Your 2014 Toyota FJ Cruiserproblems, repair costs and recalls
What we've documented about the 2014 Toyota FJ Cruiser: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2014 Toyota FJ Cruiser
20 documented issues apply to 2014, most serious first.
Frame rust in salt-belt states
- What you'll notice
- Flaking, scaling or holes in the frame rails, rusted crossmembers, or a shop saying the frame is unsafe or not fit to tow with.
- Why it happens
- Road salt eats into the frame and underbody over time. FJs from snowy, salted-road states are much more likely to have it. Toyota did not run a frame program for the FJ.
- What to do
- Have the frame inspected on a lift, especially before buying. Rustproofing each year slows it down. Heavy rot needs frame repair by a welding shop or a replacement frame.
Steering shaft weld may fail (recall)
- What you'll notice
- Clunking or looseness in the steering, or in the worst case the steering wheel stops turning the wheels.
- Why it happens
- On FJs built August 7-20, 2013, the intermediate steering shaft may have a weak weld. Recall 15V-081.
- What to do
- Have a Toyota dealer check your VIN right away. They replace the shaft for free.
Ball joint bolts may be loose on Trail Teams Ultimate (recall)
- What you'll notice
- Clunking from the front suspension or wandering steering on a Trail Teams Ultimate Edition.
- Why it happens
- After shock and spring work on these trucks, the front lower ball joint and arm bolts may not have been tightened enough and could fall out. Recall 14V-539.
- What to do
- Have a Toyota dealer check your VIN and torque the bolts for free.
Fuel pump may fail and stall the engine (recall)
- What you'll notice
- The engine runs rough, will not start, or stalls while driving.
- Why it happens
- The low-pressure fuel pump in the tank can fail. Recall 20V-012 covers many Toyota models including some 2014 FJ Cruisers.
- What to do
- Have a Toyota dealer check your VIN. The fuel pump is replaced free.
Front differential grinding or groaning in 2WD
- What you'll notice
- A cyclic grinding or groaning noise from the front while driving in 2WD that goes away when you shift into 4WD.
- Why it happens
- Toyota bulletin T-SB-0026-15 covers this on 2004-2015 Tacoma, 4Runner and FJ Cruiser. The noise comes from the front differential while it is not driving the wheels.
- What to do
- Tell the shop the noise stops in 4WD; that points them to the bulletin. Have the front differential fluid checked too.
Front brake calipers stick and drag
- What you'll notice
- The truck pulls to one side when braking, a hot or burning smell from one wheel, one wheel much hotter than the others, or fast pad wear on one side.
- Why it happens
- The caliper pistons and slide pins corrode and stick, so the pad keeps rubbing on the rotor. It is one of the most reported FJ repairs.
- What to do
- Have the brakes inspected. A stuck caliper should be replaced along with pads and often the rotor on that side.
Front wheel bearing or hub wears out
- What you'll notice
- A humming or growling noise that gets louder with speed and changes when turning, or play in the wheel.
- Why it happens
- Front wheel bearings and hubs wear out, faster with big tires, lifts and off-road use.
- What to do
- Have the wheel checked for play and noise. A bad bearing can overheat, so do not put it off for long.
Front CV axle boots tear
- What you'll notice
- Grease slung around the inside of the front wheel, a clicking noise when turning, or vibration.
- Why it happens
- The rubber CV boots on the front axles crack with age and suspension travel, letting grease out and dirt in.
- What to do
- Replace a torn boot quickly. Once the joint clicks, the whole axle is usually replaced.
Front lower ball joints wear out
- What you'll notice
- Clunking from the front over bumps, wandering steering, or uneven tire wear.
- Why it happens
- The lower ball joints wear with mileage, big tires and off-road use.
- What to do
- Have the ball joints checked for play. Worn joints should be replaced, since a failed joint can let the wheel collapse.
Alternator stops charging
- What you'll notice
- The battery light comes on, lights dim, the battery keeps going dead, or a whining noise from the engine.
- Why it happens
- The alternator wears out with age. It is among the more common FJ repairs reported by owners.
- What to do
- Have the battery and charging system tested. Replace the alternator if it is not charging, before you get stranded.
Check engine light from a failed air-fuel sensor
- What you'll notice
- The check engine light comes on with a code for the bank 1 or bank 2 sensor 1 air-fuel sensor. The truck may run normally or use more fuel.
- Why it happens
- The upstream air-fuel sensors wear out at higher mileage. A failing sensor or misfires can also damage the catalytic converters.
