Toyota Tundraproblems, repair costs and recalls
Problems reported across 2000–2027. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
29 documented issues across all years, most serious first.
Severe frame rust
- What you'll notice
- Thick flaking scale, holes, or soft spots on the frame rails, and parts bolted to the frame (sway bar, steering rack, fuel tank straps) coming loose.
- Why it happens
- The frame's rust protection did not hold up on salted winter roads. Toyota offered frame replacement on 2000-2003 trucks and later corrosion-proofing campaigns, but many owners report rot on trucks outside those programs.
- What to do
- Have the frame inspected soon, including tapping suspect areas. A badly rotted frame is unsafe to drive or tow with. Ask a Toyota dealer whether any program still applies to your VIN.
Rear crossmember rust can drop the spare tire (recall)
- What you'll notice
- Rattling or clunking from under the rear, a sagging spare tire, or visible rot on the rear crossmember.
- Why it happens
- Road salt can corrode the rear crossmember that holds the spare tire carrier. If it weakens enough, the spare can fall off while driving.
- What to do
- Check your VIN for this recall and have the rear crossmember inspected right away. Do not drive with a loose or sagging spare.
Front ball joint wear and separation
- What you'll notice
- Clunking over bumps, wandering steering, uneven tire wear, or in the worst case a front wheel suddenly collapsing or folding under the truck.
- Why it happens
- The front ball joints on these trucks wear out and owners report them separating, sometimes at low speed while turning. Rust around the suspension mounts makes things worse.
- What to do
- Have the ball joints checked for play now, especially on a high-mileage truck. If you hear clunks from the front end, get it inspected before driving at speed.
Frame rust (frame replacement program)
- What you'll notice
- Heavy scaling, flaking or holes on the frame, often worst in snowy, salted-road states.
- Why it happens
- Some frames from these years were not protected well enough against road salt. Toyota ran a frame replacement program and a corrosion-proofing campaign for certain trucks.
- What to do
- Have the frame inspected promptly. Do not tow with a frame that shows holes or soft spots. Ask a Toyota dealer whether your VIN was part of the frame programs.
Twin-turbo V6 main bearing failure (recalls)
- What you'll notice
- Engine knocking, rough running, loss of power, stalling while driving, or the engine not starting.
- Why it happens
- Machining debris left inside some engines at the factory can stick to the crankshaft main bearings and wear them out. Toyota has issued several recalls to inspect the bearing or replace the engine.
- What to do
- Check your VIN for open recalls now. Toyota's later recall advises not driving affected trucks until the dealer inspects them. If the engine knocks or runs rough, stop and have it towed.
Rear axle shaft nuts can loosen (recall 22V-445)
- What you'll notice
- Clunk, vibration or gear oil at a rear wheel. In the worst case an axle shaft and wheel can come away.
- Why it happens
- Nuts on the rear axle flange may not have been tightened enough and can back off.
- What to do
- Stop driving if you hear new rear axle noise and have the recall done. The repair is free at a dealer. Ask the dealer to check your VIN to see if it was already done.
Fuel tube can rub on a brake line and leak (recall 23V-566)
- What you'll notice
- Fuel smell or wet fuel under the truck.
- Why it happens
- A plastic fuel tube can chafe against a brake line until it wears through.
- What to do
- Stop driving if you smell fuel, because of the fire risk. The repair is free at a dealer. Ask the dealer to check your VIN to see if it was already done.
Truck can creep forward in Neutral (recall 24V-125)
- What you'll notice
- With the shifter in Neutral and your foot off the brake, the truck can move forward on level ground.
- Why it happens
- Parts inside the automatic transmission may not fully release, so some drive still reaches the wheels.
- What to do
- Keep the brake applied in Neutral and get the software update promptly. The repair is free at a dealer. Ask the dealer to check your VIN to see if it was already done.
Low-pressure fuel pump can fail and stall the engine
- What you'll notice
- A rough idle, a check engine light, hard starting, or the engine cutting out while driving and not restarting.
- Why it happens
- The in-tank low pressure fuel pump can stop delivering fuel.
- What to do
- Check the VIN for recall 20V-682 and have the pump replaced. A stall in traffic is dangerous, so do not put this off.
