Your 2012 Toyota Venzaproblems, repair costs and recalls
What we've documented about the 2012 Toyota Venza: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2012 Toyota Venza
17 documented issues apply to 2012, most serious first.
Panoramic glass roof shatters
- What you'll notice
- A loud bang while driving and broken glass falling from the roof, often with no obvious impact.
- Why it happens
- Owners have reported the large glass roof panel shattering on its own. Thin tempered glass with built-in stress can break suddenly.
- What to do
- Pull over safely and cover the opening. Report it to NHTSA and to Toyota, and check whether your insurance glass coverage applies.
A/C drain leak can wet the airbag computer (recall)
- What you'll notice
- The airbag warning light comes on, there is water on the floor, or in rare cases an airbag deploys unexpectedly.
- Why it happens
- A blocked A/C drain hose can let condensation drip onto the airbag control module, which can short circuit and disable the airbags or set them off.
- What to do
- Have a Toyota dealer confirm recall 13V-442 is complete. The fix is free. Get any wet carpet or airbag light checked right away.
Driver door wiring can disable side airbags (recall)
- What you'll notice
- The airbag warning light comes on, often after the driver door has been opened and closed many times.
- Why it happens
- The airbag wiring that runs into the driver door can wear through from repeated door use. That can disable the driver-side side and curtain airbags.
- What to do
- Have a Toyota dealer check for recall 21V-257. The wiring repair is free and important for side-impact protection.
Water pump leak on the V6
- What you'll notice
- Coolant level keeps dropping, a pink or white crusty residue on the passenger side of the engine, a sweet smell, or a grinding noise from the pump area. Leaking coolant can wet the drive belt and make it slip.
- Why it happens
- The water pump seal wears and starts to seep from the weep hole or gasket, usually somewhere around 80,000 to 130,000 miles. On the V6 the pump sits behind the timing cover area, so the repair is labor-heavy.
- What to do
- Check the coolant tank level often and do not let the engine overheat. Have the pump replaced, ideally with the thermostat and drive belt at the same time, and use Toyota pink long-life coolant.
Water pump leak on the 4-cylinder
- What you'll notice
- Low coolant, pinkish residue around the water pump on the passenger side of the engine, and sometimes a grinding or whirring noise.
- Why it happens
- The water pump seal and bearing wear out with age and mileage. The 4-cylinder pump is easier to reach than the V6 pump, so it costs less to fix.
- What to do
- Keep the coolant topped up with Toyota long-life coolant and replace the pump before it fails completely or the engine overheats.
Oil consumption at higher mileage
- What you'll notice
- The oil level drops between changes and you need to add oil, sometimes with blue smoke at startup or a low oil warning.
- Why it happens
- As these engines age, worn piston rings and valve seals let more oil burn in the cylinders. Owners report it on both the 4-cylinder and the V6.
- What to do
- Check the oil every few fill-ups and top it up. If you are adding more than a quart every 1,200 miles or so, have a shop or dealer run an oil consumption test.
Hesitation or jerky shifts when accelerating
- What you'll notice
- The car hesitates, jerks or surges when you press the gas, or the engine speed rises and falls unevenly while the transmission shifts.
- Why it happens
- Hesitant shifting on the 6-speed automatic is a known complaint on these Venzas. Old or low fluid, software and internal wear can all play a part.
- What to do
- Have the transmission scanned for codes and the fluid checked. Ask a dealer whether a software update applies before agreeing to major transmission work.
Passenger airbag sensor not recalibrated after accessories (recall)
- What you'll notice
- The passenger airbag status light may show the wrong state for who is sitting in the seat.
- Why it happens
- On cars that had dealer accessories such as seat covers fitted, the passenger seat occupant sensor may not have been recalibrated, so the airbag may not deploy correctly.
- What to do
- Ask a Toyota dealer to check recall 13V-014 with your VIN. The inspection and recalibration are free.
Brief rattle on cold start
- What you'll notice
- A loud knocking or rattling noise for about a second right after starting the engine, mostly after the car has sat overnight.
- Why it happens
- The variable valve timing gear on the camshaft can let the camshaft move briefly before oil pressure builds. Toyota issued a service bulletin with an updated gear assembly.
