Your 2012 Volkswagen CCproblems, repair costs and recalls
What we've documented about the 2012 Volkswagen CC: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2012 Volkswagen CC
21 documented issues apply to 2012, most serious first.
Timing chain tensioner failure
- What you'll notice
- A loud rattle from the engine for a few seconds after a cold start, a check engine light, rough running, or an engine that cranks but will not start. If the chain jumps, the engine can be badly damaged.
- Why it happens
- The early 2.0T engine used a timing chain tensioner that can lose pressure and let the chain go slack. A slack chain can skip a tooth, and because this is an interference engine the valves can then hit the pistons. VW issued service bulletins and a 10-year/100,000-mile warranty extension (VWP-18-07) for these years.
- What to do
- Do not ignore a cold-start rattle. Have a shop check the chain stretch and tensioner soon; replacing the tensioner before it fails costs far less than a damaged engine. The VW extension has likely ended on most cars, but ask a dealer with your VIN.
Water pump leaks coolant
- What you'll notice
- Coolant drips under the front of the engine, a sweet smell, a low-coolant warning, or the temperature gauge climbing.
- Why it happens
- The plastic water pump and thermostat housing on this engine can warp and crack. VW issued service bulletins and a limited warranty extension (VWP-19-08) for the water pump on these engines.
- What to do
- Check the coolant level and look for pink or purple crust near the pump. Stop driving if the engine overheats. Replace the pump and housing with the updated part, and ask a VW dealer whether any extended coverage still applies.
High-pressure fuel pump failure
- What you'll notice
- Sudden loss of power, a check engine light, hard starting after the car sits, or a low fuel pressure code such as P0087.
- Why it happens
- The engine-driven high-pressure fuel pump and its cam follower can wear, and the pump can stop making enough pressure. VW issued several bulletins on diagnosing the pump and on no-starts after long parking.
- What to do
- Have fuel pressure checked with a scan tool. If the pump is weak, replace it and inspect the cam follower it rides on, because a worn follower can damage the camshaft.
Fuel pump control module can fail and stall the engine (recall)
- What you'll notice
- The engine stalls or bogs down, often at low speed or when stopping, and may not restart.
- Why it happens
- Power to the fuel pump control module can be interrupted, which stops the fuel pump. VW recalled these cars under NHTSA campaign 17V-509.
- What to do
- Check your VIN for open recalls. The dealer replaces the fuel pump control module free of charge.
Free at a VW dealer under the recall.
Takata driver airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. The risk is only in a crash that deploys the driver airbag.
- Why it happens
- The Takata driver airbag inflator can build up too much pressure and burst, throwing metal pieces at the driver. Covered by NHTSA campaigns 16V-078 and 18V-148.
- What to do
- Check your VIN for open recalls and get the inflator replaced as soon as possible. The repair is free.
Free at a VW dealer under the recall.
Clock spring damage can disable the driver airbag (recall)
- What you'll notice
- The airbag warning light comes on, and the horn or steering wheel buttons may stop working.
- Why it happens
- Debris can tear the clock spring cable inside the steering column, cutting power to the driver airbag. VW recalled these cars under NHTSA campaign 15V-483.
- What to do
- Check your VIN for open recalls. The dealer installs a protective cover or a new clock spring for free.
Free at a VW dealer under the recall.
Intake manifold flap failure
- What you'll notice
- Check engine light (often code P2015), rough idle, hesitation or reduced power. Some owners report the light coming back after a repair.
- Why it happens
- The intake manifold has internal flaps moved by a small arm and motor. The arm, flap shafts or position sensor wear out or break, and the engine computer flags a fault. The usual fix is a new manifold.
- What to do
- Have the codes read. A P2015 code almost always means the intake manifold needs replacing; it is not an emergency, but fuel economy and smoothness suffer until it is fixed.
Ignition coil failure and misfires
- What you'll notice
- Shaking at idle, stumbling or loss of power when accelerating, and a flashing check engine light. Misfire codes like P0302 or P0304 are common.
- Why it happens
- The pencil-type ignition coils on these engines wear out, and one bad coil often follows another. Worn spark plugs speed up coil failure.
- What to do
- A flashing check engine light means stop driving hard, since unburned fuel can damage the catalytic converter. Replace the failed coil, and consider replacing all coils and plugs together if they are original.
Carbon buildup on intake valves
- What you'll notice
- Rough or uneven idle, hesitation at light throttle, misfires when cold, and slowly worsening fuel economy, usually after 50,000 miles or more.
- Why it happens
- Both CC engines use direct injection, so fuel never washes over the intake valves. Oil vapor from the crankcase bakes onto them and forms carbon deposits that disturb airflow.
- What to do
- Have a shop confirm with a scope or misfire data. The fix is a walnut-blast or manual cleaning of the intake valves; keeping up with oil changes and fixing a bad PCV valve slows the buildup.
PCV valve failure and oil leaks
- What you'll notice
- A whistling or howling noise from the engine, rough idle, lean codes, oil leaks, or a rear main seal that starts leaking.
- Why it happens
- The crankcase breather (PCV) valve on top of the engine has a diaphragm that tears. Crankcase pressure then builds up and can push oil past seals, including the rear main seal.
- What to do
- If you hear a whistle at idle or see new oil leaks, have the PCV valve checked first. It is a cheap part, and replacing it early protects the seals.