Accessory dual exhaust can rub a brake line
- What you'll notice
- A low brake pedal, a brake warning light, or fluid dripping near a rear wheel on a truck with the add-on dual exhaust.
- Why it happens
- The accessory exhaust was routed close enough to a brake line to wear through it.
- What to do
- Stop driving if the pedal sinks. Check the VIN for recall 05V-123 and have the exhaust and the brake line inspected.
Secondary air pump failure
- What you'll notice
- Check engine light, a whining noise at cold start, and sometimes reduced power or limp mode.
- Why it happens
- The air pump that helps heat the catalytic converters after a cold start can fail. Unlike later trucks, these years were not included in Toyota's extended coverage.
- What to do
- Have the codes read and the pump and valves tested. If the truck goes into limp mode, get it diagnosed before relying on it for towing or highway trips.
Secondary air injection pump or valve failure
- What you'll notice
- Check engine light, a loud noise right after a cold start, and sometimes the truck drops into reduced power mode.
- Why it happens
- The air pumps and their switching valves can take in water and debris, which rusts them inside until they seize or stick. Toyota extended coverage on the pumps and valves for 2007-2010 trucks.
- What to do
- Have the codes read and the pumps and valves tested. Ask a Toyota dealer whether the extended coverage applies to your VIN.
Leaking water pump
- What you'll notice
- Pink crusty residue or drips at the front of the engine, low coolant, weak heat, or the temperature gauge creeping up.
- Why it happens
- The water pump's bearing and seal wear over time and start to leak coolant.
- What to do
- Watch the coolant level and replace a leaking pump before it lets the engine overheat.
Cam tower oil leak
- What you'll notice
- Oil seeping at the back of the cylinder heads, a burning oil smell after driving, and a slowly dropping oil level.
- Why it happens
- The sealant between the cam towers and cylinder heads can break down. Oil can then drip onto the hot exhaust manifold. The proper repair is labor heavy because the engine timing has to be taken apart.
- What to do
- Check the oil level often and have the leak confirmed. Because oil can land on the exhaust, get it repaired rather than ignoring it.
Rear axle bearing howl
- What you'll notice
- A howl or growl from the rear of the truck that gets louder as speed increases.
- Why it happens
- A worn rear axle bearing. Toyota published a bulletin for replacing the bearing to fix the noise.
- What to do
- Have the rear axle bearings checked soon. A failing bearing gets worse and can damage the axle if ignored.
ABS, brake and 4WD warning lights on together
- What you'll notice
- The ABS, brake and four-wheel-drive lights come on at the same time.
- Why it happens
- A fault in the brake actuator assembly can set communication and speed sensor codes. Toyota's bulletin calls for replacing the actuator.
- What to do
- Have the codes read soon. Normal braking usually remains, but ABS and stability help may be off until it is fixed.
Front brake vibration
- What you'll notice
- A shaking or pulsing in the steering wheel or brake pedal when slowing down.
- Why it happens
- Toyota issued a bulletin for front brake vibration on these trucks, usually tied to the front rotors.
- What to do
- Have the front brakes inspected and ask the dealer about the bulletin.
Instrument panel screen can go blank (recall 23V-111)
- What you'll notice
- The digital gauge display goes dark, so speed and warning lights are not shown.
- Why it happens
- A software error in the instrument cluster.
- What to do
- Get the software update soon. The repair is free at a dealer. Ask the dealer to check your VIN to see if it was already done.
Rearview camera image may not display (recalls)
- What you'll notice
- Blank, frozen or wrong camera picture when backing up.
- Why it happens
- Several software faults in the parking assist system can keep the rear camera image off the screen.
- What to do
- Check behind you by other means and get the update soon. The repair is free at a dealer. Ask the dealer to check your VIN to see if it was already done.
Electric parking brake may not engage (recall 22V-661)
- What you'll notice
- Parking brake warning message, and the parking brake may not set.
- Why it happens
- The brake control computer can wrongly detect an electrical fault and refuse to apply the parking brake.
- What to do
- Make sure the truck is in Park and get the update soon. The repair is free at a dealer. Ask the dealer to check your VIN to see if it was already done.
