Home › Warning lights › Cruise control indicator
Green: system on

Cruise control indicator

Also called: Speedometer with arrow

How urgent? Information only

What it means

Cruise control is on or set. Amber or flashing can mean the system is unavailable.

A green or white symbol in the cluster, most often a speedometer dial with an arrow or a needle, and on some makes just the word CRUISE. Many cars show one color when the system is awake and a second color, or the set speed as a number, once a speed is locked in. Amber, or the symbol with a line through it, means the system is not available.

Can I keep driving?

Yes. It's an information light.

If it's flashing or blinking: A cruise symbol that flashes, or turns amber, is the car saying the system has dropped out or cannot be used right now. Adaptive cruise does this when the radar behind the grille is covered in snow, spray or mud. Plain cruise does it when the car sees a fault in the brake switch or in the road speed signal. Either way it is a report, not normal operation.

What to do now

  1. If cruise won't work, check the brake light bulbs; a bad brake switch disables cruise.

Common causes

  • Cruise control engaged
  • Brake light switch fault (if cruise won't set)

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Check your brake lights

Have someone stand behind the parked car while you press the brake pedal, or back up close to a garage door at night and watch the red glow in the mirror. Both brake lights should come on and go off with the pedal. The same small switch at the top of the brake pedal that lights those lamps also tells cruise to let go, and a bad one stops cruise setting at all.

5 minutes · A helper, or a wall to reflect off
2
Wipe the radar area in the grille

On a car with adaptive cruise, walk to the front while it is parked and find the smooth plastic panel or the badge in the middle of the grille or the lower bumper. Wipe mud, slush, road salt and bugs off it with a damp cloth. Do not pry the cover off, and do not fit a plate frame or an accessory in front of it.

5 minutes · Damp cloth
3
Check the fuse for the cruise or stop lamp circuit

Open the cabin fuse box, usually behind a cover at the end of the dash or below the glovebox, and read the map printed on the lid. With the car switched off, pull the fuse marked cruise, stop lamp or brake switch and look at the metal strip inside. A broken strip means it has blown. Replace it only with the same number.

15 minutes · Owner's manual and a fuse puller
4
Try the buttons and read the rules for your car

Cruise will not set below a certain speed, in a low gear, with a door open, or while traction control is working. Press the on button and watch for the symbol, then try to set a speed on a clear, dry road at normal highway pace. Look in the owner's manual index under cruise control for the limits your particular car has.

10 minutes · Owner's manual

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't use cruise control on wet, icy or snow covered roads; it can hold power on right through a skid.
  • Don't treat adaptive cruise as self driving; keep your hands on the wheel and your eyes on the road.
  • Don't tap the brakes just to test whether cruise cancels while a car is close behind you.
  • Don't ignore a cruise fault when your brake lights are out too, because one switch feeds both.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Cruise control is simply engagedPrice not verified

How you can tell The symbol appeared right after you pressed the cruise button, and the car is holding a steady speed on its own without your foot on the pedal. Nothing is wrong; it is doing its job.

The repair Nothing. Press cancel or tap the brake and the symbol goes out.

Failed brake light switchPrice not verified

How you can tell Cruise refuses to set, or drops out the moment you set it. Often the brake lights stay off, or stay on all the time, and the stored code names the brake switch circuit. On many cars the shifter also refuses to come out of park.

The repair A small switch clipped to the bracket at the top of the brake pedal is unplugged and replaced, then adjusted.

Snow, slush or mud over the front radarPrice not verified

How you can tell Adaptive cruise goes unavailable during a storm or after a salty winter drive, and the dash shows a message about a blocked front sensor. It comes back by itself once the grille area is clean and dry.

The repair Wiping the radar cover clean. No parts needed.

Front radar sensor failed or knocked out of aimPrice not verified

How you can tell Adaptive cruise stays unavailable on a clean, dry day, usually after a front end bump or a curb strike, and the scan tool shows the radar module not answering or reporting itself out of alignment.

The repair The radar unit behind the grille is re-aimed or replaced, then calibrated to the car.

Faulty cruise switch or steering wheel wiringPrice not verified

How you can tell Nothing happens at all when you press the buttons on the wheel, or they work only now and then. If the horn or the wheel audio buttons act up at the same time, the coiled wiring behind the wheel is the suspect rather than the switch.

The repair The switch pad on the steering wheel, or the coiled connector behind it, is replaced.

Wheel speed sensor or throttle faultPrice not verified

How you can tell Cruise will not set and the speedometer flickers, or the ABS and traction lights are on alongside it. Cruise needs a road speed signal it can trust, so it shuts itself off when the car cannot agree on how fast it is going.

The repair The faulty wheel speed sensor, or the throttle or pedal sensor behind it, is replaced.

What a shop will do

A shop reads the codes first, then checks the shared parts that fail most: brake lights on and off with the pedal, the brake switch adjustment at the top of the pedal, and whether road speed stays steady on live data. On a car with adaptive cruise they also check the radar behind the grille for codes, damage and alignment, and see whether the windshield camera is tied in. Half an hour to an hour is typical, longer when they have to road test to catch an intermittent fault.

How to reset this light

Cruise control has no reset procedure. The green symbol simply follows the system, so it lights when cruise is on and goes out when you cancel it or switch the car off. If the symbol is amber or the car says cruise is unavailable, that is a fault report, and clearing codes or disconnecting the battery will not repair it; the car checks itself again and the message returns. A blocked radar is the one exception, and that clears itself once the sensor is clean.

Some makes remember that cruise was on when you last parked, while others start every drive with the system switched off.

Trouble codes often stored with this light

Common questions

What does the cruise control indicator mean?

Cruise control is on or set. Amber or flashing can mean the system is unavailable.

Can I drive with the cruise control indicator on?

Yes. It's an information light.

Why won't my cruise control set?

Start with the brake lights. The switch on the brake pedal cancels cruise, and when it fails the car believes your foot is on the brake all the time. Cars also refuse to set below a certain speed, in a low gear, or while traction control is working. If the brake lights are fine and the road is clear, it needs a scan.

Is it safe to drive with the cruise light on?

Yes. A green or white cruise symbol is information, not a warning, and it says nothing about the engine, the brakes or the steering. If it is amber or flashing, the car is telling you cruise is unavailable; carry on driving and have it looked at when it suits you.

Will a cruise control fault fail inspection?

The cruise system itself is not part of a state safety or emissions inspection. The brake light switch behind many cruise faults is another matter, because brake lights that do not work will fail an inspection and are a ticket on their own. Fix the switch and both problems go away together.

Does adaptive cruise control drive the car for me?

No. It holds a set gap to the car in front and slows down and speeds up to keep it, but you steer, you watch the road, and you are responsible. It can miss a stopped vehicle, a motorcycle between lanes or a sharp cut in, so keep your hands on the wheel.

Can I use cruise control in the rain?

Better not. Holding a steady speed on a wet or icy road can keep power going to the wheels through a skid, which is exactly when you want a human foot on the pedal instead. Save cruise for dry roads with light traffic.

Sources: YourMechanic · AAA

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.