Rear main seal oil leak
- What you'll notice
- Oil drips where the engine meets the transmission, oil spots under the car, and the oil level dropping between changes.
- Why it happens
- The rear crankshaft seal hardens and leaks, and a failed PCV valve can blow it out. Replacing it means removing the transmission, so the labor is high.
- What to do
- Keep the oil topped up and have the source confirmed. Fix the PCV valve at the same time. Manual-transmission cars often do the clutch while the transmission is out.
Fuel injector failure
- What you'll notice
- Misfire on one cylinder, rough running, fuel smell, or an injector stuck open that floods the cylinder and makes starting hard.
- Why it happens
- Direct injectors on this engine can stick or leak, and their seals can be pinched during service.
- What to do
- Have a shop run injector tests. Replace failed injectors with new seals; a stuck-open injector should be fixed right away because it can wash oil off the cylinder wall.
DSG transmission shudder or erratic shifting
- What you'll notice
- Shudder or jerking when pulling away, harsh or delayed shifts at low speed, a flashing gear display, or limp mode.
- Why it happens
- The DSG dual-clutch transmission needs fluid changes about every 40,000 miles. Worn clutches or a failing mechatronic control unit cause shudder and shift faults.
- What to do
- Have the DSG fluid and filter changed if it is due, then have the clutch and mechatronic adapted with a scan tool. If faults continue, a clutch pack or mechatronic unit may be needed.
Turbo diverter valve or wastegate rattle
- What you'll notice
- Loss of boost, a whistle or fluttering sound when lifting off the gas, or a rattle from the turbo above about 2,500 rpm.
- Why it happens
- The turbo diverter (blow-off) valve diaphragm can tear, and the wastegate linkage can wear and rattle. VW issued a bulletin with a clip for the wastegate rod.
- What to do
- A torn diverter valve is a cheap part. For a wastegate rattle, ask a dealer about the service bulletin fix before replacing the turbo.
Brake vacuum pump oil leak
- What you'll notice
- Oil seeping from the back of the engine near the cylinder head, burning oil smell, and in rare cases a firm brake pedal.
- Why it happens
- The engine-driven vacuum pump that helps the brake booster has seals that leak oil as they age.
- What to do
- Have the leak traced. Resealing or replacing the vacuum pump fixes it; if the brake pedal feels hard, get it checked right away.
Port-installed wheels may lack proper tire pressure sensors (recall)
- What you'll notice
- The tire pressure warning light may stay on or may not warn you about a low tire.
- Why it happens
- Some accessory wheels and tires fitted at the port did not have the correct tire pressure sensors. VW recalled these cars under NHTSA campaign 11V-312.
- What to do
- Check your VIN for open recalls. VW replaces the sensors free of charge.
Free at a VW dealer under the recall.
Cupped or uneven front tire wear
- What you'll notice
- A humming or droning noise that gets louder with speed, vibration, and front tires wearing in scalloped patches or on the inside edge.
- Why it happens
- Owners and RepairPal report tire cupping on the CC. Worn struts, alignment that is out of spec and skipped tire rotations make it worse.
- What to do
- Rotate the tires regularly and have the alignment and struts checked. Replace badly cupped tires, since the noise will not go away on its own.
Worn struts and strut mounts
- What you'll notice
- Clunking over bumps, a bouncy or floaty ride, or a creak when turning the wheel at low speed.
- Why it happens
- Struts and their upper mounts and bearings wear out with mileage and are among the more commonly replaced parts on the CC.
- What to do
- Have the suspension inspected. Replace struts in pairs along with their mounts, and get an alignment afterward.
Headlight and tail light bulb failures
- What you'll notice
- A bulb-out warning on the dash, or a headlight, brake light or turn signal that does not light.
- Why it happens
- Headlight bulbs are one of the most-replaced parts on the CC in owner surveys. Cars with xenon lights can also have a failing igniter or ballast.
- What to do
- Replace the bulb in pairs. If a xenon headlight flickers or stays out with a new bulb, have the ballast checked.
Radio and navigation unit freezes or fails
- What you'll notice
- The touchscreen freezes, reboots, goes blank or loses navigation, radio or Bluetooth.
- Why it happens
- The factory radio and navigation head units can fail, sometimes after a software update.
- What to do
- Try a full reset by turning the car off and opening the driver door for a few minutes. If it keeps failing, a software update or a replacement unit is needed.
Exterior trim and roof molding coming loose
- What you'll notice
- Chrome or black trim strips along the roof or doors peel, lift, flap at speed or come off.
- Why it happens
- The adhesive on the roof and side moldings weakens with heat and age; trim is a frequently reported repair in owner surveys.
- What to do
- Have loose trim reattached or replaced before it blows off on the highway.
Repair prices for your 2012 Volkswagen CC
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace timing chain, tensioner and guides
- Replace intake manifold
- Replace water pump and thermostat housing
- Replace ignition coil (one) and spark plugs
- Intake valve carbon cleaning (walnut blasting)
- Replace high-pressure fuel pump and cam follower
- Replace PCV (crankcase breather) valve
- Replace rear main seal (transmission removal)
- Replace fuel injector with new seals
- Replace diverter valve or install wastegate clip
- Reseal or replace brake vacuum pump
- DSG fluid and filter change
- Four-wheel alignment and pair of tires
- Replace front struts and mounts (pair)
- Replace headlight bulbs (pair)
- Replace radio/navigation head unit
- Replace roof or side molding
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…