid gets low.
- Why it happens
- The power steering pump seals and the pressure and return hoses wear and start to leak with age.
- What to do
- Check the fluid level and look for wet hoses. Replace the leaking hose or pump before the pump runs dry and fails.
Clutch wearing out early
- What you'll notice
- The engine revs rise without the car speeding up, the pedal engages high, or there's a burning smell on hills.
- Why it happens
- Owners report clutches worn out by about 56,000 miles. Spirited driving, common in these cars, speeds up wear.
- What to do
- Have the clutch checked before it slips badly. Ask the shop to check the flywheel at the same time.
Check engine light for variable valve timing (P1349)
- What you'll notice
- The check engine light comes on with code P1349. The engine may idle rough or feel weak.
- Why it happens
- Variable valve timing is driven by oil pressure. A sticking oil control valve or dirty oil can set this code. Toyota issued bulletin 00903 for it.
- What to do
- Check the oil level and condition, then have the oil control valve and its screen tested.
Crankshaft sensor code (P0335) from a weak battery
- What you'll notice
- The check engine light comes on with code P0335, often with slow or hard starting in cold weather.
- Why it happens
- Toyota bulletin T-TT-0010-10 says low battery voltage during cranking can set this code even when the sensor is fine.
- What to do
- Test the battery and charging system before paying for a crank sensor.
Check engine light and rough running in freezing weather
- What you'll notice
- Rough running or stumbling when it's very cold, with a check engine light for lean (P0171), misfire (P030x) or oxygen sensor (P0133) codes.
- Why it happens
- Toyota bulletin 04607 says the engine can run lean in subfreezing temperatures and set these codes, and gives a repair.
- What to do
- Have the codes read and ask a Toyota dealer about the bulletin. Check for vacuum leaks and a dirty airflow sensor too.
Rear hatch won't stay up
- What you'll notice
- The rear hatch drifts down or drops shut on its own.
- Why it happens
- The gas struts that hold up the hatch lose pressure. Toyota bulletin BO01502 addresses hatch stays that don't give enough support.
- What to do
- Replace both struts as a pair. Until then, prop the hatch so it can't fall on anyone.
Repair prices for your 2002 Toyota Celica
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace engine with used or remanufactured unit
- Replace piston rings (engine rebuild) or engine
- Replace lift bolts with updated part
- Diagnose lift system and perform bulletin repair
- Replace power steering pressure hose or pump
- Test and replace 12V battery
- Rebuild manual transmission (input shaft bearing)
- Replace clutch kit
- Replace VVT oil control valve
- Diagnose lean codes and perform bulletin repair
- Replace rear hatch struts (pair)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect and repair fuel filler check valve (recall 03V-074)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…