Toyota 86 / GR86problems, repair costs and recalls
Problems reported across 2013–2025. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
20 documented issues across all years, most serious first.
Valve springs can break and stall the engine (recall)
- What you'll notice
- Rough running, misfires, unusual engine noise, or the engine stalling while driving.
- Why it happens
- Some valve springs on early cars (sold as the 2013 Scion FR-S) were weak and could fracture.
- What to do
- Check your VIN for open recalls. A dealer replaces the valve springs for free; the engine has to come out, so allow time.
Engine knock or failure after the valve spring recall repair
- What you'll notice
- Knocking or rod-like noise, low oil pressure light, loss of power or sudden engine shutdown, often within days to a few thousand miles of the valve spring recall work.
- Why it happens
- Many owners report bearing damage after the recall repair. Excess sealant or debris reaching the oil pickup and starving the bearings of oil is the most common explanation given, though it has not been officially confirmed.
- What to do
- If the recall was done and you hear knocking, stop driving and have the oil pan and pickup inspected. Keep the recall paperwork and ask Toyota for goodwill help.
Engine knock or sudden engine failure
- What you'll notice
- Knocking that gets louder, smoke, misfires or the engine dying, sometimes with no warning lights.
- Why it happens
- Owners report bottom-end failures and broken valve parts outside of the recall. Low oil level and hard driving make it worse.
- What to do
- Check the oil level often, since these engines can use some oil. If you hear knocking, stop driving and have it diagnosed before it seizes.
Power steering binds, clunks or loses assist
- What you'll notice
- The steering feels notchy or stiff, clunks or rattles, or suddenly gets heavy.
- Why it happens
- Owners report failures in the electric power steering, including worn dampers or bushings and motor problems.
- What to do
- Have the steering checked right away if it binds or loses assist. Report it to NHTSA if it happened while driving.
In-tank fuel pump can fail and stall the engine (recall)
- What you'll notice
- Rough running, a check engine light, the car not starting, or the engine stalling while driving.
- Why it happens
- The low-pressure fuel pump inside the tank may fail.
- What to do
- Check your VIN for open recalls. A dealer replaces the pump for free.
Engine failure from sealant clogging the oil pickup
- What you'll notice
- Sudden knocking, an oil pressure light, power loss or the engine shutting down, sometimes at low mileage and with no warning.
- Why it happens
- On some cars, too much silicone sealant was applied to the oil pan at the factory. Pieces break off and block the oil pickup screen, starving the bearings of oil.
- What to do
- Ask a shop or dealer to drop the oil pan and clean the pickup, or at least look inside with a camera and cut open the old oil filter. If you hear knocking, stop driving and have it towed.
Oil pressure drops during hard cornering on track
- What you'll notice
- On track or autocross, the oil pressure dips in long, fast corners. Some engines have spun a rod bearing.
- Why it happens
- Independent testing found oil pressure falling sharply in sustained high-speed right-hand corners at high rpm, likely from oil moving away from the pickup.
- What to do
- If you track the car, fit an oil pressure gauge, keep the oil at the full mark and talk to your dealer about warranty rules. Normal street driving is far less affected.
Rough idle or stalling with cam timing codes
- What you'll notice
- Idle speed that hunts up and down, shudder, stalling when you come to a stop, and a check engine light with codes P0016 to P0019.
- Why it happens
- The variable valve timing controllers on early engines did not always meet tolerances. A faulty cam sprocket can also lose oil pressure so the cam timing cannot respond.
- What to do
- Have the codes read and ask a dealer about the engine computer update. If it still stalls, the cam sprocket may need replacing.
Clutch release bearing noise or failure
- What you'll notice
- Chirping, squealing or screeching that changes when you press the clutch, gears that grind when shifting, or a clutch pedal that feels different.
- Why it happens
- The clutch release (throw-out) bearing on manual cars can wear out early.
- What to do
- Have the clutch inspected soon. Replacing the bearing with the clutch before it fails can prevent damage to the transmission.
Fuel pump chirp, whine or failure
- What you'll notice
- A chirp or whine from the fuel system, hard starting, sputtering when you accelerate, or the engine cutting out.
- Why it happens
- The engine has both a high-pressure fuel pump and an in-tank pump. A chirping high-pressure pump can be an early sign of wear, and in-tank pumps have failed.
- What to do
- If the car stalls or struggles to start, have fuel pressure tested. Check for open recalls on 2018 and 2019 models.