- What to do
- Have the codes read. Replace the failed sensor; do not ignore a misfire, since it can ruin a converter.
Oil consumption at higher mileage
- What you'll notice
- The oil level drops between changes, the low oil light comes on, or blue smoke from the exhaust.
- Why it happens
- As the 4.0L V6 ages, it can start using oil. Running it low can lead to engine damage; some owners report needing a replacement engine.
- What to do
- Check the oil every few fill-ups and top it up. Keep up with oil changes. If use climbs quickly, have a compression and leak-down test done.
Timing chain stretch at high mileage
- What you'll notice
- A rattle or slap from the front of the engine, mostly at cold start, or a check engine light for cam and crank timing.
- Why it happens
- The 4.0L V6 uses a timing chain. At high mileage the chain, tensioner and guides can wear, especially with poor oil change habits.
- What to do
- Have the noise diagnosed. Keeping oil clean and full helps the chain last. A worn chain is replaced with its tensioner and guides.
Blend door actuator clicking
- What you'll notice
- A clicking or tapping noise behind the dash, or air temperature that will not change properly.
- Why it happens
- A small motor that moves the heater blend door fails or strips its gears.
- What to do
- Have the HVAC system checked. The actuator is a small part but can take some dash work to reach.
Left foot rest comes loose or falls off
- What you'll notice
- The dead pedal (left foot rest) feels loose or falls off the floor.
- Why it happens
- Owners widely report the foot rest mounting coming loose on FJs.
- What to do
- Re-secure it or replace the foot rest so it cannot slide under the pedals.
Rear swing door hinge area cracks
- What you'll notice
- Creaking from the rear door, the spare tire wobbling, or cracks around the rear door hinges.
- Why it happens
- The heavy spare tire hangs on the rear swing door, and the weight can stress the hinge area over time, worse off-road or with bigger tires.
- What to do
- Inspect around the hinges when buying. Do not mount a much larger spare without a separate carrier. Have a body shop repair cracks early.
Hard start or rough idle after the battery is disconnected
- What you'll notice
- After a battery change or jump start the engine is hard to start or idles low and rough; sometimes a crankshaft sensor code (P0335) sets.
- Why it happens
- The engine computer loses its learned idle settings when power is cut, and low battery voltage can set false sensor codes. Toyota has bulletins for both.
- What to do
- Let it idle and drive normally to relearn, or have a shop run the idle relearn. Test the battery if codes keep coming back.
Musty A/C smell or water on the floor
- What you'll notice
- A musty or sour smell from the vents, or water on the front passenger floor.
- Why it happens
- The A/C drain tube can clog with debris or insect nests, so water backs up in the evaporator case. Toyota has bulletins on blocked drains and HVAC odors.
- What to do
- Have the A/C drain cleared and the evaporator cleaned. Replace the cabin air filter if fitted.
Tire label may show wrong spare tire info (recall)
- What you'll notice
- The tire placard on the door jamb lists the wrong spare tire size or pressure, mostly on trucks with accessory wheels.
- Why it happens
- Some FJs with accessory wheels and tires got a placard that did not match the spare. Recall 14V-475.
- What to do
- Check that your spare matches the placard. A Toyota dealer will apply a corrected label free.
Dealer-installed accessories may be loose (recall)
- What you'll notice
- Running boards or other dealer-installed accessories rattle or feel loose.
- Why it happens
- Fasteners on accessories installed by the regional distributor may not have been tightened enough. Recall 14V-828.
- What to do
- Have a Toyota dealer check your VIN and tighten the bolts.
Repair prices for your 2014 Toyota FJ Cruiser
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Cut out rusted frame sections and weld in repair plates
- Repair front differential per Toyota bulletin
- Replace front brake caliper, pads and rotor
- Replace front wheel bearing/hub
- Replace front CV axle
- Replace front lower ball joints and align
- Replace alternator
- Replace upstream air-fuel sensor
- Diagnose oil consumption (compression/leak-down test)
- Replace timing chain, tensioner and guides
- Replace HVAC blend door actuator
- Replace or re-secure left foot rest
- Repair rear door hinge area and adjust door
- Idle relearn and battery test
- Clear A/C drain and clean evaporator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Install corrected tire placardNo charge if your vehicle is included
- Replace intermediate steering shaftNo charge if your vehicle is included
- Inspect and torque lower ball joint and arm boltsNo charge if your vehicle is included
- Replace fuel pumpNo charge if your vehicle is included
- Inspect and torque accessory fastenersNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…