- What to do
- The noise is not immediately harmful, but have a Toyota dealer confirm it and replace the cam timing gear with the updated part.
Humming wheel bearing
- What you'll notice
- A humming or growling noise that gets louder with speed and changes when you turn or change lanes.
- Why it happens
- A front or rear wheel bearing has worn out. The noise usually starts quietly and grows over time.
- What to do
- Have the bearing checked soon. A badly worn bearing can get loose and affect handling, so do not wait for it to get loud.
Worn front struts
- What you'll notice
- A bouncy or floaty ride, the nose diving under braking, clunks over bumps, or oil on the strut bodies.
- Why it happens
- The front struts wear out at higher mileage, and the large wheels on the Venza make the ride firm to begin with.
- What to do
- Have the struts inspected. They are normally replaced in pairs, followed by a wheel alignment.
Check engine light from a failed air-fuel sensor
- What you'll notice
- The check engine light comes on, sometimes with slightly worse fuel economy. Codes such as P0138, P0161 or P0057 are common.
- Why it happens
- The air-fuel ratio sensor or oxygen sensor in the exhaust, or its heater circuit, wears out with age.
- What to do
- Have the codes read to see which sensor failed. It is not urgent, but fix it before an emissions test and so fuel economy does not suffer.
ABS light from a wheel speed sensor
- What you'll notice
- The ABS and traction control lights come on and stay on. The normal brakes still work.
- Why it happens
- One of the wheel speed sensors or its wiring has failed. The anti-lock and stability systems switch off when they lose a sensor signal.
- What to do
- Have the ABS codes read to find which wheel is affected. The sensor itself is usually inexpensive.
Tire pressure light from corroded sensors
- What you'll notice
- The tire pressure light stays on or flashes even when the tires are properly inflated.
- Why it happens
- The tire pressure sensors inside the wheels use metal valve stems that corrode, and their internal batteries eventually die.
- What to do
- Check all tire pressures first. If they are correct, have the sensors tested and replace the faulty ones, ideally when tires are changed.
No-start from corroded battery terminals
- What you'll notice
- Clicking or no crank when you turn the key, flickering lights, or odd electrical behavior that comes and goes.
- Why it happens
- Corrosion on the battery terminals or a weak battery stops enough current from reaching the starter.
- What to do
- Clean and tighten the battery terminals and have the battery tested. Replace it if it fails the test.
Factory alarm goes off by itself
- What you'll notice
- The car alarm sounds randomly, often at night, with no one near the car.
- Why it happens
- The hood latch switch can falsely report that the hood is open. Toyota released a revised hood latch assembly.
- What to do
- Have the hood latch switch checked and replaced with the updated latch if it is the cause.
Check engine light from the gas cap or EVAP system
- What you'll notice
- The check engine light comes on, often with an evaporative emissions code such as P0441 or P0455, with no change in how the car drives.
- Why it happens
- A worn or loose gas cap seal lets fuel vapor escape, which the evaporative emissions system reports as a leak.
- What to do
- Tighten the cap until it clicks. If the light returns, replace the cap with a Toyota one and have the EVAP system smoke-tested if the code comes back.
Repair prices for your 2012 Toyota Venza
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace water pump, thermostat and drive belt (V6)
- Replace water pump (4-cylinder)
- Replace camshaft timing (VVT) gear with updated part
- Oil consumption test, then piston ring and valve seal repair if needed
- Transmission diagnosis, software check and fluid exchange
- Replace panoramic roof glass
- Replace one wheel bearing/hub assembly
- Replace both front struts and align
- Replace air-fuel ratio or oxygen sensor
- Replace one ABS wheel speed sensor
- Replace tire pressure sensor(s) and relearn
- Clean or replace battery terminals and test battery
- Replace hood latch assembly with revised part
- Replace gas cap
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall 13V-442: A/C drain and airbag module protectionNo charge if your vehicle is included
- Recall 21V-257: repair driver door airbag wiringNo charge if your vehicle is included
- Recall 13V-014: recalibrate passenger occupant sensorNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…