Key can be removed when not in Park (recall)
- What you'll notice
- On automatics with a regular key, you can pull the key out without the shifter in Park, and the car could roll away.
- Why it happens
- The key-to-shifter interlock was disabled for shipping and was not always reconnected.
- What to do
- Check your VIN for open recalls. A dealer inspects and reconnects the interlock wiring for free.
Rear turn signals stop working in bright sun (recall)
- What you'll notice
- In strong sunlight the rear turn signals stop flashing and the front ones flash fast.
- Why it happens
- Strong sun on the rear lamp electronics makes the car think a bulb has failed and shut the rear signals off.
- What to do
- Check your VIN for open recalls. A dealer replaces both rear lamp assemblies for free.
Fuel lines rub through their covers under the hood
- What you'll notice
- Worn or flattened spots on the fuel lines on the right side of the engine bay near the intake, and possibly a fuel smell.
- Why it happens
- Owners report the fuel lines rubbing against nearby parts or each other while the engine runs, which wears through the protective sleeve.
- What to do
- Open the hood and look at the fuel lines near the intake. If they are worn, have a dealer reposition or replace them before they leak.
Ignition coil failure causes misfires
- What you'll notice
- Shaking or stumbling under power and a check engine light with a coil or misfire code.
- Why it happens
- The coils on the passenger-side cylinders sit close to the hot exhaust header, and heat makes them fail sooner, especially on cars that see track use.
- What to do
- Have the codes read and replace the failed coil. Heat shielding can help if the car is driven hard.
Fuel pump clicks off early when filling up
- What you'll notice
- The gas station pump keeps shutting off before the tank is full, or fuel spills out while filling, sometimes with an EVAP check engine code.
- Why it happens
- A problem in the charcoal canister or vapor venting system stops the tank from venting properly during refueling.
- What to do
- Have the EVAP system smoke-tested and the charcoal canister checked.
Spare tire may be underinflated (recall)
- What you'll notice
- The temporary spare is low on air when you need it.
- Why it happens
- Some spares left the factory without being filled to the pressure on the tire label.
- What to do
- Check the spare's pressure yourself, and ask a dealer about the recall check.
Remote start and app features stop working
- What you'll notice
- Toyota app features such as remote start stop working, often about a year after the car was built.
- Why it happens
- The car's built-in cellular module was not activated or was programmed in a way that cut off service.
- What to do
- Ask a Toyota dealer to activate or reprogram the data communication module under the service bulletin.
Oil leak from spark plug tube seals
- What you'll notice
- Oil seeping from the top of the cylinder heads, burning oil smell, or a misfire if oil reaches the plugs.
- Why it happens
- The seals around the spark plug tubes can crack and let oil out.
- What to do
- Have a shop find the leak and replace the cracked seals while under warranty.
Load capacity label shows the wrong weight (recall)
- What you'll notice
- No symptom. The door-jamb label may show the wrong added weight for dealer-installed accessories.
- Why it happens
- On some cars with distributor-installed accessories, the load label had incorrect weight values, which could lead to overloading.
- What to do
- Check your VIN for open recalls. A corrected label is mailed for free.
Blind spot alerts late or missing
- What you'll notice
- The blind spot light comes on late or not at all when a car is beside you.
- Why it happens
- An owner reported intermittent blind spot warnings; the dealer reproduced it but found no fault codes.
- What to do
- Always check over your shoulder. Keep the rear bumper corners clean and have a dealer check the radar sensors.
Repair prices for your Toyota 86 / GR86
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace engine with used or remanufactured unit
- Update engine computer; replace cam sprocket/actuator if needed
- Replace clutch kit with new release bearing
- Replace in-tank fuel pump or high-pressure fuel pump
- Replace ignition coil (one)
- Repair or replace electric power steering column/motor
- Replace EVAP charcoal canister or vent valve
- Remove oil pan, clean pickup and reseal (engine replacement if damaged)
- Install oil pressure gauge/sensor (baffled pan optional)
- Activate or reprogram data communication module
- Reposition and protect fuel lines; replace damaged line
- Replace spark plug tube seals and valve cover gaskets
- Diagnose and recalibrate or replace blind spot radar sensor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace all valve springsNo charge if your vehicle is included
- Inspect and reconnect key interlock wiringNo charge if your vehicle is included
- Inspect and inflate spare tireNo charge if your vehicle is included
- Replace low-pressure fuel pumpNo charge if your vehicle is included
- Replace both rear combination lampsNo charge if your vehicle is included
- Install corrected load capacity labelNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.