Power steering gear can leak
- What you'll notice
- Red or brown fluid dripping under the front of the truck, a low reservoir, a whine when turning, or heavier steering.
- Why it happens
- The hydraulic steering gear assembly can leak oil from its seals.
- What to do
- Have the gear inspected and replaced. Check the VIN for recalls 21V-920 and 21E-103, and do not let the reservoir run dry.
High and low beams can power together and overheat the wiring
- What you'll notice
- Headlights flicker or go out, or there is a hot plastic smell from a headlight.
- Why it happens
- Both beams can be powered at once, which overloads a connector in the headlight harness.
- What to do
- Have the harness modified under recall 21V-688 and any melted parts replaced before you lose a headlight at night.
Front turn signals may not flash brightly enough
- What you'll notice
- The front blinkers look dim and are hard for other drivers to see in daylight.
- Why it happens
- The wiring to the front turn signals does not give them enough power.
- What to do
- Have the harness modified under recall 20V-410, and use hand signals or extra care at busy junctions until then.
Cracked exhaust manifold or leaking gasket
- What you'll notice
- A ticking or tapping sound that is loudest on a cold start and may fade as the engine warms up.
- Why it happens
- Repeated heating and cooling can crack the exhaust manifold or wear out its gasket. Heavy towing speeds this up.
- What to do
- Have the manifolds inspected. Repair it before the leak grows or starts to affect the oxygen sensors.
Rear driveshaft clunk
- What you'll notice
- A clunk or thunk from under the truck when pulling away from a stop or shifting, sometimes with a slight vibration.
- Why it happens
- Wear and binding in the rear driveshaft slip joint on four-wheel-drive trucks. Toyota issued service bulletins for the noise.
- What to do
- Ask a Toyota dealer to check the driveshaft against the bulletin. It is usually a noise issue, but have worn joints replaced.
Valve timing codes from a stiff VVT spring
- What you'll notice
- Check engine light with cam timing codes, sometimes with slightly rough running.
- Why it happens
- Some engines were built with a variable valve timing spring that is too stiff, so the system can stick in the wrong position.
- What to do
- Have the codes read and ask a Toyota dealer about the bulletin for this fix.
Charcoal canister contamination
- What you'll notice
- Check engine light for the evaporative emissions system.
- Why it happens
- Water or dirt can get in through the fresh air inlet of the fuel vapor canister. Toyota revised the filler pipe to help prevent it.
- What to do
- Have the codes read and ask a Toyota dealer about the bulletin for this repair.
Reverse lights can fail from moisture (recall 25V-322)
- What you'll notice
- One or both white reverse lights stop working.
- Why it happens
- Moisture can get into the reverse light assemblies and corrode them.
- What to do
- Have them replaced when you can. The repair is free at a dealer. Ask the dealer to check your VIN to see if it was already done.
Load capacity label may show the wrong weight
- What you'll notice
- Nothing is wrong with the truck, but the door jamb sticker overstates how much weight you can add.
- Why it happens
- The label did not account for accessories fitted before delivery, so the stated carrying capacity is too high.
- What to do
- Get the corrected label free from a dealer and go by the new figure when loading the bed or hitching a trailer.
Repair prices for your Toyota Tundra
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace frame and transfer body, suspension and lines
- Replace rear frame crossmember and nearby brake lines
- Replace front lower ball joints (both sides) and align
- Replace secondary air pump and check valve
- Replace secondary air pump and air switching valve
- Replace water pump and refill coolant
- Reseal camshaft housings (cam towers)
- Replace exhaust manifold, gasket and studs
- Lubricate driveshaft slip yoke and replace worn U-joints
- Replace rear axle bearings and seals (both sides)
- Replace front brake rotors and pads
- Replace EVAP charcoal canister
- Replace engine assembly
- Tighten or replace rear axle flange nuts
- Replace fuel tube and add clamp
- Update transmission software
- Update instrument cluster software
- Update parking assist software
- Replace reverse light assemblies
- Update brake control software
- Replace hydraulic power steering gear
- Modify headlight harness and replace damaged parts
- Replace low pressure fuel pump
- Modify front turn signal wiring harness
- Replace accessory exhaust and brake line
- Install corrected load capacity label
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.